Hasbro Brother Bear Super Switchin Kenai 34927 User manual

AGES 3+
34927/34904 Asst.
Thank you for purchasing this Brother Bear toy! or
maximum play value, be sure to read and follow
instructions carefully.
Includes 3 x 1.5V "AAA"/R03 batteries. Alkaline
batteries recommended. Phillips/cross head
screwdriver (not included) needed to replace
batteries.
Super Switchin’ Kenai
Super Switchin’ Kenai

To activate speech, just give Super Switchin’ Kenai a hug or
squeeze his tummy. When Kenai’s in "human" mode, he says
human phrases. When he’s in "bear" mode, he growls and says
bear-like phrases!
To change Kenai into "bear" mode:
1. Pull his hood up and over his head, and fasten as shown.
( astening the hood switches toy from one mode to the other.)
Kenai will growl when you have correctly fastened the hood.
2. Pull bear-paw mittens over his hands.
3. Pull bear-foot slippers over his feet.
4. Squeeze Kenai to hear one of 6 phrases!
TO PLAY
TO PLAY
After about 30 seconds of non-activation Kenai says, "I’m on
my way!" and shuts himself off. To reactivate, just give him a
hug or squeeze his tummy.
To change Kenai back to "human" mode:
1. Unfasten hood and pull back over Kenai’s head.
2. Pull back mittens and slippers from his hands and feet, and
tuck into outfit.
3. Squeeze Kenai to hear him say one of 6 phrases!

CAUTION: TO AVOID BATTERY LEAKAGE
1) As with all small batteries, the batteries used with this toy should be
kept away from small children who still put things in their mouths.
If they are swallowed, promptly see a doctor and, in the U.S., have
the doctor phone [phone] collect, or, in Canada, have the
doctor call your provincial Poison Control Centre.
2) Make sure the batteries are inserted correctly and always follow the
toy and battery manufacturers' instructions.
3) Do not mix old batteries and new batteries or alkaline, standard
(carbon zinc) or rechargeable (nickel-cadmium) batteries.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1) Always follow the instructions carefully. Use only batteries specified and be sure to
insert them correctly by matching the + and – polarity markings.
2) Do not mix old batteries and new batteries, or standard (carbon-zinc) with alkaline
batteries.
3) Remove exhausted or dead batteries from the product.
4) Remove batteries if product is not to be played with for a long time.
5) Do not short-circuit the supply terminals.
6) Should this product cause, or be affected by, local electrical interference, move it
away from the other electrical equipment. Reset (switching off and back on again or
removing and re-inserting batteries) if necessary.
7) RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always
remove from the product before recharging. Recharge batteries under adult
supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
8) As with all small items, these batteries should be kept away from children. If
swallowed, seek medical attention immediately.
Use a Phillips/cross head
screwdriver to loosen screw in
battery compartment door
(screw remains attached to
door). Remove door. Remove
exhausted batteries and insert
3 x 1.5V fresh "AAA"/LR03
alkaline batteries. Replace door
and tighten screw.
TO REPLA E BATTERIES
TO REPLA E BATTERIES

© Disney
®* and/or ™* & © 2003 Hasbro. All Rights Reserved.
® denotes Reg. U.S. Pat. & TM Office.
34927/34904 Asst. PN 6272450000
HASBRO.COM
FOR NEW PRODUCTS AND OFFERS
HASBRO.COM
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1-800-327-8264
SURFACE WASH ONLY
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including any interference that may cause undesired operation. This
equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.