Hans Grohe AXOR Citterio 39453 1 Series Installation guide

Installation Instructions / Warranty
Citterio
39453XX1
+
2
7
+
2
7
+
2
7
+
2
7
&
2
/
'
&
2
/
'
&
2
/
'
&
2
/
'
90501301 7/2004

Axor Citterio four-hole roman tub set
39453XX1
Technical Data
Flow rate @ 45 psi 6.0 gpm per side
Handshower 2.5 gpm max.
Maxim m water press re 145 psi
Recommended water press re: 14.5 - 75 psi
Recommended hot water temp.: 120oF - 140oF*
*Some municipalities limit the maximum water temperature from the water heater to 120o or
below. lease know and follow all applicable local codes when setting the temperature on the
water heater.
Installation Considerations
•Roman t b ro gh 13444181m st be installed, and the finished deck
s rface m st be complete before this trim kit can be installed.
•Backflow preventer cartridge 94146000 is incl ded with this kit, and
m st be sed to provide protection from back siphonage. It is already
installed on the 94148000 inner Sec -flex hose.
The 13444181 roman tub rough is listed by IAPMO.


Installation Instructions
The water supply must be turned o at the main prior to
installation o this kit.
•Remove the plastic plaster shields from
the valves and the spo t tee. Use a
phillips head screwdriver to remove the
screws from the white plastic handle
snap connectors. Remove the snap
connectors.
•P ll pward on the handshower holder
plaster shield. P ll the o ter Sec -flex hose
completely away from the deck. Unscrew
the white plastic winged n t from the
bottom of the Sec -flex hose. P t the o ter
hose away in a safe location. Be ex-
tremely caref l to prevent the high press re
hose from falling back beneath the t b.
•Remove the brass pl g from the end of
the high press re hose. Attach the
chrome inner Sec -flex hose. Use the
enclosed Hansgrohe Color towelette to
clean and l bricate the inner hose.
Have a co-worker se the towelette to
clean and l bricate the ends of the
o ter hose. If the towelette is missing,
se a soft cloth sprayed with a silicon
l bricant.

•Disassemble the handshower holder as
shown in the diagram. Feed the inner
hose thro gh the o ter hose. Sec re
the o ter hose at the bottom with the
white plastic winged n t. Remove the
plaster shield. Compress the o ter
hose so that the hose end connection
can be grasped.
•Feed the hose end connection thro gh
the handshower holder. Snap the two
halves of the white plastic retainer over
the inner hose. Slide the finished hose
retaining ring over the end of the hose
and the white plastic hose retainer.
Screw it into the handshower holder.
•Lower the handshower holder onto the
handshower tee, feeding the hose assembly
nder the t b. The hole on the rear of the
handshower holder sho ld go over the
positioning pin on the handshower holder
tee.Install the handshower holder esc tcheon
over the handshower holder. Screw it down
over the tee.

•Screw the s b-esc tcheon rings onto the
hot and cold valves..
•Press the hot and cold esc tcheons over
the s b-esc tcheon rings.
•Inspect the handles, making s re that they
are aligned properly.
•If the handle is not straight, remove it from the valve
by grasping the barrel and t rning it co nter
clockwise.
+
2
7
+
2
7
+
2
7
+
2
7
&
2
/
'
&
2
/
'
&
2
/
'
&
2
/
'
+
2
7
+
2
7
+
2
7
+
2
7
&
2
/
'
&
2
/
'
&
2
/
'
&
2
/
'
•Use a phillips head screwdriver to loosen the screw
inside the handle assembly 3 complete t rns clockwise.

+
2
7
+
2
7
+
2
7
+
2
7
•P ll pward on the lever to remove it.
T rn it approximately 60o. Reinsert it.
Tighten the screw.
•Reinstall the handle.
•Place the spo t over the diverter
assembly. Insert the diverter knob and
tighten. Tighten the set screw, sing the
enclosed 3 mm allen wrench.
+
2
7
+
2
7
+
2
7
+
2
7
&
2
/
'
&
2
/
'
&
2
/
'
&
2
/
'
+
2
7
+
2
7
+
2
7
+
2
7
&
2
/
'
&
2
/
'
&
2
/
'
&
2
/
'

•P ll o tward on the inner Sec -flex
hose. Install a screen washer in the
hose end connector. Install the
handshower.
•G ide the handshower back into the
handshower holder.
+
2
7
+
2
7
+
2
7
+
2
7
&
2
/
'
&
2
/
'
&
2
/
'
&
2
/
'
User Instructions
•T rn the left handle to obtain hot water, the right handle to obtain cold
water.
•When the water comes on, it will come thro gh the spo t. P ll the
diverter lever p to divert the water to the handshower. When the
water is t rned off, the diverter will a tomatically reset to the spo t
position.
Troubleshootin

Replacement Parts
1 handle 39292XX0
2 hot escutcheon
3 sub-escutcheon
4 cold escutcheon
5 spout
6 diverter knob 96774XX0
7 aerator
8 spout escutcheon
9 diverter
10 handshower holder
11 handshower holder escutcheon
12 inner ecuflex hose 94148000
13 backflow preventer cartridge 94146000
14 screen washer
15 Uno handshower 38850XX1
XX = color
00 = chrome
42 = platinum

Cleanin Recommendation for Hans rohe Products
Modern faucetry and shower products utilize a combination of materials to comply with the needs of
the market with regard to design and functionality.
To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper
treatment is not covered under the Hansgrohe warranty.
Cleaning Materials for Faucets and Showers
•To remove lime scale, use only products made specifically for that purpose. Always follow the
manufacturers instructions when using.
•Do not use cleaners that contain hydrochloric, formic, acetic, or phosphoric acids, as these
will cause considerable damage to finishes and to plastic components.
•Never mix cleaning materials.
•Never use cleaners containing abrasives. Do not use abrasive cleaning cloths, pads, or
sponges.
Cleaning Procedures
•Clean your faucets and shower products as and when required. Regular cleaning will prevent
scale buildup and water spotting.
•Follow the label instructions. Do not allow any cleaner to remain on the product for longer
than necessary.
•When using spray cleaners, spray first onto a sponge or cloth  do not spray directly onto the
product.
•After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
Important
•oap and shampoo residue can also cause damage to the product. Rinse well with clean
water after use.
•If the surface is already damaged, harsh cleaning materials will cause further damage.
Limited Lifetime Consumer Warranty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc.
(Hansgrohe). This warranty is limited to Hansgrohe products which are purchased by a consumer in the nited
States after March 1, 1996, and installed in either the nited States or Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against
defects in material or workmanship as follows: Hansgrohe will repair at no charge for parts only or, at its option,
replace any product or part of the product which proves defective because of improper workmanship and/or
material, under normal installation, use, service and maintenance. If Hansgrohe is unable to provide a
replacement and repair is not practical or cannot be timely made, Hansgrohe may elect to refund the purchase
price in exchange for the return of the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following
two sentences. If you are a consumer who purchased the product for use primarily for personal, family, or
household purposes, this warranty extends for as long as you own the product and the home in which the product
is installed. If you purchased the product for use primarily for any other purpose, including, without limitation, a
commercial purpose, this warranty extends only (i) for 1 year, with respect to Interaktiv and Retroaktiv products,
and (ii) for 5 years, with respect to AXOR, ShowerPower and Pharo products.