habitat et jardin Kiss Pool User manual

2019-2020

1 200*81*61mm X1
2 Ø109*179mm X1
3
8
9
378*164*143mm X1
196*102*79mm
230*200mm
175*140*40mm X1
7
X1
10
11
X1
X1
X1
1/1
1/1
1/1
1/1
1/1
1/1
1/1
1/1
80*80*30mm
37*35*88mm

(1)Plug one end of the charger into the socket, and the charger is green.
(2)Then, plug one end of charger to P1111, the charger is red, the charger is working
now.
(3)After charging 3 hours, the charger becomes green, and P1111 is fully charged.

A B
b1 b3b2
C D
c1 c3c2

Problem Possible Cause Remedy
Battery is running out
Impeller is jammed
Impeller is broken
Detach the filter basket and filter bag,
and clean them.
Replace a new filter sock.
Power off the cleaner and visually check
the gap in middle of the cleaner to see if
the impeller is jammed. you can use your
hand to rotate the impeller two circles to
make the impeller rotation looser.
WARNING! Make sure cleaner is
power off when servicing the cleaner.
Charge the battery again. Normally
cleaner can operate 45~60 minutes
after fully charged.
When the filter bag
is full
Filter sock is
damaged
Garbage flowing out
from the Transparent
Suction Head part
Garbage flow out from
the rear filter bag
Cleaner does not
capture the debris
Side pin broken Using the new V-Shape clip
Contact your dealer for impeller
replacement.
The charger is out of
order WARNING! Using wrong charger will
result in damaging the cleaner
/battery and void the warranty.
Contact dealer for proper transformer.
Cleaner cannot be
recharged
Battery is dead
WARNING! When you replace the
battery, please contact the local
dealers to purchase the original
lithium battery in case that the electric
cleaner is destroyed.
Contact dealer for battery replacement.
The soft rubber of rear impeller is like a
door in case the garbage in the filter bag
will flow backwards into impeller and the
cover of transparent suction head part.
The soft rubber of
the rear impeller is
broken
Handle/pole connector
cannot be secured in
assembly

Batterie:
Tension de charge:
Tension du moteur:

(1) Branchez une extrémité du chargeur dans la prise, et le chargeur est vert.
(2) Ensuite, branchez une extrémité du chargeur sur P1111, la charge est rouge, le
chargeur fonctionne maintenant.
(3) Après avoir chargé 3 heures, le chargeur devient vert et P1111 est complètement
chargé.