Hollyland HLHF200 User manual

USER MANUAL
HDMI Fiber Optic Transmission
1.0 Introduction
2.0 Panel Description
3.0 Function Specification
4.0 Connection and operation
1.0 Introduction
HLHF200 is a perfect solution for transmitting HDMI audio and video through the fiber, the set of device includes
a sender of Tx and a receiver of Rx. Our products transmit the HD video over optical fiber, which making the
images clearer as well as the transmission more stable. At the same time, the product has the built-in IR remote
control function.
2.0 Panel Description
2.1 Front Panel

HDMI TX
HDMI RX
HDMI PORT
Video Input
Video Output
IR PORT
IR Input
IR Output
Fiber Port SC
Optic-fiber Data Transmission
RESET KEY
Hold down the key for 8 seconds after power on, the
model will restore default settings
2.2 Indicator led.
Indicator led
Status
FX
Light On
The transmission rate is correct
Light Off
The transmission rate is not correct
Link act
Light On
Fiber Link up
Flash
Packets of data are transmitting in the indicating port
Dpx Light On In the State of full-duplex
Light Off In the State of half-duplex
3.0 Function Specification
HDMI 1.3/HDCP1.1 & 1.2
Both Optic-fiber transmission.
Support point-to-point mode, one point-to-many mode and cascaded transmission mode.
built-in IR remote control function, you can control the set-top box at the receiving site using the IR remote
control.
Pure hardware design, just plug and play, no need to install extra software.

Video Parameter
Video Resolution
640X480 @ 60fps 800X600 @ 60fps
1024X600 @ 60fps 1024X768 @ 60fps
1152X864 @ 60fps 1280X600 @ 60fps
1280X720@ 60fps 1280X768@ 60fps
1280X800@ 60fps 1280X960@ 60fps
1280X1024@ 60fps 1440X1050@ 60fps
1440x900 @ 60fps 1600x900 @ 60fps
1660x1200 @ 60fps 1680x1050 @ 60fps
1920x1080 @ 60fps
Audio
32kHz, 44.1kHz and 48kHz
Infrared Support 38KHz; NEC code
HDMI Version HDMI 1.3
HDCP Version
HDCP 1.2
The wavelength
Single mode 1310/1550nm
Power input
AC input: 100V - 240V (50 - 60Hz)
Max Power Consumption
DT200T: 5W
DT200R: 5W
Size (L-W-H)
(24.8X21.8X5.5)CM
Net Weight
0.85kg
Operating Temperature/Humidity
0
℃
- 70
℃
/ 10% - 80%RH(no condensation)
Storage Temperature/Humidity
-10℃- 80℃/ 5% -90% RH(no condensation)
4.0 Connection and operation
1. Please connect the HDMI signal source to the Tx 。
2. Connect RX to the HD displayer.
3. Between TX and RX(SC port-to-SC port) use optical fiber to connect.
4. IR remote control function, connect the IR receiver to the HDMI TX and connect the IR transmitter to the
HDMI RX.
5. Power on the device, POWER light on, then it will do the self-checking job with the other indictors
blinking automatically. When the Link light flash, the device starts up.
Application diagram

Distributed by
 

Phone: [phone], Email: [e-mail]
Suite 1A Level 2, 802 Pacific Highway, Gordon NSW 2072
www.ultralinks.com.au