Specification Details
Certifications CE
Warranty EU: 2 years, US: 1 year
Table 1 Specifications—Measurement ranges and detection limits
Parameter Unit Measurement range based on the optical path2 3
50 mm 100 mm 150 mm 250 mm
SAC 436 nm 1/m 0.1 to 30 0.05 to 15 0.03 to 10 0.02 to 6
True color 410 nm mg/L Pt 2 to 560 1 to 280 0.6 to 185 0.4 to 110
Hazen 390 nm mg/L Pt 0.8 to 220 0.4 to 110 0.3 to 75 0.2 to 45
Hazen 455 nm mg/L Pt 4 to 1100 2 to 550 1.5 to 360 0.8 to 220
General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer’s website.
Safety information
N O T I C E
The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.
Use of hazard information
D A N G E R
Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.
WARNING
Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or serious
injury.
CAUTION
Indicates a potentially hazardous situation that may result in minor or moderate injury.
N O T I C E
Indicates a situation which, if not avoided, may cause damage to the instrument. Information that requires special
emphasis.
2Transmission at 740 nm must always be higher than 33%, if not, the content of turbid material in
the medium is too high and the path must be lower.
3The detection limit specification refers to a standard reference solution with lab conditions.
4 English
