Hanover Denver DEN3PC-TAN User manual

Page 1of 5

Page 2of 5
ASSEMBLY INSTRUCTIONS
Denver 3pc Seating Set
Please read through these instructions before beginning assembly.
-Clear out the space for assembly and lay out all parts based on parts list. Extra room will allow you to
easily determine if all the pieces are present.
-Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or
hardware.
-Keep small parts and pieces away from children until fully assembled.
-Do not fully tighten the screws until all have been inserted and hand tightened.
-Check for any loose screws and tighten them before use.
-Do not stand or jump on the chair or table as it may cause injury.
-Weight limit of chair: 250lbs

Page 3of 5
ASSEMBLY FOR CHAIR
PARTS LIST (Quantities listed for one chair)
STEP-BY-STEP ASSEMBLY
Tighten all the bolts using Allen Key (I). Repeat the steps for second chair.

Page 4of 5
ASSEMBLY FOR TABLE
PARTS LIST
Table Top 1pc
Table Leg 4pcs
Connector Ring 1pc
Bolt 4pcs
Washer 8pcs
A
B
C
D
E
Nut 4pcs
Allen Key 1pc
Wrench 1pc
Screwdriver 1pc
Tapping Screw 4pcs
F
G
H
I
J
STEP-BY-STEP ASSEMBLY
Tool used: Screwdriver (I)
Tool used: Allen Key (G) & Wrench (H)

Page 5of 5