21
OPERATION _____________________________
Preparation
1 Remove all packaging and sticker materials
and dispose of them according to the
applicable legal regulation.
2 Before using of the appliance for first time,
clean all parts which come into contact with
water carefully.
(See the “Cleaning and care” section).
3 Completely roll out the power cord L from
the power cord storage K on the bottom of
the base J. Pass the power cord through
the slot on the base.
4 Fill the water tank G with water.
5 Set the kettle on its base J. Make sure that
the kettle is sitting in an upright position and
that it is sitting on the base correctly and in
a stable position.
6 Pour out the hot water and rinse the kettle
with water. This will remove any remaining
manufacturing residues from the inside of
the water tank G.
7 Clean kettle well before initial use and
discard water of first two boiling cycles.
Operation
1 Push the lid release button D on the kettle
to open the lid A.
– The lid A opens automatically.
2 Fill the water tank G with water.
Note
Do not place the water tank G on the base
J while filling it with water.
Never fill the water tank G above the
maximum level indicator or below the
minimum level indicator.
3 Close the lid A until it clicks into place.
4 Place the water tank G on the base J.
Make sure that it is sitting in an upright and
stable position.
5 Insert the plug into the wall socket.
6 Press down On/Off switch I.
– Power on indicator H illuminates and
heating process begins.
Note
Lid A should always be closed during the
heating process; otherwise the kettle will not
switch off automatically.
7 After a few minutes, the water will start to
boil. The kettle switches off automatically
and On/Off switch I moves upwards.
– Power on indicator H goes off
Note
If you want to stop the heating manually,
push the On/Off switch I upwards. Power
on indicator H goes off.
8 Disconnect the plug from the wall socket.
9 Take the water tank G from the base J.
Only hold it by the handle E.
Caution
Do not open the lid A as hot water could
splash out. Make sure that no water splashes
onto the base J.
10 Pour the water from the spout B to the cup
or glass you want to use.
Notes
If you want to continue the heating process,
repeat the procedure from 1 to 10.
Let the kettle cool down between each
heating process.
Hints and Tips
The kettle is equipped with a filter C which
filters out limestone and other residues when
the water is being poured out.
Use softened or filtered water to prevent lime
build-up.