GTO®,GTO/PRO®, Bulldog®, Mighty Mule® and E-Z Gate® are registered trademarks of GTO,Inc. Professional Access Systems™ , America's DIY Automatic Gate Openers™ are trademarks of GTO, Inc.
and are the exclusive property of GTO, Inc. (“GTO”). All rights are reserved by GTO, and these marks may not be used, in any for without the prior,written permission of GTO. Copyright 2007 rev-5-2007
www.gtopro.com
ESTATE RESIDENTIAL
AGRICULTURAL
PRO3000XL-CS
Includes large control box,
radio receiver, transmitter,
AC transformer, and all
necessary mounting
hardware for a standard
post mount installation,
14” (36 cm) offset.
PRO-SW3000XL-LCB
DRIVE
Powered by: a reliable 12 Volt (120 Watt)
DC motor, 16:1 planetary gear drive system.
Temperature rating: -5°F (-28°C)
to +160°F (71°C). Battery rating
Opening time: From 15 seconds.
Range of arm stroke: is up to 16”(41 cm).
Operator length with arm fully retracted is
40.25” (102 cm), mounting point to
mounting point.
POWER
The PRO-SW3000XL-LCB system requires
a large automotive or marine battery (not
included). Battery charge is maintained by
a120V AC/60 Htz input and 18V AC at 40
VA output, transformer rectied to 14V DC
through control board.
Solar Panel Charger: oat voltage
14.5 V DC output from a 19-3/8” (49.21 cm) x
15 1/4” (38.74 cm) silicon alloy panel. Gener-
ates minimum of 10 watts at 600 mA. A gated
diode on the control board prevents battery
discharge. (FM123)
FEATURES
• Large control box (19”H x 18.25”W x 8.25”D) provides room
for automotive or marine battery and room for access controls.
• Extended Cycle Life - Enhanced motor design makes this
operator ideal for today’s single family estates, housing
complexes of up to twenty multi-family units or equivalent
commercial applications.
• Features GTO/PRO’s true soft start and stop operation.
Open and close times from 15 seconds.
• Full systems capable, single/dual control board includes an
adjustable obstruction sensing, gate sequencing, and auto
close settings.
• U.L. rated for Class I, II, III & IV. System certied to be in
compliance with U.L. 325, 5th edition.
CONTROLS
• The GTO/PRO® control board can be programmed for
pull-to-open or push-to-open.
• Adjustable auto close, obstruction sensitivity, dual gate sequencing.
• One button auto-memorization of digital transmitter code.
• Charging regulated circuit on control board. “Sleep draw”
is 40 mA; “active draw” is 2 to 9 amps.
• GTO/PRO® remote-mounted 318 MHz RF receiver and one
button transmitter included.
OPTIONS:
Dual applications: The PRO-SW3200XL is designed to work
as a slave gate operator in dual gate applications when combined
with a PRO-SW3000XL-LCB. Includes a 40’ (12.2m) power cable.
Push to open applications: Require one (349IH) bracket
per operator.
The PRO-SW3000XL-LCB Kit provides the room necessary to utilize a large automotive or ma-
rine battery and will operate a gate up to 16’ (4.9 m) long and weighing 650 lbs.
(294.8 kg) each leaf; if all proper installation procedures have been followed. Ball bearing
hinges should be used on all gates weighing over 250 lbs (113.4 kg).
SUGGESTED ACCESSORIES:
• Automatic Gate Lock (FM144/FM142)
• Estate Intercom/Keypad (F4100MBC)
• Gooseneck Pedestal (F100/F110)
• Driveway Exit Wand (FM140)
• Solar Panel (FM122/FM123)
• Keychain Transmitter (RB742)
• Digital Keypad (F310)
• Loop Detector (LOOPDT1)
• Preformed Loops (L-SC-0408/0612,
L-PO-0408/0612)
