Hi Sharp HS-CX9100 User manual

Thank you for purchasing our product.
Please read this User’s Manual before
using the product. Change without Notice CONTENT TABLE
CONTENT TABLE…………………………………………..………………. 2
FCC STATEMENT…………………………………………..………………. 3
SAFETY PRECAUTIONS………………………………………................. 4
REAR PANEL………………………………………………………………… 5
INSTALL STEP……….. …………………………………………………….. 8
SPECIFICATION.. …….…………………………………………………….. 9
D
IMENSION…………………………………………………………………... 11
BOX COLOR CAMERA (UTP)
2
SAFETY PRECAUTIONS
FCC STATEMENT
WARNING
This device complies with Part 15 FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received including
interference that may cause undesired operation."
* Federal Communications Commission (FCC) Statement
WARNING
This Equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the ser is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
* You are cautioned that changes or modifications not expressly approved
by the party responsible for compliance could void your authority to operate
the equipment.
3
Please read before using
1. Please read the service manual in details before using.
2. Don't try to disassemble the chassis or the part easily , in case
that touch the power by mistake , is shocked by electricity the
danger or caused inside parts to be damaged ,
3. Do not attempt to service this unit yourself unless you are
authorized to do so. Opening cover may exposure you to
dangerous voltage or other hazards. Refer all servicing to
qualified personnel only.
4. When being regular, please lock the parts firmly first to prevent
the machine damage.
5. Please connect correctly in accordance with the regulation,
prevent the machine from using, or striking improperly.
6. Please don't use any organic solution or the corrosively sanitizer
to insert and wipe away the chassis outside. While inserting and
wiping away, please turn off the power, and use the clean cloth is
stained with letting a small amount of branch water, insert and
wipe away appearance.
7. Please don't use the camera under the following abominable
environments. Temperature is lower than- 10 degrees
Centigrade, or is higher than +50 degrees Centigrade.
4
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of insulated dangerous Voltage within the
product’s enclosure that may be sufficient magnitude
to constitute risk of electrical shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operation and maintenance (servicing) instructions in
the literature accom
p
an
y
in
g
the a
pp
liance.

R AR PANELE
6
5
INSTALL STEPS
1. Make the camera on the bracket stable.
2. The Video output has two type of connections (video can be
output at the same time)
2.1. Use the BNC connector (75ΩCoaxial cable) then
connected with video in device (monitor , Matrix , DVR)
2.2. Use the UTP twisted pair to connect UTP receiver then the
receiver connected with video in device (Monitor, Matrix,
DVR)
3. Then connect the 75Ωcoaxial cable to device video in.
4. Put the power cable on.
5. Users may adjust the camera poison and angle in different
environment.
UTP SYSTEM
8
7

SPECIFICATION
DC circuit & Impedance table
Cable / Inch 18AWG(Ω) 18AWG(Ω) 18AWG(Ω) 18AWG(Ω)
250 3 5 8 13
290 4 6 9 15
330 4 7 11 17
380 5 8 12 20
435 6 9 14 22
500 6 10 16 26
575 7 12 19 30
660 8 13 21 37
750 10 15 24 39
870 11 18 28 45
1000 13 20 32 51
1150 15 23 37 59
1320 17 27 43 68
1500 19 30 48 77
1750 22 36 56 90
2000 26 41 65 103
2300 29 47 74 118
2650 34 54 86 136
3000 38 61 97 154
3480 44 71 112 179
4000 51 81 129 205
TypeA TypeB
DIMENSION
Horizontal
Resolution
530 TV Lines 420 TV Lines
IMAGE SENSOR 1/3” COLOR CCD SENSOR INTERLINE
Total Pixels NTSC: 811(H) x 508(V)
PAL: 795(H) x 596(V)
NTSC:537(H) x 505(V)
PAL:537(H) x 597(V)
Effective Pixels NTSC:768 (H) x 494(V)
PAL:752 (H) x 582 (V)
NTSC:510(H) x 492(V)
PAL:500(H) x 582(V)
Syn. System 2：1 Internal
Scanning system NTSC: 525 line 60 fields
PAL : 625 line 50 fields
Video Output 1.0 Vp-p / 75 Ohms composite
Function BLC, FLK, ON/OFF
UTP Unshielded Twisted Pair (UTP) Transmission (Built-In)
Wire Spec. Twisted pair (UTP)
26 to 12 AWG Unshielded (Category 2,3,4,5 or better
DC Loop Resistance 51 ohms / 1,000 feet (304 meters) (max)
Normal Capacitance 17pF/ft
Impedance 100 ohms +/- 20%
Electronic
Shutter
Auto Electronic Shutter
(1/60~1/100000 sec) NTSC,
(1/50~1/100000 sec) PAL
Lens Video / DC Lens / AE
S/N Ration More than 48db (AGC OFF)
Minimum
Illumination
0.5 Lux / F2.0 0.3 Lux / F2.0
Power Supply DC12V AC24V/DC12V AC 110/220V DC12V AC24V/DC12V AC 110/220V
Current 2.4W
(Max)
3W / 3.4W
(Max)
2.9W / 3.2W
(Max)
2.2W
(Max)
2.7W / 3.2W
(Max)
2.6W / 2.9W
(Max)
Power
Consumption
(Without Lens)
200mA
(Max)
280mA /290mA
(Max)
61mA /40mA
(Max)
180mA
(Max)
250mA /260mA
(Max)
55mA /36mA
(Max)
Dimension 67(W) x 92.5(D) x 58(H)mm
Operating Temp -10 to 50℃(14 to 122℉)
Storage Temp -20 to 70℃(-4 to 158 ℉)
9
V+ GNDV-
VIDEO
2.FLK
1.BLC AUTO
IRIS
LED
VIDEO
AESDC
AUDIO
DC +12V
V+ GNDV-
VIDEO
2.FLK
1.BLC AUTO
IRIS
LED
AC24V/ DC12V
VIDEO
AESDC
AUDIO AUDIO
DC AES
VIDEO
LED
AUTO
IRIS
1.BLC
2.FLK
VIDEO
V- GN DV+
POWER
11