HighPoint SSD7140 User manual

1
SSD7140
8x M.2 Port to PCIe 3.0x16 NVMe RAID Controller
Quick Installation Guide
V1.02

2
System Requirements
PC Requirements
•System with a free PCIe3.0 (or 4.0) x16 slot
•Windows 10 , Windows Server 2016 and Windows Server 2019
•Linux kernel 3.10 and later
•macOS 10.13 and later
SSD7140 Kit Content
•SSD7140 Controller Card
•Quick Installation Guide
SSD7140 Hardware
Front View

3
Hardware Installation:
Step 1. On the rear of the SSD7140, remove the six screws that secure
the unit’s heat sink to the PCB.
Step 2. Carefully remove fan’s power cable from the right-side of the
heatsink as shown below, then carefully flip the heatsink to the
left (like turning a page from a book).
Note: Take care when moving the heatsink to prevent damaging
the left fan’s power cable.

4
Step 3. These 8 screws are used to install the NVMe SSD’s.
Step 4. Please remove these screws from each of the M.2 slots.
Step 5. Gently insert the SSD into the slot.
Step 6. Refasten the screw to secure the SSD.

5
Repeat Steps 4 to 6 to install the remaining SSDs.
The following example shows eight SSD Samsung 970 EVO PLUS
PCIe Gen3 SSDs installed into Ports 1-8:
Step 7. After installing all SSDs, carefully flip the heatsink to the right.
Note: Make sure each SSD is carefully aligned and fastened to the
SSD7140 using the supplied screws. Loosely attached SSDs may
not be detected by the SSD7140 or host system.
Step 8. Carefully reinsert in the power supply cable of the cooling fan
that was removed in step 2.

6
Step 9. On the rear of the SSD7140, refasten the 6 screws that were
removed in step 1.
Step 10. Power up the SSD external power supply
Note: If the external power supply is not powered on, the SSDs
may drop offline or remain undetected, which could lead to data
loss.

7
SSD7140 relies on two power sources to support eight SSDs;
power supplied through the PCIe bus, and power from the
system’s PSU via an external power cable. If the external cable is
not connected, there will be insufficient power to support all 8
SSD’s; this may cause the SSDs to drop offline.
Note ： The SSD7140 does not require the external power cord
when used with 2019 Macpro systems.

8
Note: Please be sure to connect NVMe before using the product to
reduce the occurrence of unnecessary errors!
Note: Install the driver in the system first and then install the board
Resources
A variety of manuals, guides and FAQ’s are available for the SSD7140
RAID controller.
In addition, we recommend visiting the Software Downloads webpage
for the latest drivers, management interfaces, and installation guides.
Software Download:
SSD7140 Driver, WebGUI, Installation Guides
https://highpoint-tech.com/USA_new/series-ssd7140-download.htm
Other Reference Information:
Mother Board & NVMe SSD Compatibility List
SSD7140 User Guides
https://highpoint-tech.com/USA_new/series-ssd7140-resource.htm

9
Customer Support
If you encounter any problems while utilizing the SSD7140, or have
any questions about this or any other HighPoint Technologies, Inc.
product, feel free to contact our Customer Support Department.
Web Support:
https://www.highpoint-tech.com/websupport/main.php
HighPoint Technologies, Inc. websites:
https://www.highpoint-tech.com
© Copyright 2020 HighPoint Technologies, Inc. All rights reserved.