Haztec EconoMax 8-6400 User manual

Haztec International Ltd ∙ Moorfield Road ∙ Leeds ∙ LS19 7BN ∙ UK
T: [phone] ∙ inf[email protected] ∙ www.haztec.uk
8-6400 EconoMax
Remote Mount Siren
M111 Issue 1.1 Created by: Technical - 1 - August 2019
Thank you for purchasing this Haztec product. Before proceeding with installation it is essential
to read and understand this instruction booklet.
Warning!
▪This product must be installed by persons competent in vehicle electrical installations
▪Improper installation of this product will void all warranties
▪Care should be taken to ensure that water ingress cannot occur through mounting or
wiring holes
▪Regularly inspect the product to confirm correct operation
▪Use only a mixture of soap and water to clean this product
▪DO NOT allow solvents, fuels or acetone-based cleaners etc. to contact this product
Basic Operating Specifications:
Supply voltage range:
12VDC
Maximum current draw:
1.4A
Sound output:
102dB @ 3m
Amplifier dimensions (mm):
104 x 53 x 30
Operating temperature:
-20 to 55OC
Connection Instructions:
Wire
Connect to
Function
Red
Positive [+] via switch & fuse
Main feed
Black
Negative [-]
Earth/Ground
Green
Speaker
Amplifier output
White
Speaker
Amplifier output
Green (x2)
Amplifier
Speaker output
▪Compact Siren Amplifier
▪12VDC
▪40W/8 Ohm
▪Wail/Yelp/Air Horn
▪Control Panel

Haztec International Ltd ∙ Moorfield Road ∙ Leeds ∙ LS19 7BN ∙ UK
T: [phone] ∙ inf[email protected] ∙ www.haztec.uk
8-6400 EconoMax
Remote Mount Siren
M111 Issue 1.1 Created by: Technical - 2 - August 2019
Installation:
▪Ensure the power is isolated from the unit before installation
▪Ensure correct supply voltage –12VDC ONLY
▪The amplifier and switch panel are pre-wired, leaving only the 2 output wires to be
connected to the speaker
▪Secure the amplifier to a suitable flat surface using the fixing lugs. Ensure it is kept away
from damp, potential damage and has suitable air ventilation
▪The switch panel can be affixed to a suitable flat surface using the self-adhesive pads
included
▪The speaker has a mounting bracket for secure fixing to a suitable position towards the
front of the vehicle
▪Connect the wiring loom ensuring that the +ve 12V supply is adequately protected (fuse
included)