Hans Grohe Talis M52 260 1jet Manual

ZH 用户手册/组装说明 2
EN Instructions for use / assembly instructions 3
Lesezeichen
中文 2
English 3
Talis M52 260 1jet
14872007
Talis M52 220 2jet
14877007

2安装 (参见第页 4)
中文
安全技巧
装配时为避免挤压和切割受伤，必须戴上
手套。
冷热水管间过大的压力差必须予以平衡。
安装提示
• 安装前必须检查产品是否受到运输损害。
安装后将不认可运输损害或表面损伤。
• 管道和阀门必须根据通用标准进行安装、冲
洗和检查。
• 请遵守当地国家现行的安装规定。
技术参数
工作压强： 最大1MPa
推荐工作压强： 0,1-0,5MPa
测试压强： 1,6MPa
(1MPa=10bar=147PSI)
热水温度： 最大70°C
推荐热水温度： 65°C
热力消毒: 最大70°C/4分钟
该产品专为饮用水设计！
符号说明
请勿使用含有乙酸的硅胶！
调节 (参见第页6)
热水温度调节。如果使用即热式喷头，则不建
议安装热水阀门。
保养 (参见第页7)
单向阀必须在符合国家或当地的法律的情况下
按照EN806-5定期检查(至少一年一次)。
清洗 (参见第页7)
大小 (参见第页12)
流量示意图 (参见第页13)
普通水流
花洒
备用零件 (参见第页14)
操作 (参见第页10)
• 汉斯格雅建议，清晨或在水流长时间停滞
后，前半升水不作饮用水使用。
• 通过手柄打开阀门时出水口可能流出少量
水。
问题 原因 补救
龙头不灵活 - 阀芯损坏，结垢 - 更换阀芯
龙头滴水 - 阀芯损坏 - 更换阀芯
水从螺纹底座中流出 - 连接软管没有完全旋入基体 - 用手拧紧连接软管
- 连接软管的O形环损坏 - 更换O形环
热水温度过低 - 温度限制器设置错误 - 设置温度限制器

3
Assembly (see page 4)
English
Safety Notes
Gloves should be worn during installation to
prevent crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.
Installation Instructions
• Prior to installation, inspect the product for
transport damages. After it has been installed, no
transport or surface damage will be honoured.
• The pipes and the fixture must be installed,
flushed and tested as per the applicable
standards.
• The plumbing codes applicable in the respective
countries must be observed.
Technical Data
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 70°C
Recommended hot water temp.: 65°C
Thermal disinfection: max. 70°C / 4 min
The product is exclusively designed for drinking
water!
Symbol description
Do not use silicone containing acetic acid!
Adjustment (see page 6)
To adjust the hot water limiter. Using a hot water
limiter in combination with a continuous flow water
heater is not recommended.
Maintenance (see page 7)
The check valves must be checked regularly
according to EN 806-5 in accordance with national
or regional regulations (at least once a year).
Cleaning (see page 7)
Dimensions (see page 12)
Flow diagram (see page 13)
 Normal spray
 Regular
Spare parts (see page 14)
Operation (see page 10)
• Hansgrohe recommends not to use as drinking
water the first half liter of water drawn in the
morning or after a prolonged period of non-use.
• Minor leaking may occur briefly at the spout
when opening the fitting via the lever.
Fault Cause Remedy
Mixer stiff - Cartridge defective, calcified - Exchange cartridge
Mixer dripping - Cartridge defective - Exchange cartridge
Water escaping at the threaded
base
- connection hoses not completely
screwed into basic body
- Tighten connection hoses by
hand
- O-ring at the connection hose
defective.
- Exchange O-ring
Hot water temperature too low - Hot water limiter incorrectly set - Set hot water limiter

4
max. 35 mm
max.60 mm
(3 Nm)
SW 10 mm
SW 24 mm
(4 Nm)
CLICK
2. 3.
1.
1b
1a 2
3 4
5 6
Montage

5
80
(1 Nm)
> 2 min
7 8
910
11 12
Montage

0,3 MPa
60 °C 10 °C
+
+
21 3
4
6 7
4.
3.
1.
2.
3.
1.
2.
6 x
5
36°C
38°C
43°C
50°C
55°C
60°C
17 x
SW 4 mm
SW 4 mm
SW 4 mm
SW 4 mm
(5 Nm)
6
Justierung

7
14872007 14877007 21a 1b
1 2
WartungReinigung Wartung

8
•
•
•
•
•
•
•
•
•
•
•
Hansgrohe
Hansgr
ohe
www.hansgrohe-int.com/guarantee
QuickClean
QuickClean
QUICK
CLEAN
Reinigung

9
English
Cleaning Recommendation for Hans-
gro
he Products
T
oday, modern sanitary and kitchen tapware,
sh
owers, accessories, washstands, tubs and radiators
consist of
very different materials to comply with the
needs of the mar
ket with regard to design and
functionalit
y.
To
avoid damage and reclamations, it is necessary to
consider cer
tain criteria when cleaning.
Wi
th regard to caring for the Hans-
gro
he products, the following must in
principle be heeded:
• Only use cleaning material which is explicitly
provided for this type of application.
• Never use cleaning materials, which contain
hydrochloric acid, formic acid, chlorine pale lye
or acetic acid, as they cause considerable
damage.
• Phosphorus acidic cleaners are only conditionally
applicable.
• Mixing cleaning agents is not permitted, generally.
• Never use cleaning materials or appliances with
an abrasive effect, such as unsuitable cleaning
powders, sponge pads or micro fibre cloths.
• The instructions of the cleaning agent manufactur-
ers have to be followed absolutely.
• Cleaning has to be carried out with a specified
cleaner dosage, contact time, object-related and
adapted to the needs.
• The building up of calcifications has to be
removed by cleaning regulary.
• When using spray cleaners, spray the cleaning
solution onto a soft cloth or sponge, never directly
onto the Hansgrohe products, as the atomised
spray could enter openings and gaps in the
Hansgrohe products and cause damage.
• After cleaning rinse thoroughly with clean wa
ter to
remove any cleaner residue.
• The use of steam cleaners is not permitted. The
high temperatures can damage the products.
Important
Residues of toiletries such as liquid soaps, shampoos
and shower gels, hair dyes, perfumes, aftershave
and
nail varnish can also cause damage.
Here too: Carefully rinse with water after use to
remove residues.
Likewise, do not store any cleaning agents or
chemicals under the products, for example in a vanit
y
unit, as the vapours may damage the products.
The damage of already damaged surfaces will
deteriorate under the effect of the cleansers.
Components with damaged
surfaces must be exchanged,
otherwise there could be an injury
danger.
Damage caused by improper treatment will not be
covered by our guarantee.
Warranty
Hansgrohe guarantees to the consumer that this
product is free of production faults. If evertheless any
defect is detected within 5 years from date of
purchase, Hansgrohe will remedy this defect free of
charge. Y
ou will find the conditions and details of this
guarantee at www.hansgrohe-int.com/guarantee.
Please contact your contracting party to claim your
rights under this guarantee. This guarantee does not
affect the customer‘s rights under the respective
national legislation.
QuickClean
The QuickClean cleaning function only needs a small
manual rub over to remove the lime scale from the
spray channels.
QUICK
CLEAN

10
开 / open
热 / hot 冷 / cold
关 / close
1.
2.
Bedienung

11
1 2
3 4
1. 2.
Bedienung

Talis M52 260 1jet
14872007
Talis M52 220 2jet
14877007
12
G 1/2
132
Ø 34
855
max. 60
G 1/2
ca. 500
177
150°
Maße

Talis M52 260 1jet
14872007
Talis M52 220 2jet
14877007
13
bar
4,5
0,0
0,5
1,0
1,5
2,0
2,5
3,0
3,5
4,0
5,0
0,45
0,00
0,05
0,10
0,15
0,20
0,25
0,30
0,35
0,40
0,50
5,50,55
6,00,60
036912151821242730
MPa
00,1 0,2 0,3 0,4 0,5
Q = l/min
Q = l/sec
1
2
bar
4,5
0,0
0,5
1,0
1,5
2,0
2,5
3,0
3,5
4,0
5,0
0,45
0,00
0,05
0,10
0,15
0,20
0,25
0,30
0,35
0,40
0,50
5,50,55
6,00,60
036912 15 18 21 24 27 30
MPa
00,1 0,2 0,3 0,4 0,5
Q = l/min
Q = l/sec
1
2
Durchflussdiagramm

Talis M52 260 1jet
14872007
14
95049000
95560000
96338000
95008000
98365000
95562000
88659000
93218000
95498000
92730000
97350000
(DIN-DVGW)
98212000
(41x2)
92500000
(400g)
95507000
(1500 mm)
97523000
98193000
(32x2)
97209000
(M37x1,5)
SW 30 mm
97735000
95140000
(M4x20)
95561000
(600 mm)
97489000
(900 mm)
13913000
(M24x1)
97827000
(8x1,75)
98422000
(7x1,5)
97548000
Serviceteile

Talis M52 220 2jet
14877007
15
98212000
(41x2)
95561000
(600 mm)
97489000
(900 mm)
95049000
95560000
96338000
95008000
98365000
95562000
96920000
95498000
92730000
94074000
92500000
(400g)
95507000
(1500 mm)
97523000
98193000
(32x2)
97209000
(M37x1,5)
SW 30 mm
97735000
95140000
(M4x20)
13913000
(M24x1)
97827000
(8x1,75)
98422000
(7x1,5)
97548000
Serviceteile

Hansgrohe · Auestraße 5 - 9 · D-77761 Schiltach · Telefon [phone] · Telefax +49 (0) 7836/511440
E-Mail: [email protected] · Internet: www.hansgrohe.com
06/2020 9.06379.52