Harman Kardon THE BRIDGE IIIP User manual

THE BRIDGE IIIP
Docking station for iPod and iPhone
Owner’s Manual
iPhone not included
ENGLISH

THE BRIDGE IIIP
2
080-1479 / ( 0245CSK - 15/Sep/2011 )
Table of Contents
INTRODUCTION 3
FEATURES 3
INCLUDED ITEMS 3
COMPATIBILITY 3
INSTALLING 4
CHARGING THE IPOD OR IPHONE 5
UNDOCKING THE IPOD OR IPHONE 5
TROUBLESHOOTING 5
SPECIFICATIONS 5

3
THE BRIDGE IIIP
ENGLISH
Introduction, Features, Included Items and Compatibility
Introduction
Congratulations! With The Bridge IIIP, you are entering the new world of entertainment
made possible by combining the incredible storage capacity and playback flexibility of an
iPod or iPhone with the sonic power of your harman kardon system.
With a single cable, your iPod or iPhone is connected, and all you need is your remote
control to get started!
Features
Single connection to a The Bridge IIIP-ready harman kardon product•
Plays content from a compatible iPod or iPhone through your harman kardon•
system
Outputs high-definition video up to 720p from compatible iPod and iPhone models,•
when available on the device
Controls your iPod or iPhone, using the harman kardon remote•
Easy track selection with on-screen navigation•
Included Items
The Bridge IIIP docking station•
Five clear dock adapters, marked “NANO,” “5G (VIDEO 60GB),” “5G (VIDEO 30GB),”•
“13” and “12, 14”
Black insert marked “UNIVERSAL” to accept appropriate dock adapter•
Compatibility
At the time of the printing of this manual, The Bridge IIIP is compatible with the
harman kardon BDS 2, BDS 5, MAS 101, MAS 102 and MAS 111.
Made for iPod nano 5th generation, iPod touch 2nd generation, iPod classic, iPod nano 4th
generation, iPod touch 1st generation, iPod nano 3rd generation, iPod with video.
Made for iPhone 4, iPhone 3GS, iPhone 3G and iPhone.
Please check www.harmankardon.com for the latest compatibility information.
Video and photo playback requires iPod model supporting video browsing and a video-
capable harman kardon product.
Refer to the user manual of the compatible harman kardon product for information about
operation and capabilities.

THE BRIDGE IIIP
4
080-1479 / ( 0245CSK - 15/Sep/2011 )
Installation
Installing
With only a single cable connection, The Bridge IIIP is easy to connect to your harman
kardon product.
Step One: Turn off the harman kardon The Bridge IIIP-ready product, using its main power
switch.
Step Two: Holding the cable with the wider part of the connector at the bottom, gently
squeeze the tabs on each side as you insert it into the connector on the rear panel of the
harman kardon product. See Figure 1.
Figure 1 –
The Bridge IIIP connector
Step Three: Place the black insert in The Bridge IIIP, making sure to push it all the way
down. See Figure 2.
NOTE: Do not place an iPod or iPhone in The Bridge IIIP unless both the black insert and
a dock adapter are installed. Otherwise, the iPod or iPhone will not connect properly, and
both it and The Bridge IIIP may sustain damage that is not covered by the warranty.
Step Four: Locate the dock adapter that was included with your iPod or iPhone, or select
one of the included clear dock adapters by referring to Table 1. If your iPod or iPhone does
not appear in Table 1 and did not include an adapter, contact Apple Inc. to purchase one.
Place the adapter in The Bridge IIIP insert, as shown in Figure 2.
Step Five: Remove the iPod or iPhone from any case, and dock it in The Bridge IIIP, as
shown in Figure 2.
Figure 2 – Docking an iPod
or iPhone in The Bridge IIIP
Step Five
Step Four
Step Three
Table 1 – Select the Correct The Bridge IIIP Dock Adapter
The Bridge IIIP Insert iPod Model
NANO iPod nano, 1st generation
5G (VIDEO 60GB) iPod, 5th generation (60GB, 80GB) and iPod classic (160GB)
5G (VIDEO 30GB) iPod, 5th generation (30GB) and iPod classic (80GB)
13 iPod nano, 3rd and 4th generation
12, 14 iPod touch – install large bumper; iPhone 4,
iPhone 3GS, iPhone 3G, iPhone – install small bumper

5
THE BRIDGE IIIP
ENGLISH
Charging the iPod or iPhone, Undocking the iPod
or iPhone, Troubleshooting and Specifications
Charging the iPod or iPhone
You may leave your iPod or iPhone in The Bridge IIIP even when you are not using it as a
playback source. Whenever the iPod or iPhone is docked and your harman kardon product
is turned on, The Bridge IIIP will charge the battery in the iPod or iPhone.
Undocking the iPod or iPhone
We recommend that you pause playback before physically removing the iPod or iPhone
from The Bridge IIIP.
Troubleshooting
Symptom Solution
The iPod or iPhone does
not play or respond to
commands from the
harman kardon remote.
Make sure that The Bridge IIIP is properly•
connected to a compatible harman kardon
product.
Make sure that The Bridge IIIP is selected as the•
input on the harman kardon product.
Specifications
Dimensions (H x W x D): 1-3/16" x 4-1/2" x 4-1/2" (30mm x 114mm x 114mm)
Weight: 0.37 lb (0.17kg)

www.harmankardon.com
Harman Consumer, Inc.
8500 Balboa Boulevard, Northridge, CA 91329 USA
516.255.4545 (USA only)
Made in P.R.C.
© 2010 Harman International Industries, Incorporated. All rights reserved.
Features, specifications and appearance are subject to change without notice.
harman kardon is a trademark of HARMAN International Industries, Incorporated, registered in the United States
and/or other countries. The Bridge IIIP logo is a trademark of HARMAN International Industries, Incorporated.
iPod and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries. iPod and iPhone not
included. “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to
connect specifically to iPod or iPhone, respectively, and has been certified by the developer to meet Apple
performance standards. Apple is not responsible for the operation of this device or its compliance with safety
and regulatory standards.
Part No 950-0331-001
iPhone not included