Hawking Hi-Gain HWREN15 User manual

website www.hawkingtech.com
e-mail [email protected]
©COPYRIGHT 2011 HAWKING TECHNOLOGIES,INC. ALL RIGHTS RESERVED.
USER’S MANUAL

HI-GAINTM WIRELESS-150N
Mini Range Extender
HWREN15

COPYRIGHT
Copyright ©2011 by Hawking Technologies. All rights reserved. No part of this
publication may be reproduced, transmitted, transcribed, stored in a retrieval system,
or translated into any language or computer language, in any form or by any means,
electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the
prior written permission of this company
Hawking Technologies makes no representations or warranties, either expressed or
implied, with respect to the contents hereof and specifically disclaims any warranties,
merchantability or fitness for any particular purpose. Any software described in this
manual is sold or licensed "as is". Should the programs prove defective following
their purchase, the buyer (and not Hawking Technologies, its distributor, or its dealer)
assumes the entire cost of all necessary servicing, repair, and any incidental or
consequential damages resulting from any defect in the software. Further, this
company reserves the right to revise this publication and to make changes from time
to time in the contents thereof without obligation to notify any person of such revision
or changes.

Federal Communication Commission
Interference Statement
FCC Part 15
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
4. Consult the dealer or an experienced radio technician for help.
FCC Caution
This equipment must be installed and operated in accordance with provided
instructions and a minimum 20 cm spacing must be provided between computer
mounted antenna and person’s body (excluding extremities of hands, wrist and feet)
during wireless modes of operation.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for
compliance could void the authority to operate equipment.
Federal Communication Commission (FCC) Radiation Exposure Statement
This equipment complies with FCC radiation exposure set forth for an uncontrolled
environment. In order to avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches)
during normal operation.
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.

R&TTE Compliance Statement
This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF
THE EUROPEAN PARLIAMENTAND THE COUNCIL of March 9, 1999 on radio
equipment and telecommunication terminal Equipment and the mutual recognition of
their conformity (R&TTE).
The R&TTE Directive repeals and replaces in the directive 98/13/EEC
(Telecommunications Terminal Equipment and Satellite Earth Station Equipment) As
of April 8, 2000.
Safety
This equipment is designed with the utmost care for the safety of those who install
and use it. However, special attention must be paid to the dangers of electric shock
and static electricity when working with electrical equipment. All guidelines of this
and of the computer manufacture must therefore be allowed at all times to ensure the
safe use of the equipment.
EU Countries Intended for Use
The ETSI version of this device is intended for home and office use inAustria,
Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Italy, Luxembourg,
the Netherlands, Portugal, Spain, Sweden, and the United Kingdom.
The ETSI version of this device is also authorized for use in EFTA member states:
Iceland, Liechtenstein, Norway, and Switzerland.
EU Countries Not intended for use
None.

CONTENTS
Chapter I: Product Information................................................................1
1-1 Product Introduction........................................................................................1
1-2 Safety Information...........................................................................................2
1-3 System Requirements......................................................................................3
1-4 Package Contents.............................................................................................4
1-5 Product Overview............................................................................................5
Chapter II: Quick Setup and Basic Settings.............................................7
2-1 Installing the 150N Mini Range Extender to your Network ...........................7
2-2 Connecting to the Range Extender by Web Browser ......................................8
2-2-1 Windows 95/98/Me IPAddress Setup:............................................................. 9
2-2-2 Windows 2000 IPAddress Setup ................................................................... 10
2-2-3 Windows XP IP Address Setup .......................................................................11
2-2-4 Windows Vista/7 IP Address Setup................................................................ 13
2-2-5 Mac OS X IPAddress Setup.......................................................................... 15
2-2-6 Connecting to Web Management Interface.................................................... 16
2-3 Quick Setup ...................................................................................................18
2-4 Status .............................................................................................................20
2-5 Wireless Security...........................................................................................21
2-5-1 Disable Security............................................................................................. 23
2-5-2 WEP............................................................................................................... 24
2-5-3 WPA Pre-shared Key...................................................................................... 26
2-6 WPS Setting...................................................................................................28
2-7 MAC Filtering ...............................................................................................31
Chapter III: Advanced Settings...............................................................33
3-1 Advanced Wireless Settings...........................................................................33
3-2 System Utilities..............................................................................................36
3-2-1 Change Password........................................................................................... 36
3-2-2 IPAddress of the Wireless Range extender ................................................... 37
3-2-3 DHCP Server.................................................................................................. 39
Chapter IV: Advanced Configuration.....................................................41
4-1 Configuration Backup and Restore................................................................41
4-2 Firmware Upgrade.........................................................................................43
4-3 System Reset..................................................................................................44
Chapter V Setup Wizard...........................................................................45
Chapter VI: Appendix..............................................................................47
6-1 Hardware Specification .................................................................................47

6-2 Troubleshooting.............................................................................................48
6-3 Glossary.........................................................................................................51

1
Chapter I: Product Information
1-1 Product Introduction
Thank you for purchasing the Hawking HWREN15 Hi-Gain™ Wireless
-150N Mini Range Extender!
Easy installation procedures allow any computer user to setup a network
in very short time - within minutes, even inexperienced users. Just follow
the instructions given in this user manual, you can complete the setup
procedure and unleash the power of this range extender all by yourself!
Other features of the 150N Mini Range Extender include:
Compatibility with IEEE 802.11b/g/Draft-N wireless network
standard - works with other 802.11b/g/Draft-N wireless devices.
High speed wireless network, three times faster than conventional
802.11g wireless network (up to 150Mbps).
Supports DHCP server function.
Supports 64/128-bit WEP, WPA, and WPA2 wireless data
encryption.
Supports MAC address filtering (Only allow specific wireless
device of your choice to connect to this range extender).
Supports WPS (Wi-Fi Protected Setup), simplifies wireless client
setup procedures. Even inexperienced users can setup wireless
network without a network technician’s help!
Easy to use web-based GUI (Graphical User Interface) for network
configuration and management purposes.

2
1-2 Safety Information
In order to keep the safety of users and your properties, please follow the
following safety instructions:
1. This range extender is designed for indoor use only; DO NOT place
this range extender outdoors.
2. DO NOT put this range extender near hot or humid places, like a
kitchen or bathroom. Also, do not leave this range extender in the car.
3. DO NOT pull any connected cable with force; disconnect it from the
range extender first.
4. If you want to place this range extender at high places or hang on the
wall, please make sure the range extender is firmly secured. Falling from
high places would damage the range extender and its accessories, and
void the warranty.
5. Accessories of this range extender, like the antenna and power supply,
are dangerous to small children under 3 years old. They may put the small
parts in their nose or mouth and it could cause serious damage to them.
KEEP THIS RANGE EXTENDER OUT THE REACH OF CHILDREN!
6. The range extender will become hot when being used for a long time
(This is normal and is not a malfunction). DO NOT put this range
extender on paper, cloth, or other flammable materials.
7. There’s no user-serviceable part inside the range extender. If you found
that the range extender is not working properly, please contact your dealer
of purchase and ask for help. DO NOT disassemble the range extender, or
the warranty will be void.
8. If the range extender falls into water when it’s powered, DO NOT use
your hand to pick it up. Switch the electrical power off before you do
anything, or contact an experienced electrical technician for help.
9. If you smell something strange or even see some smoke coming out
from the range extender or power supply, remove the power supply or
switch the electrical power off immediately, and call dealer of purchase
for help.

3
1-3 System Requirements
Computer or network device(s) with wired or wireless network
interface card.
Web browser (Microsoft Internet Explorer 4.0 or above, Netscape
Navigator 4.7 or above, Opera web browser, Mozilla Firefox web
browser or Safari web browser).
An available AC power socket (100 – 240 V, 50/60Hz)

4
1-4 Package Contents
Before you starting to use this range extender, please check if there is
anything missing in the package. Contact your place of purchase to
claim missing items:
1x - 150N Mini Range Extender
1x - 2dBi Dipole Antenna
1x - Quick Installation Guide
1x - A/C power adapter
1x - Ethernet cord
1x - Setup CD

5
1-5 Product Overview
Top Panel
LED Name
(Left to Right) Light Status Description
WLAN
On Wireless is Enabled and Connected
Off WLAN is disabled.
Flashing Wireless LAN activity (transferring or
receiving data)
LAN 1
On LAN port is connected
Off LAN port is not connected
Flashing LAN activity (transferring or receiving data)
LAN 2
On LAN port is connected
Off LAN port is not connected
Flashing LAN activity (transferring or receiving data)

6
Back Panel
Front Panel
Item Name Description
Antenna One SMA antenna connector for the 2dBi detachable
antenna enclosed with the product.
Power
(5V DC/1A) Power connector, connects to A/C power adapter.
Wired 1/2 Local Area Network (LAN) ports
WPS/Reset Reset the router to factory default settings (clear all
settings) or start WPS function. Press this button and
hold for 15 seconds to restore all settings to factory
defaults, power off/on. Press this button for less than 5
seconds to start WPS function.

7
Chapter II: Quick Setup and Basic Settings
2-1 Installing the 150N Mini Range Extender to your Network
Complete the following instructions to build the network connection
between your new wireless range extender and your computers or
network devices:
1. Connect the range extender to your computer (source) through the
LAN (Wired 1 or Wired 2) port of the range extender by Ethernet
cable or connect to it wirelessly.
2. Connect the A/C power adapter to the wall socket, and then connect it
to the ‘Power’ socket of the range extender.
3. Please check all LEDs on the front panel. LAN LEDs should be on if
the range extender is correctly connected to the router. If it is not on,
or any LED you expect is not on, please recheck the cabling, or jump
to ‘6-2 Troubleshooting’for possible reasons and solutions.

8
2-2 Connecting to the Range Extender by Web Browser
After your 150N Mini Range Extender has been connected and powered
the next step is to access the Web Menu for initial configuration. To do
this, your computer must be able to get an IP address automatically (use
dynamic IP address setting).
Try to access: http://192.168.1.240
If the Web Menu appears you can skip the next steps and go to step 2-3.
You will need to enter the following default login and password to access
the ‘Quick Setup’ menu:
Login: admin
Password: 1234
If it’s set to use a static IP address or you are unsure, please follow the
following instructions to configure your computer to use a dynamic IP
address:
Note: Please be sure to set your network IP addresses back to default
after you have finished configuration.
If the operating system of your computer is….
Windows 95/98/Me - please go to section 2-2-1
Windows 2000 - please go to section 2-2-2
Windows XP - please go to section 2-2-3
Windows Vista/7 - please go to section 2-2-4
Mac OS X - please go to section 2-2-5

9
2-2-1 Windows 95/98/Me IPAddress Setup:
1. Click ‘Start’button (it should be located at lower-left corner of your
computer), then click control panel. Double-click Network icon, and
Network window will appear. Select ‘TCP/IP’, then click ‘Properties’.
2. Select ‘Obtain an IP address from a DHCP server’ and then click ‘OK’.

10
2-2-2 Windows 2000 IPAddress Setup
1. Click ‘Start’button (it should be located at lower-left corner of your
computer), then click control panel. Double-click Network and Dial-up
Connections icon; click Local Area Connection, and Local Area
Connection Properties window will appear. Select ‘Internet Protocol
(TCP/IP)’and then click ‘Properties’
2. Select ‘Obtain an IP address automatically’ and ‘Obtain DNS server
address automatically’, then click ‘OK’.

11
2-2-3 Windows XP IPAddress Setup
1. Click ‘Start’button (it should be located at lower-left corner of your
computer), then click control panel. Double-click Network and Internet
Connections icon, click Network Connections, and then double-click
Local Area Connection, Local Area Connection Status window will
appear, and then click ‘Properties’
2. Select ‘Obtain an IP address automatically’ and ‘Obtain DNS server
address automatically’, then click ‘OK’.

12

13
2-2-4 Windows Vista/7 IPAddress Setup
1. Click ‘Start’button (it should be located at lower-left corner of your
computer), then click control panel. Under Network and Internet, Click
View Network Status and Tasks, then click Manage Network
Connections/Change Adapter Settings on the right hand column.
Right-click Local Area Network, then select ‘Properties’. Local Area
Connection Properties window will appear, select ‘Internet Protocol
Version 4 (TCP / IPv4)’, and then click ‘Properties’
2. Select ‘Obtain an IP address automatically’ and ‘Obtain DNS server
address automatically’, then click ‘OK’.