Grilla Grills Primate PM-500-A User manual

NG Hook up Guide
There are 6 screws on the rear panel of your grill. Remove them and carefully take the panel o.
Set aside screws for later.
Next, remove the front panel of
your grill. There are two screws on
both sides of the grill.
Once removed, you may need to
disconnect the four ignitor wires
from the panel. This allows for
easier access.
Remove the 2 screws holding
together the gas line. Set aside
screws for later.
Prior to installation make sure you have all the
neccessary equipment before moving forward.
In this kit you should have received:
NG regulator *1pc
NG Jet 1.85mm *4pcs
Before you begin your installation rst start by
taking o both the front control panel and rear
access panel.
* Keep all hardware
1
2
2-1
2-3
2-2
2-4 2-5

NG Hook up Guide
Remove LP jet with spanner
wrench
Install NG jet with sealing glue.
Remove LP connector with
spanner wrench.
Install NG regulator to make
sure the OUT side connect to
bellows.
4
5
6
3

NG Hook up Guide
Re-insert knobs once complete.
Gas leak test and re test by a professional.
Reassemble control panel
Fix NG regulator with phillips
head screw driver
Remove four knobs of the
control panel.
The regulator is set to LP by default, switch
the valve rod with straight screwdriver
clockwise 1.5~2 rotations, check the gas
ow with ow gauge to meet standard
proessional regulations.
7
8
10
9
11