Haworth IQ park Connect 2 User manual

1
©Haworth Inc
IQ park Connect 2
2 x Main Wall
2 x Table 8 x M6 bolts 8 x M8 Bolts
8 x M8 Washer 8 x IQ Table Pins 2 x Wall Joiner plate
60mm
Align male and
female clips on joining
walls, with male side
into female keyway
Lower the male side
gently into the
female side. If too
tight, loosen male
screw quarter turn
and try again.
If male screw is
correctly tuned,
you should feel the
walls click into
place.
“CLICK”
1 2 3
A
BC
DE
FG
H
1 x Mid Wall
7 x Adjustable foot
I
2
I
B
I

3
5
©Haworth Inc
IQ park Connect 2
4
After Lifting the pod back upright,
insert the number of IQ table pins
supplied into the holes shown, make
sure to hand tighten these loosely
with ‘IQ’ always facing upwards
Place the table on top of
the pins aligning the pins
with the pre-threaded
holes. Insert a M6 bolt
through the IQ table
pin to bind the table
to the wall.
Best way to apply these are while the
pod is on its back. use a washer in
conjuction with a M8 Bolt and screw
through the joiner plate to bind both
walls together.
On a Double unit there will be two to
install either side of the mid wall
H
E
F
G
C
D