Grape Solar GS-900-PH-KIT Assembly instructions

www.GrapeSolar.com
Tel. [phone] (toll free), 1-541-349-9000
Document Version 20190905
©Copyright 2019, Grape Solar, Inc. All Rights Reserved
900-Watt Off-Grid Charging Kit
(GS-900-PH-KIT)
Quick Connect Guide
IMPORTANT: Please read GS-MPPT-Zenith-60 charge
controller owner’s manual, and PowerHub Owner’s Guide
(included with products) before assembling kit.
For additional information about Grape Solar products:
email [e-mail], or
call 1-877-264-1014 for live telephone support.
GS-900-PH-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 190905
1Check your order to make sure that all parts are included:
 1x GS-MPPT-Zenith-60 Charge Controllers
 1x 15-Amp MC4 In-Line Fuses
 3x GS–M60-300-Fab1-US Solar Panels
 1x 5-ft. Red/Black 4-AWG Cable Pair
 4x 15-ft. MC4 Cables
 1x 6-in. Red/Black MC4-to-Bare Wire Pair
 Xantrex PowerHub with 2x Battery Boxes
Additional tools and equipment you will need:
◦Screwdrivers– Philips Head & Flat Head
◦1-4 12-volt deep cycle AGM batteries as per Powerhub manual
◦Voltmeter (for Troubleshooting)

x4


x3

To estimate how much average monthly
power this system should produce in your
area, please use the PV Watts Calculator
found at:
https://pvwatts.nrel.gov/
This System Size= 0.9 kW DC
(only applicable for zip codes in the U.S.A.)

[The Quick Connect Guide diagrams are not to scale.]


www.GrapeSolar.com
Tel. [phone] (toll free), 1-541-349-9000
GS-1080-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 190316
3
Using a Phillip's head screw driver, open the blue
front panel on the Zenith-60 charge controller .
Connect the bare wire end of the 6-in. Red/Black
MC4-to-Bare Wire Pair’s  red wire to the (+)
solar terminal of a Zenith-60 charge controller .
Connect the bare wire end of the pair’s black
wire to the (-) solar terminal.
Connect the bare wire end of the 5-ft. Red/Black 4
AWG Cable Pair’s  red wire to the (+) battery ter-
minal of a Zenith-60 charge controller . Connect
the bare wire end of the pair’s black wire to the (-)
battery terminal.
Reattach the blue front panel to the controller unit.
5
Mount the 300-watt solar panels  so that they are facing due South at approximately the same angle as your
latitude. The ideal area has full sun and no shading. If the following connections are made during daylight, cover
the panels with cardboard, cloth, or a similar opaque material so that the panel does not output power.
Use the instructions from the PowerHub  Installation Manual to attach the battery boxes to the inverter compo-
nent. The two battery boxes can store a maximum of 4 x 100+ Ah 12V sealed lead acid batteries (not included
with kit.) All batteries in the system must be identical in regards to make, model, and usage history. Follow all
precautions while installing batteries into the PowerHub battery boxes. Follow instructions to connect the large
Anderson connectors to the inverter port.
2
4






GS-900-PH-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 190316
GS-900-PH-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 190905
Document Version 20190905
©Copyright 2019, Grape Solar, Inc. All Rights Reserved

6
GS-1080-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 190316
www.GrapeSolar.com
Tel. [phone] (toll free), 1-541-349-9000
IMPORTANT— READ CAREFULLY: If the AC Indicator LED on the front of the PowerHub  is off (see picture
below,) it is safe to remove the top of the inverter. Remove the 5 Philips screws to detach the inverter lid.
Remove the upper-left punchout disc on the backside of the inverter.
With the inverter  lid removed, place the charge controller ring-lug cable  ends through the punchout hole.
For this system, these ring lugs must be connected to the “WIND” INPUT. (Do not connect the charge controller
cables to the solar input.) Screw both RED ring lugs onto the positive (+) wind terminal. Screw both BLACK ring
lugs onto the negative (-) wind terminal.
7
AC light
indicator
screws punchout
disc
front back
+_
top




GS-900-PH-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 20190905
Document Version 20190905
©Copyright 2019, Grape Solar, Inc. All Rights Reserved

DISCLAIMER:
Installations of this kit could be subject to national and local building and electrical codes. Installers should have adequate knowledge of
national and local code to ensure the installation passes inspection by the local electric authority.
Proper fuses or breakers should be used to comply with all local and national codes. Contact Grape Solar for specific recommendations.
All batteries used for this system should be identical. Do not mix battery types or sizes. Do not mix old batteries with new batteries.
Performance and charging anomalies can occur if types, sizes, or age of batteries are not identical.
Grape Solar does not warrant the accuracy, sufficiency, or suitability to all customers of any technical or other information provided in
product manuals. Grape Solar does not claim any responsibility or liability for losses, damages, costs or other expenses whether special,
indirect, consequential or incidental, which might arise out of the use of such information.
DISCLAIMER:
Installations of this kit could be subject to national and local building and electrical codes. Installers should have adequate knowledge of
national and local code to ensure the installation passes inspection by the local electric authority.
Proper fuses or breakers should be used to comply with all local and national codes. Contact Grape Solar for specific recommendations.
All batteries used for this system should be identical. Do not mix battery types or sizes. Do not mix old batteries with new batteries.
Performance and charging anomalies can occur if types, sizes, or age of batteries are not identical.
Grape Solar does not warrant the accuracy, sufficiency, or suitability to all customers of any technical or other information provided in
product manuals. Grape Solar does not claim any responsibility or liability for losses, damages, costs or other expenses whether special,
indirect, consequential or incidental, which might arise out of the use of such information.
www.GrapeSolar.com
Tel. [phone] (toll free), 1-541-349-9000
GS-1080-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 190316
8Connect the solar panels  together into a three-panel series “string.” Series connections are made when the
positive cable from one panel is connected to the negative cable from the next panel. On the open positive end of
the solar panel triad, connect a 15-amp in-line fuse .
Use the 15-ft MC4 cables  to connect each solar panel  triad to a Zenith-60 charge controller . Use the all 4
of the 15-ft cables to provide 30-feet of span between the panels and the charge controller.
If the batteries are not already full, you should now begin to see power flowing into the batteries.
9



 





GS-900-PH-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 20190905
Document Version 20190905
©Copyright 2019, Grape Solar, Inc. All Rights Reserved