Graco 26A335 User manual

3A5022A
EN
GENUINE GRACO PARTS AND ACCESSORIES
Stand Extension Kit
For ProMix®PD2K
For installing a stand extension to a ProMix®PD2K electronic positive displacement
proportioner.
Part No. 26A335
PD2K Stand Extension Kit
Ref. Description Qty.
1 LEG, stand extension, painted 2
2 PLUG, tube 4
3 SCREW, cap, hex head 4
4 WASHER 8
5 NUT, lock 4
Important Safety Instructions
Read all warnings and instructions in this
manual and in your PD2K Installation and
Operation manuals. Save all instructions.
WARNING
TIPPING HAZARD
The proportioner is heavy and may be awkward to
handle. To avoid injury and possible damage to the
proportioner, use the appropriate equipment (hoist,
lift, or crane) to elevate the proportioner.
FAILURE TO FOLLOW THIS WARNING CAN
RESULT IN SERIOUS INJURY.

23A5022A
Remove Existing Stand
1. Elevate the proportioner using the appropriate
equipment (hoist, lift, or crane).
2. Loosen and remove the four screws, as shown
in FIG. 1.
Install Stand Extension Kit
1. With the proportioner still elevated, slide each stand
extension leg (1) into the proportioner frame (A), as
shown in FIG. 2.
2. Align the holes in each leg (1) and the frame (A) to
the desired height, and insert the four screws (3)
through the aligned holes.
3. Place each washer (4) and nut (5) on each
screw (3), and tighten.
4. Press each of the four plugs (2) into the open ends
of the legs (1).
5. Lower the proportioner into a stable, upright position
using the appropriate equipment.
FIG. 1 Remove existing stand
Remove
Remove
FIG. 2 Install stand extension kit
1
2
3
4
A
2
2
3
4
5
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
Original instructions. This manual contains English. MM 3A5022
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA
Copyright 2017, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.
www.graco.com
Revision A, January 2017