Hanover Lavallette LAVDN7PCSW-BLU User manual

HanoverOutdoorFurniture
IMPORTANT
Ifyouhaveanyproblemswiththisproduct(missingordamagedparts,assemblyissues,etc.),
PLEASEDONOTRETURNTOTHERETAILER/STORE
fromwhereyoupurchasedtheproduct.
PleasecallourToll‐FreeCustomerServiceHotlineat:1‐866‐851‐8438
Between9:00AMand5:00PMEasternTime,MondaythroughFriday
Orvisitourwebsiteat:www.hanover‐products.com
Toexpediteanyfuturewarrantyclaims,pleaseretaintheInstructionSheet,Warranty
Cardandreceiptforfutureuse.
For additionalon‐linesupportonassembly,troubleshootingandcare&maintenanceofyouroutdoor
furniture,pleasevisitourwebsiteat:www.hanover‐products.com.
6/1/2015(b)

1-866-851-8438
Page 1 of 7
Patio Dining Table

Page 2 of 7
STOP
To expedite any future warranty claims, please retain the instruction sheet, warranty,
and receipt for future use.

Page 3 of 7
Manufacturer reserves the right to disclaim liability for any aspect of installation
and any resulting inconvenience caused by a defective part of a component.

Page 4 of 7

Page 5 of 7

Page 6 of 7

Page 7 of 7

Swivel Dining Chair
Owner's Manual
If you have any problems with this product, DO NOT RETURN IT TO THE STORE
CALL OUR CUSTOMER SERVICE HOT-LINE AT
1-866-851-8438
Between 9 A.M. - 5 P.M. Eastern Time, Monday through Friday
Page 1 of 7

Page 2 of 7

Page 3 of 7

Page 4 of 7

PART# DESCRIPTION PICTURE QTY
AChair Frame 1
BT Rocker 1
CBase 1
DSteel Panel 4
ESeat Cushion 1
FBack Cushion 1
AA Bolt M8 x 45mm 4
BB M8 Washer 8
CC M8 Spring Gasket 4
DD M8 Nut 4
EE M8 Bolt Cover 4
FF Bolt Cover For M8 Nut 4
GG Open Wrench 1
PARTS LIST
Page 5 of 7

Assembly Steps:
Note: Do not fully tighten bolts until assembly is completed and alignment is correct.
Step 1. Carefully place the chair frame (A) upside down on a non-abrasive surface.
Assemble the T rocker(B) to the chair frame(A) with steel panel(D) and Bolts(AA) and
Washer(BB) and M8 Spring gasket (CC) and M8 Nut(DD) by using open wrench(GG),
then cover the bolts with bolt covers (EE and FF) as shown in Figure 1.
Figure 1
Step 2. Place the chair frame (A) into the base( C ) as shown in Figure 2 .
Figure 2
Page 6 of 7

Step 3. Put seat cushion( E ) and back cushion ( F ) in chair.
Your chair is now ready to use. (Figure 3).
Figure 3
Page 7 of 7