Hasbro A4571 User manual

AGES 6+
A4571
Product and colors may vary.
© 2013 Lucasfilm Ltd. & ® or TM where indicated.
All rights reserved.
®* and/or TM* & © 2012 Hasbro.
All Rights Reserved. TM & ® denote U.S. Trademarks.
ANAKIN TO DARTH VADER
COLOR CHANGE LIGHTSABER
PRESS BUTTON TO
ACTIVATE: 2
TO REPLACE BATTERIES:
Replace demo batteries with alkaline batteries. Phillips/cross
head screwdriver (not included) needed to insert batteries.
Loosen screw in battery compartment cover (screw remains
attached to cover). Remove cover. Remove and discard demo
batteries. Replace with 3 x 1.5V AA alkaline batteries. Replace
cover and tighten screw.
x3 1.5VAA
ALKALINE BATTERIES REQUIRED
DEMO BATTERIES INCLUDED
®
BEFORE YOU BEGIN TO PLAY:
Move switch from “I” to “II” to activate full range of features.
1
Color-change feature:
POWER UP: Press and release
button. If this is the first time
you are powering up, or have
not powered up the Lightsaber
recently, the blade will be blue.
CHANGE TO RED: When
Lightsaber is on and blade is
blue, press and hold button to
change blade color to red
slowly, to show Anakin’s
struggle against the dark side.
CHANGE TO BLUE: When
Lightsaber is on and blade is
red, press and hold button to
change blade color to blue.
POWER DOWN: Press and
release button to power down
the Lightsaber.

IMPORTANT: BATTERY INFORMATION
CAUTION:
1. TO AVOID BATTERY LEAKAGE
a. Always follow the instructions carefully. Use only batteries specified and be sure to insert them correctly by matching the + and – polarity markings.
b. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
c. Remove exhausted or dead batteries from the product.
d. Remove batteries if product is not to be played with for a long time.
e. Do not short-circuit the supply terminals.
f. RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. Always remove from the product before recharging. Recharge batteries
under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
2. Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment.
Reset (switching off and back on again or removing and re-inserting batteries) if necessary.
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. PN# 7351680000