Grizzly H8239 User manual

For questions or help with this product contact Tech Support at [phone] or [e-mail]
MODEL H8239
SAFETY LOCKING ON/OFF
SWITCH
INSTRUCTIONS

WARNING: NO PORTION OF THIS INSTRUCTION SHEET MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

Introduction






 
Specifications
 
 

Figure 1.


To reduce risk of serious burns, electrocu-
tion or death when installing this switch:
• Only use this switch to replace an existing
machine switch that has the same physi-
cal configuration and equivalent electrical
specifications/ratings.
• Installationmustonlybeperformedbyan
electrician or qualified service personnel,
and all applicable electrical codes must
be adhered to.
• Turn off and completely disconnect all
power sources to the machine before
installing the switch.
• Do not use this switch in wet or damp
locations, or near explosive fumes or
flammable liquids. It is not sealed or rated
for these environments.
• Make sure there is a verified machine
ground on the circuit this switch is
installed.

 
Rear View
of Switch
Hot
Out
Hot
In
Machine
Out
125V Neutral
or 250V Hot
In
125V Neutral
or 250V Hot
KEDU
HY18-XX
Power Source
Verified
Ground*
Figure 2.
Installation

  Figure 2     

Operation
ON

OFF
    OFF


This switch is intended to be connected to
stranded wire with insulated quick-discon-
nect crimp-type female wire terminals hav-
ing a 1⁄4" tab.
All crimps must be "pull-checked" to ensure
that wires are securely crimped and will
not fall out with moderate tension or when
exposed to normal machine vibration.
       
       


