Hans Grohe Axor Uno 38020XX1 User manual

Axor Uno
38020XX1
Axor Uno
38210XX1
Axor Uno
38025XX1
Installation Instructions / Warranty

2
Installation Considerations
For best results, Hansgrohe
recommends that this unit be
installed by a licensed, profes-
sional plumber.
Please read over these instruc-
tions thoroughly before begin-
ning installation. Make sure that
you have all tools and supplies
needed to complete the instal-
lation.
•
•
Technical Information
Recommended water pressure 14.7 - 72.5 psi
Max. water pressure 145 psi
Recommended hot water temp. 120° - 140° F*
Max. hot water temp 176° F*
Hole size in mounting surface 1 3/8"
Max. mounting surface depth 1 3/8"
Flow rate – lavatory 1.5 gpm
Flow rate – bidet 2.2 gpm
Cartridge with high temperature limit stop
3/8" supply hoses
*Please know and follow all applicable local plumbing codes when
setting the temperature on the water heater.
Uno Single-control Lavatory Faucet 38020XX1
Uno Single-control Tall Lavatory Faucet 38025XX1
Uno Single-control Bidet Faucet 38210XX1
38020XX1 38210XX138025XX1

3
Installation
Place the faucet and sealing ring on the mounting
surface.
Install the friction washer, metal washer, and mounting
nut.
Tighten the mounting nut by hand.
Check the position of the faucet. When satisfied, use
a slot-headed screwdriver to tighten the tensioning
screws.
Connect the hot and cold supply lines to the stops.
Use two wrenches, as shown in the
diagram, to prevent hose twisting.
Install the drain.
Set the high temperature limit stop (optional).
Turn on the water and check all connections for leaks.
Install the drain pull
rod.

4
Set the high temperature limit stop (optional)
Remove the screw cover, located on the back of the
handle.
Use a 4 mm allen wrench to loosen the screw.
Remove the handle
Remove the flange and the green high temperature limit
stop ring.
Install the high temperature limit stop ring so that the
black positioning pin is in the notch corresponding to
the desired high temperature.
The temperatures shown in the diagram assume an
incoming cold water temperature of 50°F and an
incoming hot water temperature of 140°.
Center and replace the flange.
Replace the handle.
Tighten the screw.

5
Install the pop-up drain
Attach the swivel connector to the end of the
horizontal rod.
Attach the swivel connector to the end of the
pull rod. Position as desired and tighten with a
small, flat bladed screwdriver.
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
Unscrew the tailpiece from the tee. Wrap the
threads with Teflon tape and replace.
Install the white, flexible sealing gasket to the
flange. Place it in the sink outlet.
Install the black mack gasket, white friction ring
and retainer nut on the flange.
Do not tighten the nut against the bottom of the
sink at this time.
Thread the tee and tailpiece to the flange. The
pivot must face the faucet. Turn the drain assem-
bly if necessary.
Tighten the retainer nut.
Place the plunger assembly in the drain.
Install the horizontal rod so that the end goes
through the loop in the bottom of the plunger.
Install and hand tighten the pivot ball nut.

6
Replacement Parts
1 handle 38094XXX
1.1 screw cover 96762000
1.2 set screw 96029000
2 flange 96763XXX
3 nut 97209000
4 cartridge 96764000
5 seal 95008000
6 aerator 97370XXX
7 fixing set 13961000
8 pull rod 96657000
9 ball joint 96050XXX
10 aerator 94005XXX
11 supply hose – 470 mm
supply hose – 900 mm
XX = colors
00 = chrome
82 = brushed nickel
User Instructions
Pivot the handle back to turn the water on, and forward to turn the water off.
Pivot the handle to the left to make the water warmer, to the right to make the water cooler.
1
2
3
4
5
6
7
8
9
10
1.1
1.2
11

7
Limited Lifetime Consumer Warranty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”).
This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1,
1996, and installed in either the United States or Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only. This warranty is non-transferable.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in
material or workmanship as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any
product or part of the product that proves defective because of improper workmanship and/or material, under normal
installation, use, service and maintenance. If Hansgrohe is unable to provide a replacement and repair is not practical
or cannot be timely made, Hansgrohe may elect to refund the purchase price in exchange for the return of the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two
sentences. If you are a consumer who purchased the product for use primarily for personal, family, or household
purposes, this warranty extends for as long as you own the product and the home in which the product is originally
installed. If you purchased the product for use primarily for any other purpose, including, without limitation, a commer-
cial purpose, this warranty extends only (i) for 1 year, with respect to Hansgrohe and Commercial products, and (ii) for
5 years, with respect to AXOR products.
Cleaning Recommendation for Hansgrohe Products
Modern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply with the needs of
the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain
criteria when cleaning.
Cleaning Materials for Faucets and Showers
Acids are a necessary ingredient of cleaning materials for removing lime, however please pay attention to the follow-
ing points when cleaning faucets and showers:
Only use cleaning materials which are explicitly intended for this type of application.
Never use cleaning materials which contain hydrochloric, formic, phosphoric, or acetic acid, as they cause
considerable damage.
Never mix one cleaning material with another.
Never use cleaning materials or appliances with an abrasive effect, such as unsuitable cleaning powders, sponge
pads, or micro fiber cloths.
Cleaning Instructions for Faucets and Showers
Please follow the cleaning material manufacturer’s instructions. In addition, pay attention to the following points:
Clean the faucets and showers as and when required
Use the amount of cleaning product and the amount of time recommended by the manufacturer. Do not leave the
cleaner on the fixture longer than necessary.
Regular cleaning can prevent calcification.
When using spray cleaners, spray first onto a soft cloth or sponge. Never spray directly onto the faucet as drop-
lets can enter openings and gaps and cause damage.
After cleaning, rinse thoroughly with clean water to remove any cleaner residue.
Important
Residues of liquid soaps, shampoos, and shower foams can also cause damage, so rinse with clean water after using.
Please note: if the surface is already damaged, the effect of cleaning materials will cause further damage.
Components with damaged surfaces must be replaced or injury could result.
Damage caused by improper treatment is not covered under the warranty.
•
•
•
•
•
•
•
•
•

Hansgrohe, Inc. •1490 Bluegrass Lakes Parkway •Alpharetta, GA 30004
Tel. [phone] •Fax [phone]
www.hansgrohe-usa.com
US - Installation Instructions •Part No. 90540404 •Revised 04/2009
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from (1) normal wear and tear, improper installation, improper
maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning
agents or “no-rinse” cleaning products, or the use of the product in any manner contrary to the product instruc-
tions. (3) Conditions in the home such as excessive water pressure or corrosion.
C. Labor or other expenses for the disconnection, deinstallation, or return of the product for warranty service, or for
installation or reinstallation of the product (including but not limited to proper packaging and shipping costs), or
for installation or reinstallation of the product.
D. Accessories, connected materials and products, or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY PARTS OR INFORMATION
Contact your Hansgrohe retailer, or contact Technical Service at:
Hansgrohe Inc.
1492 Bluegrass Lakes Parkway
Alpharetta GA 30004
Toll-free [phone].
In requesting warranty service, you will need to provide
1. The sales receipt or other evidence of the date and place of purchase.
2. A description of the problem.
3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe
Inc. 1492 Bluegrass Lakes Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by
Hansgrohe.
When warranty service is completed, any repaired or replacement product or part will be returned to you postage
prepaid.
EXCLUSIONS AND LIMITATIONS
REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED
UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES
NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH
THIS PRODUCT.
HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR
CONSEQUENTIAL DAMAGES, ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY
(INCLUDING MERCHANTABILITY).
Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation
or exclusion may not apply to you. This warranty gives you specific legal rights, and you may have other rights which
vary from State to State. You may be required by law to give us a reasonable opportunity to correct or cure any failure
to comply before you can bring any action in court against us under the Magnuson-Moss Warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible
defect. Prior to installing, always carefully study the enclosed instructions on the proper installation and the care and
maintenance of the product. If you have questions at any time about the use, installation, or performance of your
Hansgrohe product, or this warranty, please call or write to us or call us toll-free at 800 334 0455.