GTO®,GTO/PRO®, Bulldog®, Mighty Mule® and E-Z Gate® are registered trademarks of GTO,Inc. Professional Access Systems™ , America's DIY Automatic Gate Openers™ are trademarks of GTO, Inc.
and are the exclusive property of GTO, Inc. (“GTO”). All rights are reserved by GTO, and these marks may not be used, in any for without the prior,written permission of GTO. Copyright 2007 rev-5-2007
www.gtopro.com
ESTATE RESIDENTIAL
PRO-SW4000XL-LCB
PRO4000XL-CS
Includes large control box,
radio receiver, entry transmitter,
AC transformer, and all necessary
mounting hardware for a post or
column mount installation,
19” (48 cm) total offset.
DRIVE
Powered by: a reliable 12 Volt (120 Watt)
DC motor, 16:1 planetary gear drive system.
Temperature rating: -5°F (-28°C)
to +160°F (71°C). Battery rating.
Opening time: From 18 seconds.
Range of arm stroke: is up to 22”(56 cm).
Operator length with arm fully retracted is
46.25” (118 cm), mounting point to
mounting point.
POWER
The PRO-SW4000XL-LCB system requires
a large automotive or marine battery (not
included). Battery charge is maintained by
a120V AC/60 Htz input and 18V AC at 40
VA output, transformer rectied to 14V DC
through control board.
Solar Panel Charger: oat voltage
14.5 V DC output from a 19-3/8” (49.21 cm) x
15 1/4” (38.74 cm) silicon alloy panel. Gener-
ates minimum of 10 watts at 600 mA. A gated
diode on the control board prevents battery
discharge. (FM123)
FEATURES
• Large control box (19”H x 18.25”W x 8.25”D) provides room
for automotive or marine battery and room for access controls.
• Room to utilize a large automotive or marine battery.
• Ideal for column mount applications with up to 19” (48 cm)
of offset.
• Extended Cycle Life - Enhanced motor design makes this operator
ideal for today’s single family estates, housing complexes of up to
twenty multi-family units or equivalent commercial applications
• Features GTO/PRO’s true soft start and stop operation. Open and
Close times from 18 seconds.
• Full systems capable, single/dual control board includes an adjust
able obstruction sensing, gate sequencing and auto close settings.
• U.L. rated for Class I, II, III & IV. System certied to be in compli-
ance with U.L. 325, 5th edition.
CONTROLS
• The GTO/PRO® control board can be programmed for
pull-to-open or push-to-open.
• Adjustable auto close, obstruction sensitivity and dual gate sequencing.
• One button auto-memorization of digital transmitter code.
• Charging regulated circuit on control board. “Sleep draw”
is 40 mA; “active draw” is 2 to 9 amps.
• GTO/PRO® remote-mounted 318 MHz RF receiver and one
button transmitter (included).
OPTIONS:
Dual applications:
The PRO-SW4200XL is designed to work as a slave gate operator
in dual gate applications when combined with a PRO-SW4000XL-
LCB; includes a 50’ (15.2m) power cable.
The PRO-SW4000XL-LCB Kit provides the room necessary to utilize a large automotive or
marine battery and will handle gates weighing up to 1000 lbs. (453 kg) and up to 20 ft.(6.1 m)
in length (per leaf) if all proper installation procedures have been followed. Ball bearing hinges
should be used on all gates weighing over 250 lbs (113.4 kg).
SUGGESTED ACCESSORIES:
• Automatic Gate Lock (FM144/FM142)
• Estate Intercom/Keypad (F4100MBC)
• Gooseneck Pedestal (F100/F110)
• Driveway Exit Wand (FM140)
• Solar Panel (FM122/FM123)
• Keychain Transmitter (RB742)
• Digital Keypad (F310)
• Loop Detector (LOOPDT1)
• Preformed Loops (L-SC-0408/0612,
L-PO-0408/0612)
