Graco Swift Fold User manual

PD326940F 11/15

2-A Parts list
1 WARNING
2 Features
3-A To Open Highchair
3-B Recline Seat
3-C Adjusting Height
3 Assembly
4-A To Secure Child
4-B Attaching Tray
4-C Tray Insert
4-D To Fold for Storage
4-E Head support and Harness covers
4 Use
5-A Care and Maintenance
5 Cleaning

Prevent serious injury or death: Failure to follow these
warnings and the assembly instructions could result in serious
injury or death.
•PLEASE SAVE OWNER’S
MANUAL FOR FUTURE USE.
•ADULT ASSEMBLY REQUIRED.
•NEVER LEAVE CHILD
UNATTENDED. Always keep
your child in view.
•PREVENT SERIOUS INJURY OR
DEATH FROM FALLS OR
SLIDING OUT. Always use seat
belt. Secure your child at all
times with the restraint system
provided, in either the reclining
or upright position. The tray is
not designed to hold your child
in the highchair. It is
recommended that the highchair
be used in the upright position
only by children capable of
sitting upright unassisted.
•DO NOT FORCE TRAY against
child. Use only the three
adjustment positions. Be sure
both adjustment fingers are
engaged in armrest slots.
•STRANGULATION HAZARD: Do
not place highchair in any
location where there are cords,
such as window blind cords,
drapes, phone cords, etc.
•THIS HIGHCHAIR IS DESIGNED
TO BE USED BY A CHILD UP TO
3 YEARS OF AGE. Maximum
weight 40 pounds (18.1 kg).
•FOLLOW ASSEMBLY
INSTRUCTIONS CAREFULLY. If
you experience any difficulties,
please contact the Customer
Service Department.
•DISCONTINUE USING YOUR
HIGHCHAIR should it become
damaged or broken.

2-A Parts list
This model may not include some features shown below. Check that
you have all the parts for this model BEFORE assembling your product.
If any parts are missing, call Customer Service.
No tools required.
ALL MODELS
FEATURES ON CERTAIN MODELS

3-A To Open Highchair
1. Push release button on the side of
the frame and pull legs all the way
toward you. DO NOT apply weight
to the frame.
SNAP!

2. Grab the handle behind the seat
and lift seat upwards.
3. Rotate handle down to raise the
tray arm. Check to make sure
it is locked in place by pressing
down on both arm rests.
SNAP!

3-B Recline Seat
3 recline positions

Pull up on seat to raise the seat.
Squeeze seat buttons on both
sides of the frame to lower seat.
Lowest/storage position is for
folding only, DO NOT put child in
seat while using lowest/storage
position.
Seat height should not be
adjusted with the child in the seat.
3-C Adjusting Height

4-A To Secure Child
WARNING Falling Hazard: Always use the seat belt.
1. To open, press button on buckle
to release the waist straps.
2. To close, slide shoulder strap
connectors to waist straps and
insert into buckle.
5 Point Harness

3. Use slide adjuster at shoulder and
waist for tighter adjustment.
1. To convert to 3-pt harness.
3 Point Harness

13
2. Use slide adjuster at waist for
further adjustment.
Harness Height Adjustment
1. To access the seat back, undo the
2 rear snaps.

4. The harness straps must go into
the slot that is even with or slightly
above the shoulders. Avoid twisting
straps. PULL both harness straps
to make sure D rings are secured
through seat back.
3. When changing harness strap slots,
MAKE SURE harness straps are
going through same slots in seat
pad and seat back.
2. Locate the harness D rings under
fabric and rotate D rings to push
through seat back and seat pad
slots.

4-B Attaching Tray
1. Pull locking clamps located
underneath the tray outward and
attach tray to seat. MAKE SURE
the locking clamps fit into the
grooves and does not move.
2. Squeeze adjustment button on
front of tray to adjust tray to fit
child.

1. To remove, lift tray up as
shown.
4-C Tray Insert
Dishwasher safe.

4-D To Fold for Storage
1. With your thumb, slide and hold
the release switch and squeeze
the One Hand Fold handle button
to rotate the tray downwards.

3. Pull handle rearward to close legs
until the frame storage button
clicks.
SNAP!
2. Continuously lower seat to
the bottom of the frame, while
holding the handle, until hearing a
click sound.

WARNING
To prevent injury from falling, DO NOT lean folded unit against wall.
To prevent child injury when folding the seat, keep child away from the
high chair during the fold process.

4-E Head support and Harness covers
(On certain models)
Never use this head support or
the harness covers on any other
product.
Slide harness covers onto shoulder
straps.

5-A Care and Maintenance
Removing Seat Pad
Certain models only, CHECK care tag on seat pad.
1. Remove harness covers, head
support, and tray.

2. Undo the 2 rear snaps.
4. Remove harness and waist straps
from highchair.
3. Locate the harness D rings under
fabric and rotate D rings to push
through seat back and seat pad
slots.