High Street TV Verti Steam Pro User manual

Quick Start Guide
Verti Steam ProTM
SET UP PRESS PAD
FILL & GET READY
STEAMING - delicate fabrics – See page 13 of instructions for advice
VERTICAL IRON - ironable fabrics ACCESSORIES
1
2
3
Connect
1st pole
Connect
2nd pole
Insert
pole
1
2
Pull out stopper
3
Ready
Approximately
45 secs
Press &
release
to turn
on
1
2
Pull to
tension
Touch to
fabric
1
2
2cm away from fabric

BEFORE FIRST USE
• When you first use the appliance, some smoke or a harmless odour may be produced or
there may be a small discharge of particles. This will not affect the use of the appliance and
will disappear quickly.
• Each product is fully tested at the factory before being shipped. As a result, there may be a
little water in the tank already.
• We recommend to use the perfect finish lint remover in most garment steaming operation, as
this will help prevent water spots appearing.
NOTE
It will take 2 or 3 seconds for steam to be delivered on first use. During this initial period, the pump will
sound a little louder than in general use. The noise level will decrease as the steam flow continues.
This product has a safety Auto-Off function. If the unit is not used for a period of 15 minutes, the
auto-off will engage and switch onto standby. Pressing the trigger will turn the unit back on. It will
take up to 45 seconds to get back up to temperature.
WHAT WATER TO USE?
• For best results use demineralised water.
- Never use water containing additives (starch, perfume, aromatic substances, softeners,
etc.). or condensation water (for example water from tumble dryers, water from refrig-
erators, water from air conditioning units, rainwater). This water contains organic waste
materials that concentrate under the effect of heat and cause spitting, brown colouring or
premature ageing of your appliance.
WARNING:
Take care in use. Steam is HOT and may scald if applied directly onto skin. Although the stainless
steel press plate is not heated from within, the steam passing over WILL make it hot after a few
minutes use. It won’t get as hot as a steam iron soleplate, but it will be hot.
Always unplug the steamer before filling the water tank or attaching and detaching the attachments.
The Press Pad MUST be in place for Vertical Ironing.
✘
✘
✘
✘
Safety information
PLEASE DO NOT
Using your Verti Steam ProTM