Halsey Taylor 4520-68 User manual

These fountains are certified to
NSF/ANSI 61.
GENERAL
Pedestal, cast iron closed base with forest
green enamel finish for year-round beauty with
minimum maintenance. Contour-formed basin
with rounded corners and edges reduces
splatter, insures proper drainage and prevents
standing waste water. Model 4520-68 is 30"
high and Model 4521-68 is 36" high
BUBBLER
Single-stream, self-closing, pushbutton operat-
ed with integral volume control for maintaining
proper stream height. Also includes hood
guard and anti-squirt feature.
AUTOMATIC STREAM HEIGHT REGULATOR
Self-closing assembly is located inside unit to
prevent tampering. Unit resists corrosion and
liming. A constant stream height is automatically
maintained under line pressures that vary from
20 to 105 psi.
INLET STRAINER
Easily cleaned in-line strainer screen traps
particles of 140 microns or larger before they
enter the waterway.
WATER INLET
3/8" O.D. Tubing
DRAIN OUTLET
1-1/4" tube outlet for 1-1/4" slip joint connec-
tion.
SUGGESTED SPECIFICATIONS
Fountain shall include pushbutton on the front.
Shall include contour-formed basin to eliminate
splashing and standing water, and shall have
rounded corners and edges. Projector shall be
single-stream type with integral hood guard and
anti-squirt feature. The manufacturer shall certify
the unit to meet the requirements of NSF/ANSI
61, and the Safe Drinking Water Act.
Note: Continued product improvement makes
specifications subject to change without notice.
See Halsey Taylor website for most current
spec sheet.
Standard Finish is Forest Green enamel.
Each 4520-68 / 4521-68 consists of 1 carton
of the following:
Fountain
Trap and service stop not included.
Shipping weight: 63 lbs.
HALSEY TAYLOR, 2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523
D19 / 8-2007
MODEL: ■■4520-68 (30") ■■4521-68 (36")
Pedestal Fountain
Cast Iron
halseytaylor.com
JOB NAME:
ENGINEER/CONTRACTOR NAME:
APPROVAL:
DATE:

Printed in the U.S.A.
4520-68 (30"), 4521-68 (36")
Cast Iron
Pedestal Fountains
(CONTINUED)
MOUNTING INSTRUCTIONS
• Provide solid, well-drained surface to mount
fountain.
• Locate and install plumbing through ground as
shown in rough-in.
Note: Fountain is not furnished with service valve.
• Locate three tripod mounting holes as shown
on rough-in. Mounting bolts not furnished –
7
/16" diameter holes provided in tripod.
• Remove set screw in side of tripod cover and
raise cover to aid in positioning fountain over
mounting holes. Support cover with blocking
while making plumbing connections.
• Use unions to connect supply and waste lines.
• Anchor tripod to ground.
• Turn on water supply and check for water
leaks.
• Lower tripod cover, align hole for set screw
and tighten set screw into leg of tripod.
• Stream height is factory set at 45-50 psi.
Trap and service stop not included.
OPERATING PRESSURES:
Supply water- 20 psi minimum to 105 psi
maximum.
4520-68 / 4521-68