Preparation
1 Remove all packaging and sticker materials
and dispose of them according to the applica-
ble legal regulation.
2 Before using the appliance for the first time,
clean all parts which come into contact with
water (see the “Cleaning and care” section).
3 Completely roll out the power cord from the
storage I on the bottom of the base H. Pass
the power cord through the slot on the base.
4 Fill the water tank with water.
5 Set the kettle on its base H. Make sure that
the kettle is sitting in an upright position and
that it is sitting on the base correctly and in a
stable position.
6 Pour out the hot water and rinse the kettle with
water. This will remove any remaining manu-
facturing residues from the inside of the water
tank.
7 Clean kettle well before initial use and discard
water of first two boiling cycles.
Operation
1 Push the lid release button D on the kettle to
open the lid C.
― The lid C opens automatically.
2 Fill the water tank with water.
Notes
7 Do not place the water tank on the base H
while filling it with water.
7 Never fill the water tank above the maximum
level indicator or below the minimum level
indicator.
3 Close the lid C until it clicks into place.
4 Place the water tank on the base H. Make
sure that it is sitting in an upright and stable
position.
5 Insert the plug into the wall socket.
6 Press down On/Off switch G.
― On/Off switch G illuminates blue and boil-
ing process begins.
Note
7 Lid C should always be closed during the
boiling process; otherwise the kettle will not
switch off automatically.
7 After a few minutes, the water will start to boil.
The kettle switches off automatically and On/
Off switch G moves upwards.
― The blue light goes off.
Note
7 If you want to stop the heating process manu-
ally, push the On/Off switch G upwards.
8 Disconnect the plug from the wall socket.
9 Take the water tank from the base H. Only
hold it by the handle E.
Caution
7 Do not open the lid C as hot water could
splash out. Make sure that no water splashes
onto the base H.
10 Pour the water from the spout A to the cup
or glass you want to use.
Notes
7 If you want to continue the boiling process,
repeat the procedure from 1 to 10.
7 Let the kettle cool down between each heat-
ing process.
Hints and Tips
7 The kettle is equipped with a calc filter B
which filters out limestone and other residues
when the water is being poured out.
7 Use softened or filtered water to prevent lime
build-up.
OPERATION ______________________________
