HIK VISION DS-3WF01C-2N User manual

Installation manual
Special Wireless Bridge For Elevator
*Please be sure to install and use in pairs.
Package Contents: Device of Elevator Room DS-3WF01C-2Nx1; Device of IP Camera DS-3WF01C-2Nx1; DC48V 0.25A POE Adapterx2; Plastic tie x4; Certificate x1;
Instructions x1
Device of Elevator
Room connection
Device of IP Camera
connection
LAN2 LAN1 12V
Reset
POE
POE Adapter
POE POE LAN1/LAN2
LAN POE Adapter
The signal level LED
Green, yellow and red lights on: the
wireless signal level is strong.
Yellow and red lights on: the
wireless signal level is medium.
Red light on: the wireless signal
level is weak or no signal.
12V DC power supply port:
The default power supply mode is POE, if
you want to use 12V DC power supply, you
must provide 12V DC Adapter for yourself.
Reset Button:
User can restore the device to factory
settings
POE Port: The port used to connect the POE port
of POE Adapter, the green LED will light when the
port is connected to the POE Adapter. The yellow
LED will light when the device connect to the
camera or computer successfully.
LAN1/LAN2 Port: The Port
used to connect camera,
information distribution screen
and other network equipment
Device of Elevator Room
Default IP: 192.168.1.35
User name: admin Password: 12345
Device of IP Camera
Default IP: 192.168.1.36
User name: admin Password: 12345
Trouble shooting for Network failure,
video transmission is not smooth
1.Please confirm that the devices are installed in
pairs. The serial numbers of the Elevator Room
device and the IP Camera device should be
consistent.
2.Make sure the devices are aligned and visible,
there is not a bunker between the devices.
3.Make sure the LED and the signal level LED are
working properly.
Other questions, please contact
technical support
400-700-5998
21 43 65 87
UPLINKLAN
Configuration and Debugging

Specification
Sheet
Marking for the restriction
of substances or elements
Warranty
card
Standard
Operating Frequency
Antenna
Output power
Receive Sensitivity
Max Transmission Rate
Power supply
Interface
Operating Temperature
Storage Temperature
Operating Humidity
Dimensions
Application scenarios
Encryption
Network Mode
Security
Network Protocol
TDMA
Auto ACK timing Adjust
Management and Logs
Web Based Configuration
Firmware Update
Bandwidth supported
IEEE802.11 b/g/n（2T2R 300Mbps）
2400~2500MHz(More Non-standard channels is availability, the range: 2312MHz-2732MHz)
Internal, Gain 6dBi, H: 65° V: 60°
27dBm
-72dBm@65Mbps, -97dBm@1Mbps
11n: 300Mbps(HT40)/130Mbps(HT20) 11g: 54Mbps
48V PoE or 12V DC
3×10/100M Base-TX (Cat. 5/5E， RJ-45) ports
-30℃～+65℃
-40℃～+85℃
5%～95%RH non-condensing
150*150*31.6mm
Elevator Room/IP Camera
WPA-PSK/WPA2-PSK
Router/Bridge
IP/MAC filter, SSID hidden, Interface Isolation
TCP/UDP/ARP/ICMP/DHCP/HTTP/NTP
Supported (Extend private communication protocol)
Supported (It can automatically detect the distances of the devices, keep the performance
always the best)
NTP，Syslog，Telnet，AC
Supported
Support update firmware by Web page
20M/40MHz
Wireless
Items Parameters
Hardware
Software
Explanation
Case
Printed Circuit Board
Power Supply(if exists)
Accessory(if exists)
x
x
x
x
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
Part of
the name Lead
(Pb)
Mercury
(Hg)
Cadmium
(Cd)
Hexavalent
chromium
(CrVI)
Polybrominated
Biphenyl
(PBB)
Polybrominated
Diphenyl Ethers
(PBDE)
o indicates that the content of the restricted substance in all homogeneous
materials of the part is below the limit specified in the SJ/T11363-2006 standard.
x indicates that the content of the restricted substance in at least one of the
homogeneous materials of the part exceeds the limit specified in the
SJ/T11363-2006 standard.
Customer Name：
Detailed Address：
Telephone： Fax： Postal Code：
E-mail：
Product Model：
Product Number(S/N)：
Production Date： YY MM DD
Purchase Date： YY MM DD
Free Warranty： MM
If you have any other requirements, please fill in the following：
Dealer： Telephone：
Distribution Unit: (Stamp)
Mailing Address: Hikvision Technical Service Center, 5 floor of Hikvision
Science Park Building 2, No.469 Jianghui Road, Binjiang District,
Hangzhou, China
Postal Code：310052
Substances or elements which are restricted by
Measures for the Control of Pollution from
Electronic Information Products