Haworth Zody LX User manual

4
1Seat Height Adjustment
Seat height adjustment lets you adjust the chair to
properly position your body at the worksurface and
maintain proper blood flow in your legs. Seat height
should be adjusted to allow your legs to maintain a
90-degree angle to the floor or footrest. (1)Pull up on
the lever and raise your body out of the chair to increase
seat height. (2) Stay in the chair and pull up on the lever
to decrease seat height.
2Seat Depth Adjustment
Seat depth adjustment moves the seat pad to accommo-
date different leg lengths. It helps you sit back far enough
in the chair to use the backrest without creating pressure
behind the knees. With a full 76 mm of seat depth you
have lots of room to adjust, so blood flow to your legs
isn’t restricted and you stay alert. (1) Pull up and slide
the seat forward to lengthen, or backward to shorten. A
minimum of two fingers should fit between the back of
your calf and the front of the seat.
3Tilt Tension Control
Regulates the amount of resistance you feel when
leaning back in the chair, and the effort required to
recline backward. You accomplish multiple tasks
throughout the day—the tension control helps you
stay comfortable. (1) Turn the crank forward to
increase tension; backward to decrease.
Page 1|2
Zody LX
User Guide
127 mm
406 mm
Fully Retracted Fully Extended
533 mm
76 mm
(-)
(+)
Activate 1
2
Back Stop & Lever Clicks
“Sync-Up”Release
Back Stop and Forward Tilt
Back stop lets you select an upright position or limit
the amount of recline while performing different
tasks. Back stops in 6 positions - upright and every
4° backward. Rotate the lever forward to engage;
rotate backward to disengage.
Forward Tilt enables you to vary your posture
throughout the day by changing the curve of your
spine. (1)Push down on the lever. (2)Recline just
until you hear a click, then lean forward. (3) Pull up
on lever and lean back to release forward tilt.

Zody LX
User Guide
Balanced 3-point tilt
Back reclines 24° from the upright position.
Seat pan moves downward 3° from the initial position.
Passive 51mm of torsional flex in the upper back to
increase user's mobility and comfort when reaching
sideways for objects.
5
Arms
(1) Arm height adjustment raises and lowers the arms
to keep the users shoulder in a neutral posture. To
change the height of the armrest, pull up on the lever
and slide the armrest up or down.
(2) Armrest side-to-side adjustment accommodates
users with various shoulder width. Grasp the armrest
cap and slide it side-to-side as needed.
(3) Armrest front-to-back adjustment allows users to
get closer to their work surface while maintaining
effective use of the backrest. Grasp the armrest and
slide it forward or backward as needed.
(4) Armrest pivot allows the user to have proper
support of the forearm when mousing or keying. To
change the angle of the armrest, grasp the armrest cap
and rotate the front of the armrest toward or away
from the body.
Page 2|2
Lumbar support adjustments
Lumbar height adjustment maintains the natural
curvature of the spine at the lower back and allows
users to choose the support that feels right for them.
Pull the lumbar support up or push down to adjust the
height.
Dual Posture
Models with dual posture enable a greater degree of
forward tilt to provide spinal alignment and support
for the "perching" posture between sitting and
standing. This posture offers an alternative to
standing or having to use another chair when you
increase the height of your worksurface.
102mm
6
7
8