ENGLISH 17
If run with the installed rechargeable nickel
cadmium batteries, use the charging station with
the mains adapter as a charger.
Charging
If run with the installed rechargeable nickel cad-
mium batteries, use the charging station with the
mains adapter as a charger.
1Remove the accessory used.
2Insert the appliance in the charging station
so that it precisely fits.
– The charging contacts of the appliance and
the charging station touch each other.
3Plug the mains adapter into the wall socket.
– The charging process begins, the charging
indicator lights up red.
– The charging indicator remains lit until the
appliance is removed from the charging stati-
on or the mains adapter plug is disconnec-
ted.
– If charging has finished the red charging
indicator goes out.
Note
7Fully charge the batteries before using for the
first time or if the batteries have not been used
for a long time.
(20 hours).
7Charge the appliance at room temperature.
Lower or higher temperatures have a negative
effect
on the life of the batteries.
7The ambient temperature should be between
5˚C and 40˚C.
7After charging the running time is
8 minutes.
E
J
Switching on and off
1Remove the appliance from the charging stati-
on .
2Depending on the requirements, insert one of
the accessories into the appliance's vacuum
intake .
3Switch on the appliance by pushing forward
switch .
4Switch off the appliance by pushing back
switch .
5Remove the accessory used.
6Insert the appliance in the charging station
so that it precisely fits.
Empty dust container and clean
1Hold the appliance vertically with the vacuum
intake facing downward.
2Press pushbutton and remove the dust con-
tainer from underneath.
3Remove the holder and filter from the dust
container.
Note
7You can wash the filter from time
to time with hot soapy water.
After washing, allow the filter to completely
dry.
4Empty the dust container , wash out and
dry.
Note
7Allow the dust container to completely dry
before you replace it in the appliance.
5Hold the appliance vertically facing upwards.
6Press button .
7Replace the dust container , ensure that
both plug-in contacts of the dust container are
precisely inserted in the correct position.
8Release button . Ensure the latch clicks into
place.
D
A
D
A
B
D
C
J
F
F
C
J
USE ________________________________________________________________________