HDanywhere XTND User manual

QUICK START GUIDE
HDMI CABLE
CAT6 CABLE
INFRARED (IR) CABLE
POWER
1Connect a HDMI source (e.g Satellite/Cable TV, Apple TV,
Xbox etc) to the “HDMI IN” of the XTND transmitter (labelled
TX) using a HDMI cable. Connect another HDMI cable into the
“HDMI Out” port to enable a local display.
2Connect a Cat6 cable between the “CAT” port of the XTND
transmitter (TX) and the “CAT” port of the XTND receiver
(labelled RX).
3Connect a display to the “HDMI OUT” of the XTND receiver
(RX) using a HDMI cable
4Power on the XTND Extender by connecting the supplied 5V
power supply to the XTND (TX) . XTND will immediately turn
on. A picture will display after several seconds.
5To control your HDMI source from your display location
connect the IR TX to the “IR (OUT)” port on the XTND
transmitter (TX). Ensure that the IR TX is positioned over the
IR window on your source device.
Connect the IR RX to the “IR (IN)” port on the XTND receiver
(RX). Ensure that the IR RX is in-line-of-sight of your source
device remote control. HDMI EXTENDER
FULL MANUAL ON HDANYWHERE.COM/SUPPORT

CAT6 RESOLUTION/DISTANCE GUIDE
SHORT RUN ADJUST
IN THE BOX
INFRARED (IR) CABLE
HD 1080iHD 1080p 24HD 1080p 60
INSTALL AT SOURCE LOCATION
0m
0ft 10m 32ft 20m 65ft 30m 98ft 40m 131ft 50m 164ft 60m 197ft 70m 230ft 80m 262ft 90m 295ft 100m 328ft
INSTALL AT DISPLAY LOCATION
POWER
1x IR RX
1x 5V 1A PSU
1x XTND RECEIVER (RX) 1x XTND TRANSMITTER (TX)
1x IR TX
If you find that your picture quality is low (sparkling or dropping
out altogether) you can adjust the short run settings to improve
the picture. You can typically assume the correct position of the
switches based on the distances shown below.
Each distance has two positions if one does not work try the
other.
FULL MANUAL ON HDANYWHERE.COM/SUPPORT
RECOMMENDED EQ SETTINGS
Position Cable Length
Under 7m
7-15m
15-22m
22-30m