Graham Field Lumex Sure-Safe 2032A Parts list manual

2032A-INS-LAB-RevA08 1
2032A: Sure-SAfe®BAthtuB rAil
ASSemBly & OPerAtiON iNStruCtiONS
PleASe SAVe theSe iNStruCtiONS fOr future uSe
Note: The most current version of these instructions can be found online at www.grahamfield.com
WARNING: Important! Read and understand these instructions before installing or using
the 2032A Sure-Safe Bathtub Rail. If you do not understand any part of these warnings,
cautions or instructions, contact a healthcare professional for direction in the use of this
product. If the 2032A Sure-Safe Bathtub Rail is not properly assembled and adjusted,
personal injury and damage to the Sure-Safe Bathtub Rail could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO
NOT use substitute parts. Use only Lumex replacement parts. Non-Lumex replacement
parts could cause personal injury and damage to the Sure-Safe Bathtub Rail.
WARNING: This product has a weight limit of 250 lb.
WARNING:ThisproductisNOTrecommendedforuseonberglassorplasticbathtubs—
do NOT over-tighten. GF Health Products, Inc. assumes no responsibility for any damage or
injury caused by improper assembly or use of this product.
InstallatIon
1. Ensure that the tub surface where the Bathtub Rail
will be installed is smooth, clean, and dry before in-
stalling the Bathtub Rail. Remove any dust, powder,
or foreign particles to ensure proper installation.
2. Use the hand knob to loosen the mounting bar until
it is wide enough to t your bathtub.
3. Place the Bathtub Rail in the desired location on the
bathtub.
4. Turn the hand knob clockwise until the Bathtub Rail
is secure on the bathtub.
5. Test installation security by giving a strong pull to
the Bathtub Rail in a lengthwise direction to the
bathtub. If the Bathtub Rail moves, reset it and
tighten it more.
Caution: Do not over-tighten the Bathtub Rail.
WARNING: Ensure that the Sure-Safe Bathtub Rail is installed as described. If the Sure-
Safe Bathtub Rail is not properly assembled and installed, personal injury and damage to
the Sure-Safe Bathtub Rail could result.
operatIon
WARNING: Always ensure the Sure-Safe Bathtub Rail is secure before use.
WARNING:HoldtheSure-SafeBathtubRailrmlywhenenteringorexitingthebathtub.
2032A Sure-Safe
®
Bathtub Rail
hand
knob
mounting
rail
mounting
bar

2 2032A-INS-LAB-RevA08
© December 2008 GF Health Products, Inc. • 2935 Northeast Parkway • Atlanta, GA 30360 • tel [phone] • fax [phone] • www.grahamfield.com
GF Health Products, Inc. is not responsible for typographical errors. Packaging, warranties, products and specications are subject to change without notice.
Graham-Field, Lumex, and Sure-Safe are registered trademarks of GF Health Products, Inc.
MaIntenance
WARNING: Check the Sure-Safe Bathtub Rail weekly for signs of damage or cracking. If
damage or cracking of any component of the Sure-Safe Bathtub Rail is found, DO NOT
use the Bathtub Rail. Contact your Graham-Field provider.
Inspect the Sure-Safe Bathtub Rail weekly and tighten it as needed to ensure proper installation.
To clean the Sure-Safe Bathtub Rail, wash it with soap and water or a mild detergent, then rinse.
Ensure that the Sure-Safe Bathtub Rail is rinsed well before use.
Warranty
GF Health Products, Inc. warrants the Lumex 2032A Sure-Safe Bathtub Rail as follows:
Limited lifetime warranty against manufacturer's defects. If a product is deemed to be under war-
ranty, GF Health Products, Inc. shall provide, at its option, (1) replacement of any defective part or
product or (2) a credit of the original selling price made to GF Health Products, Inc.'s initial cus-
tomer. The warranty does not include any labor charges incurred in replacement part(s) installa-
tion or any associated freight or shipping charges to GF Health Products, Inc.