Hanh Filtration HF-SH User manual
This system has been tested according to NSF/ANSI 177 for reduction of free available chlorine. The
concentration of free available chlorine in water entering the system was reduced to a concentration
less than or equal to the permissible limit for water leaving the system, as specied in NSF/ANSI
177. This system has not been evaluated for free available chlorine reduction performance in the
presence of chloramines. Free available chlorine reduction performance may be impacted by the
presence of chloramines in the water supply. Please contact your local water utility to determine if
chloramines are used in treating your water.
The HF-SH Water Filtration System lter cartridge should be replaced every six months
to ensure peak performance.
This lter system is designed and tested for use with genuine Hahn Filtration parts,
including replacement lters and all hardware. Use of parts from other manufacturers
may result in loss of contaminant reduction performance, system damage or failure.
Use of parts from other manufacturers will also void your warranty. Please visit
hahnltration.com for all replacement parts.
Testing was performed under standard laboratory conditions, acutal performance may
vary. See preceeding page for general installation conditions and needs.
The Hahn shower ltration system is designed to produce the highest quality water
possible with the least amount of pressure loss. Hahn’s patented two-stage lter
cartridge substantially reduces chlorine and other chemicals present in tap water.
In compliance with California State Law, this system has a maximum ow rate of 2
gallons per minute. The Hahn adjustable shower head can be adjusted to the desired
pressure while still conserving water usage. The lter cartridge should be replaced
every six months per instructions.
• Do not use with water that is microbiologically unsafe or of unknown
water quality without adequate disinfection before or after the system.
• This system and installation shall comply with applicable state and local regulations.
• This system is not for use as a drinking water treatment unit.
Performance Data for the HAHN Premium Shower Filter HF-SH
Model Replacement Operating pressure range Rated capacity Max operating temp Rated ow
HF-SH HF-SH-R 50 psi 10,000 gallons 115° F 2.0 gpm
Manufactured by: Sink Warehouse, LP • 4601 Spicewood Springs Rd., Suite 1-100 • Austin, Texas 78759 • (888) 245-3114
Premium Shower Filter
Installation Instructions
MODEL HF-SH
HF-RO3-RM_OM_201403
Manufactured by Sink Warehouse, LP
4601 Spicewood Springs Rd, Suite 1-100, Austin, Texas 78759
(888) 245-3114 •www.hahnltration.com
1. Unpack and prepare contents:
Shower Filter body, threaded cartridge (already assembled) and Hahn
Shower Head
Remove the black plastic caps from the Shower Filter body.
Make sure the white rubber washer is in place in the chrome inlet collar.
2. Shower head removal
Remove your existing shower head from the shower supply pipe.
3. Filter attachment
Attach the Shower Filter body to the shower supply pipe at the side with
the chrome swivel collar. (Figure 1)
Turn clockwise to tighten.
Use a pair of pliers to turn the chrome swivel collar an additional ¼ turn or
until the lter system retains a rm position.
Teon tape may be required on threads of shower pipe.
4. Cold water lter ushand activation
A. Place bucket or container under the lter system to capture the rst 1-2
gallons of discolored water. (Figure 2)
B. Turn on cold water. After the water has turned clear, adjust the
temperature up to a normal shower temperature. There will be a slight
delay in temperature adjustment due to the volume of water in the lter.
C. Run water until clear and then turn off and back on several times. Repeat
this procedure until the initial surge of water is free of discoloration.
Water Supply Pipe
Water Out
Filter System
DO NOT OVERTIGHTEN THE CHROME INLET COLLAR
Overtightening may cause the washer to compress into the inside of the shower
pipe, resulting in leakage around the connector. If this occurs, unscrew the
chrome inlet collar from pipe, reinstall the washer and reconnect the shower pipe.
The initial surge of water will be discolored
with carbon nes and may soil your shower
stall. This carbonized water is benecial
to plants and the environment. It can be
discarded in a plant bed or down the drain.
Do NOT use a shower head or
wand with a shut-off valve.
5. Shower head attachment
Attach the shower head to the shower lter body. (Figure 3)
Now you are ready to enjoy the benets of showering in
healthy, chlorine free water!
For best results, use the dual-action shower
head provided with this system.
Table of contents
