Hamlet HNW150APBR User manual

Wi-Fi Personal Bridge 150
HNW150APBR
Repeater mode configuration
www.hamletcom.com

Repeater mode configuration procedure
1. Power off the HNW150APBR and slide the mode switch to WiFi AP.
2. Power on the HNW150APBR.
3. Configure the Internet Protocol (TCP/IP) Properties of PC to Static IP set to 10.0.0.3.
4. With the PC connected to HNW150APBR, log on the web page 10.0.0.2 and enter the
username as “admin” and password as “hamlet”.
5. In the left menu click on Wireless > Basic Settings.
6. Configure the Mode to “Client”, select “Enable Universal Repeater Mode (Acting as AP and
client simultaneously)”, configure SSID of Extended Interface and then click Apply Changes.
7. Click on Reboot Later button.

8. In the menu on the left, click on Wireless > Site Survey.
9. Click on Site Survey button.
10. Select the radio button of desired SSID that you want to connect to and click Next >>.
11. Configure the encryption parameters of SSID that you want to connect to and click Connect.
12. Wait until the PC is connected to the HNW150APBR portable router.

13. The device will reboot and activate the settings for a while.
14. Configure the Internet Protocol Properties (DHCP client) of the PC to obtain IP and DNS server
address automatically and make a reboot.
The HNW150APBR portable router is now configured to act as a Repeater.