HIK VISION DS-KH8350-WTE1 User manual

Network Indoor Staon
Installaon Guide

Symbol Convenons
The symbols that may be found in this document are dened as follows.
Symbol Descripon
Danger Indicates a hazardous situaon which, if not avoided, will or
could result in death or serious injury.
Cauon Indicates a potenally hazardous situaon which, if not
avoided, could result in equipment damage, data loss,
performance degradaon, or unexpected results.
Note Provides addional informaon to emphasize or
supplement important points of the main text.
Network Indoor Staon Installaon Guide
i

Contents
1 About this Manual ...................................................................................... 1
2 Appearance ................................................................................................ 2
3 Typical Applicaon ..................................................................................... 4
4 Wiring Descripon ...................................................................................... 5
5 Installaon .................................................................................................. 6
5.1 Installaon Accessory Descripon .................................................................... 6
5.2 Wall Mounng .................................................................................................. 6
Network Indoor Staon Installaon Guide
ii

1 About this Manual
Get the manual and related soware from or the ocial website (hp://
www.hikvision.com).
Product Model
Network Indoor Staon DS-KH8350-WTE1,DS-KH8350-TE1
Scan the QR code to get the
conguraon guide for detailed
informaon.
Scan the QR code to get the operaon
guide for detailed informaon.
Network Indoor Staon Installaon Guide
1

2 Appearance
Front Panel
Figure 2-1 Front Panel
Rear Panel
Figure 2-2 Rear Panel
Network Indoor Staon Installaon Guide
2

Note
•The Unlock key is valid only when does the indoor staon speak with the
door staon or open the live view of the door staon.
•You can not use the debugging terminal.
Network Indoor Staon Installaon Guide
3

3 Typical Applicaon
Network Indoor Staon Installaon Guide
4

4 Wiring Descripon
There are 20 pins in the terminal on the rear panel of the indoor staon: 2 RS-485
pins, 2 power pins, 2 GND pins, 2 alarm output pins, 8 alarm input pins, and 4
reserved pins.
Figure 4-1 Wiring Descripon (Alarm Input Device)
Network Indoor Staon Installaon Guide
5

5 Installaon
It supports wall mounng. There are two installaon modes.
5.1 Installaon Accessory Descripon
The wall mounng plate is required when installing the indoor staon on the wall.
The dimension of wall mounng plate is shown below.
Figure 5-1 Wall Mounng Plate
5.2 Wall Mounng
Before You Start
•Make sure the device in the package is in good condion and all the assembly
parts are included.
•The power supply the indoor staon supports is 12 VDC. Please make sure your
power supply matches your indoor staon.
•Make sure all related equipments are power-o during the installaon.
•Check the product specicaon for the installaon environment.
Steps
1. Fix the wall mounng plate to the wall with 2 supplied screws.
Network Indoor Staon Installaon Guide
6

2. Put the indoor staon on the holder of the wall mounng plate.
Figure 5-2 Installing the Plate
Network Indoor Staon Installaon Guide
7

UD11942B