
ENGLISH 23
OPERATION ________________________________
Preparation
1 Remove all packaging material and stickers.
Dispose of them according to the applicable
statutory regulations.
2 Before using the appliance for the first time,
carefully clean all parts that come into contact
with water. (See the “Cleaning and care” section.)
3 Unroll the power cord H from the base F. Pass
the power cord through the slot on the base.
4 Open the lid by squeezing the lid release buttons
C together and lifting it off.
5 Fill the water tank D with water.
6 Put the lid J on and push down to secure it
into place.
7 Set the kettle on its base F. Make sure the kettle
is sitting correctly on the base and that both parts
are in a stable position. Make sure that the base of
the kettle is placed on a heat-resistant, even, stable,
dry, non-slip surface.
8 Slide the open/close push button B to the closed
position to make sure no water or steam can come
out of the spout. No red is visible on the button
when it is in the closed position.
9 Insert the plug H into an earthed wall socket.
10 Clean the kettle to remove any manufacturing
residues:
a. Press to turn the kettle on and boil it.
b. Discard the boiled water.
c. Fill the kettle again and repeat steps 10a and
10b.
Operation
To set up the kettle, follow steps 4-9 above.
Notes
Do not place the water tank D on the base F while
filling it with water.
Never fill the water tank D above the maximum
level indicator or below the minimum level indicator.
Boiling water only
1 When the kettle is placed on its base, the icon
and 100°C appear on the LCD screen.
2 To boil the water, press
Notes
The icon flashes to show the kettle is boiling.
The icon stops flashing when the kettle turns off.
The LCD screen illuminates for 10 seconds after the
kettle turns off.
Heating water to your desired
temperature
1 When the kettle is placed on its base, the icon
and 100°C appear on the LCD screen.
2 Press until the icon appears.
3 Press or to set the temperature. The
temperature is adjustable from 40°C to 100°C in
5°C increments. The default setting is 100°C.
4 Press to heat the water to your set temperature.
Notes
The icon flashes to show the kettle is boiling.
The icon stops flashing when the kettle turns off.
The LCD screen illuminates for 10 seconds after the
kettle turns off.
Notes
To manually stop the kettle at any time, press .
The lid should always be closed during the heating
process. If the lid is not placed on the kettle, the
kettle will stop to function.
When you remove the kettle from the base, all
settings will be deleted and it will return to the
default setting.
Keeping water warm
Your kettle can keep water warm for up to 40 minutes at
a preset temperature.
1 Press until the keep warm icon appears.
2 Press or to set the temperature. The
temperature is adjustable from 40°C to 90°C in
5°C increments.