Hoist Fitness CF-3252 User manual

CATALOG NUMBER
OWNER'S MANUAL
RECORD SERIAL NUMBER HERE
Fax
[phone]
[phone]
[phone]
Note: Both Serial Number and Model Number are Required when Ordering Parts
Customer Service
0908 - 000
VERTICAL KNEE RAISE (VKR)
CF-3252
**WARNING !**
TO PREVENT POSSIBLE TIPPING, BOLT THIS UNIT TO THE
EXERCISE FLOOR. FAILURE TO DO SO MAY RESULT IN SERIOUS
INJURY OR DEATH.

02
04
14
15
16
17
19
20
22
24
25
26
27
28
OWNER'S MANUAL
PAGE 01 CF-3252 ASSEMBLY
INSTRUCTIONS .....................................................................
FRAME ASSEMBLY ..............................................................
PRE-ASSEMBLY....................................................................
DECAL PLACEMENT.............................................................
DECAL REFERENCE.............................................................
PART LIST...............................................................................
ABBREVIATIONS...................................................................
BOLT SIZING CHART............................................................
WASHER SIZING CHART......................................................
MAINTENANCE SCHEDULE.................................................
GENERAL MAINTENANCE INFORMATION........................
WEIGHT TRAINING TIPS.......................................................
EXERCISE LOG......................................................................
LIMITED WARRANTY............................................................
CONTENTS

OWNER'S MANUAL
PAGE 02
CF-3252 ASSEMBLY
Ratchet Wrench
1/2", 9/16" and 3/4" Sockets
Adjustable Wrench
Rubber Mallet
Tape Measure
Level
Hex Key Wrench Set
TOOLS REQUIRED
Before beginning assembly please take the time to read instructions
thoroughly. Please use the various lists in this manual to make sure that
all parts have been included in your shipment. When ordering, use part
number and description from the lists. Use only HOIST replacement parts
when servicing. Failure to do so will void your warranty and could result
in personal injury.
HOIST equipment is designed to provide the smoothest, most effective
exercise motion possible. After assembly, you should check all functions to
ensure correct operation. If you experience problems, first recheck the
assembly instructions to locate any possible errors made during assembly.
If you are unable to correct the problem, call your authorized HOIST dealer.
Be sure to have your serial number and this manual when calling. When all
parts have been accounted for, continue on.
INSTRUCTIONS

***THIS PAGE WAS INTENTIONALLY LEFT BLANK***
OWNER'S MANUAL
PAGE 03 CF-3252 ASSEMBLY

OWNER'S MANUAL
PAGE 04
CF-3252 ASSEMBLY
FRAME ASSEMBLY

FRAME ASSEMBLY
- HAND TIGHTEN HARDWARE.
NOTE:
OWNER'S MANUAL
PAGE 05 CF-3252 ASSEMBLY
27
41
27
23
7
2
3
13
39

741
29
12
2
4
4
38
29
3
FRAME ASSEMBLY
NOTE:
- HAND TIGHTEN HARDWARE.
OWNER'S MANUAL
CF-3252 ASSEMBLY PAGE 06

- HAND TIGHTEN HARDWARE.
- SOME PARTS MAY HAVE BEEN
REMOVED FOR CLARITY.
FRAME ASSEMBLY
NOTE:
OWNER'S MANUAL
PAGE 07 CF-3252 ASSEMBLY
27
27
2
1
41
36
14

FRAME ASSEMBLY
NOTE:
- HAND TIGHTEN HARDWARE.
CF-3252 ASSEMBLY
OWNER'S MANUAL
PAGE 08
29
5
38
29
12
29
6
12
41
38
29
41

24
6
5
5
6
*
OR
*
FRAME ASSEMBLY
THE CF-3962-OPT MANUAL TO ASSEMBLE
THIS PART AT THIS TIME.
REFER TO
NOTE:
IF INSTALLING THE CF-3962-OPT, DISCARD
ITEM (24) AND REPLACE WITH (*).
OWNER'S MANUAL
PAGE 09 CF-3252 ASSEMBLY

41 19 27
41
35
20
37
37
27
41
24
27
27
27
FRAME ASSEMBLY
NOTE:
- WRENCH TIGHTEN HARDWARE
- WRENCH TIGHTEN ALL PREVIOUSLY
HAND TIGHTENED HARDWARE.
OWNER'S MANUAL
CF-3252 ASSEMBLY PAGE 10
*IMPORTANT*
NOW THAT THE CF-3252 FRAME IS COMPLETELY ASSEMBLED, TAKE TIME TO
ASSURE THAT YOUR UNIT IS ASSEMBLED SQUARE AND PERPENDICULAR. IF NOT,
IT WILL BE NECESSARY TO LOOSEN SOME FRAME HARDWARE TO RE-ALIGN THE
FRAME ANDRETIGHTEN BOLTS.

3
33
26
8
7
26
40
33
40
26
8
26
NOTE:
- REPEAT ASSEMBLY FOR OPPOSITE SIDES.
- WRENCH TIGHTEN HARDWARE.
FRAME ASSEMBLY
OWNER'S MANUAL
PAGE 11 CF-3252 ASSEMBLY

FRAME ASSEMBLY
NOTE:
- WRENCH TIGHTEN HARDWARE.
- SOME PARTS HAVE BEEN REMOVED
FOR CLARITY.
CF-3252 ASSEMBLY
OWNER'S MANUAL
PAGE 12
31
9
5
31
25
9
25
6

10
32
25
1
24
FRAME ASSEMBLY
FOR CLARITY.
- WRENCH TIGHTEN HARDWARE.
- SOME PARTS HAVE BEEN REMOVED
NOTE:
OWNER'S MANUAL
PAGE 13 CF-3253 ASSEMBLY

21
22
17
34
34
28
22
21
16
34
28
17
18
30
30
6
11
15
24
28
28
34
18
30
5
30
15
16
PRE-ASSEMBLY
CF-3252 ASSEMBLY
OWNER'S MANUAL
PAGE 14

NOTE:
UNLESS OTHERWISE STATED.
- ALL DECALS ARE CENTERED
DECAL PLACEMENT
OWNER'S MANUAL
PAGE 15 CF-3252 ASSEMBLY
44
44
45
46
42 43
44
44

021-0003008
SERIAL # DECAL
021-0003135
021-0003221
021-0003226
DECAL REFERENCE
CF-3252 ASSEMBLY
OWNER'S MANUAL
PAGE 16
400 LBS.
MAXIMUM
WEIGHT RATING

ITEM NO. PART NUMBER DESCRIPTION QTY
1 026-01X2044 BACK SUPPORT ASSEMBLY 1
2 026-01X5107 REAR FOOT ASSEMBLY 1
3 026-01X5117 LOWER SIDE FRAME , LEFT ASSEMBLY 1
4 026-01X5118 SIDE UPRIGHT ASSEMBLY 2
5 026-01X5119 ARM REST, RIGHT SIDE ASSEMBLY 1
6 026-01X5120 ARM REST, LEFT SIDE ASSEMBLY 1
7 026-01X5162 LOWER SIDE FRAME, RIGHT ASSEMBLY 1
8 026-01X1610 FOOT PLATE ASSEMBLY 4
9 022-01PD2208-A ARM PAD ASSEMBLY 2
10 022-01PD2306-A BACK PAD ASSEMBLY 1
11 016-0201016 END CAP 2.00" X 4.00" (BLACK) 1
12 026-01F0300 FLANGE .188" H.R.S. Ø3.00" 4
13 026-01F0321 FLNG-F, .188" x 2.00" x 9.00 2
14 026-01F0515 .188" X 4.00" X 9.00" LG. HRS 1
15 026-01M0932 END CAP: ALUMINIUM Ø1.25" ID 2
16 026-01M0933 ALUMINUM RING: Ø1.25" ID 2
17 026-01M0934 1.5" ID ALUMINUM END CAP 2
18 026-01M0935 ALUMINIUM RING: Ø1.50" I.D. 2
19 026-01P2045 FLANGE 1
20 026-01P2047 COUNTERSINK FLANGE 1
21 026-01PL0209-4 GRIP:OPEN ENDED 1.50" X 12.88 LG. 2
22 026-01PL0235-17 1.188" DIA X 5.00" OPEN END GRIP 2
23 026-01PL2211-B RUBBER FOOT 4
24 026-01T2052 TUBE FILLER 1
25 013-0302008 5/16" SAE FLAT WASHER (WZ) 6
26 013-0402007 3/8" X 22mm FLAT WASHER (WZ) 16
27 013-0102003 1/2" X 27mm SAE FLAT WASHER (WZ) 26
28 013-0408001 3/8" INTERNAL LOCK WASHER (SS) 4
29 013-0202007 1/2" CURVED WASHER (WZ) 16
30 011-0111008 SET SCREW: 1/4"-28 X .25" LG. (WZ) 8
31 011-0107011 5/16"-18UNC X 1.25" HHB (WZ) 4
32 011-0407015 5/16"-18UNC X 5.50" HHB (WZ) 2
33 011-0101026 3/8"-16UNC X 1.00" BHCS (WZ) 8
34 011-0401002 3/8"-16UNC X 1.25" BHCS (SS) 4
35 011-0102030 1/2"-13UNC X 5.25" FHCS (WZ) 2
PART LIST
NOTE: SOME OF THESE PARTS MAY COME PRE-INSTALLED
PAGE 17
OWNER'S MANUAL
CF-3252 ASSEMBLY

PART LIST CONTINUED
NOTE: SOME OF THESE PARTS MAY COME PRE-INSTALLED
OWNER'S MANUAL
PAGE 18
CF-3252 ASSEMBLY
ITEM NO. PART NUMBER DESCRIPTION QTY
36 011-0407016 1/2"-13UNC X 3.00" HHB (WZ) 4
37 011-0407000 1/2"-13UNC X 3.50" HHB (WZ) 4
38 011-0107050 1/2"-13UNC X 3.75" HHB (WZ) 8
39 011-0107014 1/2"-13UNC X 5.00" HHB (WZ) 4
40 012-0104008 3/8"-16 UNC THIN NYLOCK NUT (WZ) 8
41 012-0304011 1/2"-13 UNC THIN NYLOCK NUT (WZ) 22
42 021-0003008 DECAL COMMERCIAL MAINTENANCE 1.50" X 6.69" 1
43 021-0003135 DECAL WARNING 1.50" X 6.69" 1
44 021-0003221 DECAL HOIST 2.50" X 9.13" 4
45 021-0003226 DECAL 400 LB. WEIGHT RATING 1.625" X 1.625" 1
46 SERIAL # DECAL DECAL HOIST SERIAL # 1.63" X 2.63" 1

BZ = Black Zinc
WZ = White Zinc
HHB = Hex Head Bolt
FHCS = Flat Head Cap Screw
BHCS = Button Head Cap Screw
SHCS = Socket Head Cap Screw
SHSS = Socket Head Shoulder Screw
ABBREVIATIONS
OWNER'S MANUAL
CF-3252 ASSEMBLY
PAGE 19