HAMPTON BAY FSC18015 User manual

HAMPTONBAY.COM
FSC18015
0000 000 000
10 FT. X 12 FT. SOLAR LED LIGHTED GAZEBO

Table of Contents ...................................2
Safety Information ..................................2
Warranty ..........................................2
Maintenance ......................................
Pre-Assembly ......................................3
3
Planning Assembly............................... . . 3
Hardware Not Included ........................... . .3
Package Contents ................................ . . 4
Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Care and Cleaning .................................13
WARNING: READ ALL INSTRUCTIONS BEFORE USE
Close supervision is necessary when this furnishing is used
by or near children, or disabled persons, if applicable.
Use this furnishing only for its intended use as described in
these instructions. Do not use attachments not
recommended by the manufacturer.
WARNING: Do not leave the gazebo where there is a risk
of high wind, as possible damage will occur to the structure.
WARNING: This unit is heavy! Do not assemble this item
alone.
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY
CAUTION: Do not climb on top of the gazebo. Falling off
the gazebo can result in serious injury, possibly even death.
www.HAMPTONBAY.com.
GAZEBO gazebo
flammability requirements of CPAI-84. The fabric may burn
if left in continuous contact with any flame source. The
application of any foreign substance to the gazebo fabric
may render the flame-resistant properties ineffective.

HAMPTONBAY.COM
Safety Goggles Safety Hat Level Gloves Step Ladder Phillips Screwdriver
Maintenance
REPLACING THE BATTERY
NOTE: Use one Li-ion 18650 Lithium battery, 2000mAh,
3.7V rechargeable battery pack. For best performance,
replace with a Lithium rechargeable battery pack after 470
times cycle use，normally every year, based on customers’
different using situation.
NOTE: To reduce the risk of damage to the electrical
connections, exercise caution when separating battery
compartment base and cover.
IMPORTANT: When storing this gazebo, remove solar
plate from the top, and store it on a cool and high place, to
increase service life.
IMPORTANT: Dispose of the battery in accordance with
local, state and federal regulations.
Loosen the two lock screws on the base, remove the cover off
the base.
Remove the old battery pack from the compartment and replace
with a new 18650 Lithium battery, 2000mAh, 3.7V rechargeable
battery pack.
Lock base and cover with two screws.
screw
Lithium battery
Li-ion 18650
2000mAh 3.7V
battery compartment cover
battery compartment base

4
2
2
2
1
2
2
2
4
4
Post Short top bar
Middle top bar
Top center connector
Right short support bar
Left short support bar
Left long support bar
Right long Support bar
Long top bar
Corner bar

HAMPTONBAY.COM
KPlug tenon 4
LEdge plug tenon 8
MPlug cover 4
NSmall Canopy 1
OLarge Canopy 1
PSidewall 4
QNet Sidewall 1
RSolar plate 1
SLight 1
TGround stake 8

B
C
B
C
B
C
K
M
M
K
D
E
D
E
D
E
K
M
M
K
Take a left short support bar (C) and a right short support bar (B).
Fix the short support bar (C and B) using plug tenon (K) and
plug cover (M).
Fix the long support bar (E and D) using plug tenon (K) and
plug cover (M).
Take a right long support bar (E) and a left long support bar (D).
x2
x2

Attaching the support bars to the post
Assembling the Top connector bar
HAMPTONBAY.COM
B
B
C
C
E
E
D
D
A
A
A
A
x4
x4
L
L
F
G
F
F
F
F
G
G
G
G
J
x4
x4
Connect the short support bar (B and C)/long support bar (D and E) to the post (A)
using edge plug tenon (L) at each corner.
Insert the wire connector on long top bar (F) into the connector on top center
connector (J).
Insert the long top bar (F) into the top center connector (J) until the
marble pops up.
Slide a short corner bar (G) onto the ends of each long top bar (F)
until the short corner bar (G) click into place.

G
F
F
F
F
G
G
G
x4
Attaching the Top support bars to the post
Link the corner bar (G) onto the post (A).

HAMPTONBAY.COM
H
H
I
I
Attaching the Top support bars to the post

N
N
R
R
J
S
Assembling the roof
Put the small canopy (N) on top.
Insert the wire connector on top center connector (J) into solar plate (R).then turn solar plate (R) and insert it into the slot of
top center connector (J).
Insert the wire connector on top center connector (J) into light (S).