Hans Grohe Metropol Select 110 32571007 Manual

INSTALLATION
ZH 用户手册/组装说明 2
EN Instructions for use / assembly instructions 3
Lesezeichen
中文 2
English 3
Lesezeichen
Metropol Select 110
32571007

2
中文
安装 (参见第页4)
安全技巧
装配时为避免挤压和切割受伤，必须戴上手
套。
本产品只允许作为洗浴、卫生和洁身之用。
冷热水管间过大的压力差必须予以平衡。
安装提示
• 安装前必须检查产品是否受到运输损害。安装
后将不认可运输损害或表面损伤。
• 管道和阀门必须根据通用标准进行安装、冲洗
和检查。
• 请遵守当地国家现行的安装规定。
• 只能按规定使用溢流阀。禁止将半露柱及其他
部件固定到溢流阀上。
• 如果使用即热式热水器时出现问题，或要求更
大的水流量，可以把位于水波器后面的
EcoSmart®(流量限制器)拆除。
技术参数
本龙头配有 EcoSmart® (流量限制器)
工作压强： 最大1MPa
推荐工作压强： 0,1-0,5MPa
测试压强： 1,6MPa
(1MPa=10bar=147PSI)
热水温度： 最大70°C
推荐热水温度： 65°C
热力消毒: 最大70°C/4分钟
该产品专为饮用水设计！
符号说明
请勿使用含有乙酸的硅胶！
调节 (参见第页6)
热水温度调节。如果使用即热式喷头，则不建议
安装热水阀门。
大小 (参见第页8)
流量示意图 (参见第页8)
带有EcoSmart®
无EcoSmart®
备用零件 (参见第页12)
保养 (参见第页9)
单向阀必须在符合国家或当地的法律的情况下按
照EN806-5定期检查(至少一年一次)。
清洗 (参见第页10)
操作 (参见第页5)
• 汉斯格雅建议，清晨或在水流长时间停滞后，
前半升水不作饮用水使用。
问题 原因 补救
龙头出水量小 - 水压不足 - 检查总水压
- 过滤网有垃圾堵塞 - 清洗过滤网/更换过滤网
串水，在龙头关闭的状态下，热
水被强迫流入冷水管路，或者相
反。
- 单向阀有垃圾堵塞或漏水 - 清洗单向阀，如有必要则更换
新的
燃气热水器不工作 - 过滤网有垃圾堵塞 - 清洗过滤网/更换过滤网
- 单向阀装反 - 正确安装单向阀
- 水压不足 - 移除流量限制器
阀门不灵活/泄漏 - Select停止阀损坏/脏污 - 更换Select停止阀
- 错误插接温度限制器 - 重新插接温度限制器
(参见第页6)

3
English
Assembly (see page 4)
Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal
pressures.
Installation Instructions
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The drain valve must only be used as intended. It is
not allowed to attach other objects to the drain
valve, for example a semi-pedestal.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart®
(flow limiter) located behind the aerator can be
removed.
Technical Data
This mixer series-produced with EcoSmart®
(flow limiter)
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 70°C
Recommended hot water temp.: 65°C
Thermal disinfection: max. 70°C / 4 min
The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
Adjustment (see page 6)
To adjust the hot water limiter. Using a hot water limiter
in combination with a continuous flow water heater is
not recommended.
Dimensions (see page 8)
Flow diagram (see page 8)
 with EcoSmart®
 without EcoSmart®
Spare parts (see page 12)
Maintenance (see page 9)
The check valves must be checked regularly according
to EN 806-5 in accordance with national or regional
regulations (at least once a year).
Cleaning (see page 10)
Operation (see page 5)
• Hansgrohe recommends not to use as drinking water
the first half liter of water drawn in the morning or
after a prolonged period of non-use.
Fault Cause Remedy
Insufficient water - Supply pressure inadequate - Check water pressure (If a pump
has been installed check to see if
the pump is working).
- Filters are dirty - Clean the filter / exchange filter
Crossflow, hot water being forced
into cold water pipe, or vice versa,
when mixer is closed
- Backflow preventers dirty or
leaking
- Clean backflow preventers,
exchange if necessary
Instantaneous heater didn’t work - Filters are dirty - Clean the filter / exchange filter
- check valve hasn't moved back - Exchange check valves
- Supply pressure inadequate - Remove flow limiter
Valve stiff / leaking - Select stop valve damaged /
soiled
- Exchange Select stop valve
- Temperature limiter plugged on
improperly
- Plug on the temperature limiter
once more (see page 6)

4
(3 Nm)
1.
2.
1 2
3 4
5 6
SW 10 mm
SW 19 mm
(4 Nm)
SW 24 mm
(4 Nm)
1.
2.
Montage

5
78
> 2 min
关 / close开 / open
热 / hot 冷 / cold
Montage/ Bedienung

6
2
3
1
4 5
60 °C
10 °C
6
35°C
39°C
43°C
47°C
57°C
60°C
0,3 MPa
Justierung/ Temperaturbegrenzer

7
7
8 9
(0,5 Nm)
最大 /
max.
至少/
min.
Justierung

8
Metropol Select 110 32571007
EcoSmart®
1
EcoSmart®
2
G3/8
Ø32
max. 40
512
48/48
203
2 0
°
136
150
113
G3/8
G1/2
Push-Open
50100007
4,5
0,0
0,5
1,0
1,5
2,0
2,5
3,0
3,5
4,0
5,0
bar
0,45
0,00
0,05
0,10
0,15
0,20
0,25
0,30
0,35
0,40
0,50
036912151821242730
MPa
00,1 0,2 0,3 0,4 0,5
Q = l/min
Q = l/sec
Maße / DurchflussdiagrammMaße

9
SW 10 mm
SW 19 mm
1 2
3 4
5
SW 19 mm
(4 Nm)
SW 10 mm
Wartung

10
•
•
•
•
•
•
•
•
•
•
•
Hansgrohe
Hansgrohe
www.hansgrohe-int.com/guarantee
QuickClean
QuickClean
⁄
⁄
⁄
⁄
⁄
⁄
⁄
⁄
⁄
⁄
⁄
Hansgrohe
Hansgrohe
www.hansgrohe-int.com/guarantee
QUICKCLEAN
QuickClean
QUICK
CLEAN
Reinigung