Happy Beds Hagen Ottoman Bed User manual

Assembly Instructions
Hagen Ottoman Bed
www.happybeds.co.uk
Important before assembly: .
Health & Safety:
.
Read these instructions carefully before assembling or using the product.
Please check the contents of the boxes before attempting to assemble this product. The instructions will
have a checklist of parts and fittings.
Assemble the product as close to its intended final location/room as possible.
This product or some parts of this product will be heavy. Please use an assistant when lifting.
Please keep small parts out of reach of children.
Always use on a level, even surface.
DO NOT jump on the product or any of its parts.
DO NOT use this product if any parts are missing, damaged or worn.
DO NOT use this product unless all fixings are secured.
Further instructions are on the following pages.
Please keep these instructions for future reference.
Page 1 of 9

No Part List Qty Box
1 1 pc
2 1 pc
3 1 pc
4
5 1 pc
6 1 pc
7a
Side rail - LH
Side rail - RH
1 pc
7b
1 pc
Page 2 of 9
No Part List Qty Box
12
13 1 pc
Headboard
Footboard
Mattress base board support rails - end
Mattress base board support rails - centre
“U” shaped cross bar
1
11 1
1
1
1 pc
2
2
2
2
2
2
2
Gas-lift mechanism
Gas-lift mechanism
Gas-lift pistons 2pcs
2pcs
82
1 pc
91
1 pc
10 1 Mattress base board - Headend
Mattress base board - Footend
230822
Fabric base cover
1 pc
1
2
8
8
9
10
3
4
6
12 x2
11
7a
7b
5
13
‘L’ shape bracket

No Qty Box
4 pcs
12 pcs
6 pcs
26 pcs 2
Hardware List
HARDWARE NEEDED FOR BED ASSEMBLY (PACK A)
D
F
Allen key for
M8 bolts
B
A
C
No Qty Box
Hardware List
E1 pc
G
H
J
6 pcs
8 pcs
Plastic spacer for lift
mechanism (7a & 7b)
Flat washer for M8 bolts
Flanged M8 lock-nuts
Spanner for flanged
M8 lock-nuts
Bolt (M8x20mm) for
fitting angle bracket (B)
to headboard and footboard
Bolt (M8x35mm) for
fitting angle bracket (B)
to headboard and footboard
Bolt (M8x35mm) for
fitting ‘U’ shape cross bar
to side rails (3&4)
2
2
2
2
2
2
4 pcs
1 pc
2
2
Angle bracket
Page 3 of 9
WARNING
TO AVOID ACCIDENTS
To access the storage area, the ottoman frame
MUST BE FULLY OPENED and then
FULLY CLOSED afterwards.
CAUTION
To be operated by ADULTS ONLY.
Keep children and pets away from the storage area.
Avoid trapping your fingers by using the handle
to lift & lower the base.
Only lift when the mattress is in place.
Ensure the ottoman support bar is secure when the
base is open.
Regularty air internal storage area and contents.
!
Note: Be very careful what you
store under the bed -the top of
an item, like a suitcase or a box
must not touch the slats or they
may be damaged. Maximum
storage height is 310mm .

Step 1:
Step 2:
Page 4 of 9
Angle bracket
B 4 pcs
Bolts (M8x20mm)
Bolts (M8x20mm) Bolts (M8x35mm)
A 8 pcs
E
3
1
1
2
3
3
&
4
4
Allen key for
M8 bolts 1 pc
B
A x2
C x2
EAllen key for
M8 bolts 1 pc
A
B
B
4 pcs 4 pcs
C
4
2
A x2

Bolts (M8x35mm)
A x2
C x4
H x2
G x4
D
F
Step 3:
Step 4:
Page 5 of 9
4 pcs
1 pc
8 pcs
EAllen key for
M6 bolts 1 pc
C8 pcs
D 4 pcs
Bolts (M8x20mm) Bolts (M8x35mm)
A 2 pcs
FAllen key for
M8 bolts 4 pcs
EAllen key for
M8 bolts 1 pc
6
4
3
4
5
&
3
Make certain the bed is
squared up as shown
in the diagram then
tighten all bed
assembly bolts 100%.
G
H
J
Plastic spacer for lift
mechanism (7a & 7b)
Flanged M8 lock-nuts
Spanner for flanged
M8 lock-nuts
7b
&
7a
8

10
7a
7a
7b
7b
Step 5:
Step 6:
Page 6 of 9
9
Turn bed on its side and
paste non woven fabric
to the bottom of the bed.
D 1 pc
Bolts (M8x20mm)
A 4 pcs
FAllen key for
M8 bolts 1 pc
EAllen key for
M8 bolts 1 pc
Bolts (M8x35mm)
A
D
F
10
12
12
A
7b

11
11
10
7b
13
13
11
A
A
Step 7:
Page 7 of 9
Bolts (M8x20mm)
A 6 pcs
EAllen key for
M8 bolts 1 pc
A
A
10
11

Step 8:
Page 8 of 9
D 1 pc
Bolts (M8x20mm)
A 2 pcs
FAllen key for
M8 bolts 1 pc
EAllen key for
M8 bolts 1 pc
Bolts (M8x35mm)
D
F
11
11
12 12
A
7b

Page 9 of 9
60
L
W
H
310
Floor to top
of side rail
10
330
Floor to top of the
mattress base
www.happybeds.co.uk
General Care & Maintenance
Please dispose of all packaging safely.
Wipe clean with a slightly damp cloth.
Avoid the use of all household cleaners and abrasives.
Periodically check all screw & fixings to ensure they are secure.
When moving your product, carefully lift into place. Never drag or push the product across the floor as
this will cause damage to the joints. If the product is used on hard flooring, such as wood or laminated
floor, you must place some protection under the legs to stop the product from moving. If this is not
adhered to, it could result in failure to the product that will invalidate the warranty.
For more information on cleaning and product care visit:
https://www.happybeds.co.uk/help-and-advice
In the unlikely event that you have problems putting this product together or have damaged or
missing parts, please contact us by visiting:
https://www.happybeds.co.uk/customer-service
Notes
Technical Specifications
Overall Dimensions (LWH mm)
Internal Dimensions (LWH mm)
Double: 1900 x 1330 x 310
King: 2000 x 1480 x 310
Double: 2010 x 1380 x 1140
King: 2110 x 1530 x 1140
Ottoman Piston Strength
:gniK&elbuoD 900N