Hobie Mirage Tandem User manual

Step 1: Flip kayak
so that the bottom is
facing up.
Step 2: Insert
threaded portion of
adapter into the
scupper hole that
corresponds to the
front seat. Note: The
sail adapter is installed
from bottom of the
kayak.
Step 3: The adapter is
self-tapping but will require
some leverage to screw in.
Insert a screwdriver into
designated slot to help with
turning.
Congratulations on purchasing the
Tandem Mirage Sail Adapter Kit.
Follow these simple installation
instructions and you'll be out on the
water in no time.
For serial numbers 1544
and larger.
Step 4: Consult Sail Kit instructions
for sail assembly.
Tandem Mirage
Sail Adapter
Step 6: Flip kayak over
and insert mast into adapter.
WWW.HOBIECAT.COM
Tandem Mirage Sail adapter
Serial Numbers 1544 and larger
Step 5: Slide down haul
hook up the bottom of the
mast approximately 10 inches
then tighten screw to secure
the hook. Once tightened
stretch bungee at base of sail
onto the down haul hook.
Step 7: Run the main
sheet from the sail side
through the rear pad-
eye and up through the
left clip on your seat.
This configuration allows
you to steer with your
right hand and
control the sail with
your left.