HEIRLOOM EURO HOMEWARE User manual

Euro Homeware N
Z
A
ust
v
1
.
1
EURO HOMEWARE
TOWEL WARMER
For Warm Fluffy Towels
Operation
Your
EURO HOMEWARE
Towel Warmer uses only minimal electrical power
-
about the same as
an average light bulb. It will take approximately 20
-
30 minutes to reach maximum operating
temperature. For best results, only
two
-
three generous sized towels should be heated at one
time. The heat of this unit may increase significantly if overloaded with an excessive number of
towels.
NOTE: The temperature of your towel warmer will vary w
ith the ambient temperature of
your room.
As a result of this the warmer will feel hotter to touch during warmer periods.
A towel
warmer is designed to warm and assist the drying of towels and will normally operate at a
temperature that is too hot for the
warmer to be grasped for anextended time
Locating Instructions
Detailed installation instructions are provided on the reverse side. The
EURO HOMEWARE
Towel Warmer should be fixed through the wall cladding directly to studs or other suitable anchor
mater
ial. It should be at least 55mm below the ceiling or any overhanging surface and at least
300mm
above the floor or
40mm above
counter top
and should not in any circumstances be
located in the direct path of a water source (tap or shower etc)
Electrical I
nstallation
Please ensure your towel warmer is installed by a registered electrician
and ensure the electrical
supply, plug & switch location, and product location will comply with your local regulations.
New Zealand electrical wiring requirements stipula
te that this appliance must be wired by a
registered electrician in accordance with current electrical wiring r
eg
ulations. This appliance must
be fitted with an air gap phase isolation switch
which isolates the phase & neutral in accordance
with local wiri
ng regulations.
This product must be used in
c
onjunction with a hard wired
switch
.
For complete te
mperature control a wall mounted dimmer switch (with “off” position) is
recommended
Care and Cleaning
All components are made from high quality materials. Th
e finish of your Towel Warmer is hard
wearing and easily maintained. Clean with a soft cloth and non
-
abrasive cleaning agent.
Guarantee
This product is guaranteed against defects due to faulty workmanship or materials for
3
years
from date of purchase. In
the event of a defect in the product, it should be returned with the sales
receipt to the retailer from whom it was purchased. Under the guarantee the defective article will
be repaired or replaced at Heirloom’s option
–
free of charge. Costs of disconnec
tion,
reconnection, and freight are the responsibility of the owner, as is any damage arising in transit to
and from servicing.
This guarantee does not cover:
a.
Any damage to the product caused by misuse, neglect, accident, or in violation of the
manufactur
er’s instructions, or
b.
Any damage, loss or injury arising as a consequence of the use of the product.
Contact Us
We welcome your feedback on our products. You can view our full range of towel warmers on our
website and send us your comments about this prod
uct to
[e-mail]
Heirloom International Limited

Euro Homeware N
Z
A
ust
v
1
.
1
P O Box
204 235,
Manukau 2161,
New Zealand.
www.heirloom.co.nz

Euro Homeware N
Z
A
ust
v
1
.
1
INSTALLATION OF
EURO HOMEWARE
TOWEL WARM
ER
SPECIFICATIONS
Rating at
240
Volts AC
Voltage
White
(W)
Stainless Steel
Model WE450
Euro Homeware Eco
39
Watts
30
Watts
240 VAC
Model WE575
Euro Homeware Standard
54
Watts
48
Watts
240 VAC
Model WE740
Euro Homeware Deluxe 3
70
Watts
51
Watt
s
240 VAC
Model WE700
Euro Homeware Deluxe 4
70
Watts
50
Watts
240 VAC
This Package Contains:
1 Towel Warmer a
nd flex
(
with
2
pin plug
–
Australia Only)
Plastic Cover Plugs (2 per Bracket)
Plastic Mounting Bracket
Mounting Screws (2 per bracket)
CAUTION
Prior to installation please ensure the product is to your satisfaction. Once installed Heirloom cannot be responsible for de
fects in
the product finish
. This product is not intended for use by young children or infirmed persons without supervisi
on. Young
children should be supervised to ensure they do not play with the product
.
If the supply cord is damaged it must be replaced
by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
Installation:
Please
ensure your towel warmer is installed by a registered electrician
and ensure the electrical supply, plug & switch location,
and product location will comply with your local regulations.
We recommend that the towel warmer be installed on a flat and
uniform
wall, and into studs or other suitable anchor material.
While not recommended, i
f fixing to hollow cavity walls, Toggle
Anchors or similar devices must be used.
Position the towel warmer so that the plug and mains power receptacle are easily accessible,
with the cable entry to the towel
warmer NEAREST THE FLOOR. Avoid the supply cable coming into contact with the heated parts of the towel warmer
.
DO NOT PLUG THE UNIT INTO THE POWER SUPPLY BEFORE INSTALLATION IS COMPLETE.
Euro Homeware Deluxe 4
Euro Homeware Eco, Standard, Deluxe 3
S
uggested positions for the wall brackets are shown in the drawings above
1.
The towel warmer can be mounted facing left or right with the cable entry at the bottom of the unit.
2.
Position the wall
brackets in the required locations.
(the screw inside each leg bracket can be slightly loosened to move
the legs into position. The screw can then be retightened)
3.
Hold the unit against the wall in the desired position in accordance with these instructions
and mark the mounting holes
with a pencil. Pre
-
drill the holes through the wall cladding into the stud.
4.
Ensure the screw at the rear of the bracket is securely tightened and then screw the brackets to the wall
5.
Inser
t
the plastic cover pl
u
gs in
to
the mount
ing
bracket screw holes