H3C MSR810 Operating and maintenance manual

Introduction to installation accessories
Wear an ESD-preventive wrist strap, and make sure the wrist strap makes good skin
contact and is well grounded.
操作者需佩戴防静电腕带，确保防静电腕带与皮肤良好接触，并确认防静电腕带已经良好
接地。
The installation tools are not provided with the router. Prepare them yourself.
路由器不随机提供安装工具，请用户根据实际安装需求自己准备安装工具。
2
1
Tool list
!
H3C MSR810 Routers Installation Quick Start-6P102
H3C MSR810 -6P102
4G antenna
外置4G天线
GPS antenna
GPS天线
Wall anchor and screw
(user supplied)
膨胀螺管和螺钉
(用户自备)
WLAN antenna
WLAN天线
Ring terminal
接地端子
Rubber feet
胶垫贴
Cage nut
(user supplied)
浮动螺母(用户自备)
M6 screw
(user supplied)
M6 螺钉(用户自备)
M4 screw
(user supplied)
M4 螺钉(用户自备)Mounting brackets
挂耳
Ruler
水平尺 Wire-stripping pliers 剥线钳 Rubber hammer 橡胶锤 ESD wrist strap 防静电腕带
Heat gun
热吹风 Drill 电钻 Marker 记号笔
Diagonal pliers
斜口钳
Flathead screwdriver
一字螺丝刀 Phillips screwdriver 十字螺丝刀
Wall-mounting the router
≥22 mm (0.87 in)
≥1.5 mm
(0.06 in)
160mm(6.30in)
When you mount the router on a wall, make sure the Ethernet ports face downwards
and the two sides with ventilation holes are perpendicular to the ground.
安装时请将设备的以太网口朝下，设备带通风孔的两个侧面与地平面垂直。
The RT-MSR810-10-PoE router is not wall mountable.
RT-MSR810-10-PoE不支持壁挂安装。
!
13 4
2
5 6

4
3
No mounting brackets are provided with the router. Prepare it yourself.
设备发货时不随机提供挂耳，用户请单独购买。
The RT-MSR810-10-PoE router supports SD card installation. Other MSR810 routers
support Micro SD card installation. Purchase a Micro SD card or an SD card as required.
仅RT-MSR810-10-PoE支持安装SD卡。
Reinstall the cover after the installation. 安装完成后，请注意安装上卡盖。
Mounting the router to a rack
Attach the mounting brackets to
the router.安装挂耳到路由器。
Mount the router in the rack.
安装路由器到机柜。
Install cage nuts.
安装浮动螺母。
!Attach the rubber feet to the holes in the router bottom. Then place the router on the
workbench upside up. 将脚垫粘贴到路由器底部，水平放置在工作台上。
Installing a Micro SD card/SD card Micro SD SD
Remove the SIM card slot cover, insert the SIM card into the slot, and reinstall the cover.
使用螺丝刀将SIM卡的卡盖拧开，将SIM卡插入到卡槽中，再盖上卡盖。
Remove the Micro SD card or SD card slot cover, insert the card into the slot, and reinstall
the cover. 使用螺丝刀将Micro SD卡的卡盖拧开，将Micro SD卡插入到卡槽中，再拧上卡盖。
Workbench-mounting the router
!
12
12

6
5
Only the RT-MSR810-LM、RT-MSR810-
W-LM、MSR810-LM-HK and MSR810-
W-LM-HK routers support 4G antennas.
仅RT-MSR810-LM、RT-MSR810-W-
LM、MSR810-LM-HK和MSR810-W-LM-
HK支持安装4G天线。
You can install two WLAN antennas for the RT-MSR810-W 、RT-MSR810-W-LM and
MSR810-W-LM-HK routers. You can install four WLAN antennas for the RT-MSR810-W-DB
router. The RT-MSR810、RT-MSR810-LM and MSR810-LM-HK routers do not support
WLAN antennas.
RT-MSR810-W、RT-MSR810-W-LM和MSR810-W-LM-HK支持两根WLAN天线；RT-
MSR810-W-DB支持四根WLAN天线；RT-MSR810、RT-MSR810-LM和MSR810-LM-HK不支
持安装WLAN天线。
Attach the 4G antennas to the router and change the angle of the antenna orientation
from horizontal to vertical.将两根4G天线依次右旋安装在设备上，向上垂直。
Attach the WLAN antennas to the router and change the angle of the antenna orientation
from horizontal to vertical.将两根WLAN天线依次右旋安装在设备上，向上垂直。
Installing 4G antennas 4G
Connecting the grounding cable to the router
Installing a GPS antenna GPS
Only the RT-MSR810-W-LM、RT-
MSR810-LM、RT-MSR810-W-LM-HK and
RT-MSR810-LM-HK routers support a GPS
antenna.
仅RT-MSR810-W-LM、RT-MSR810-LM、
RT-MSR810-W-LM-HK and RT-MSR810-
LM-HK支持安装GPS天线。
Correctly connecting the grounding cable is crucial to lightning protection and EMI
protection. Attach the ring terminal provided with the router to the grounding cable.
Make sure the grounding cable is reliably grounded.
路由器地线的正确连接是路由器防雷、防干扰的重要保障，请使用设备随机提供的接地端
子制作保护地线，并正确接地。
!
No GPS antenna is provided with the router. Prepare it yourself.
设备发货时不随机提供GPS天线，用户请单独购买。
!
12 3