Holmes HAWF2041 User manual

TROUBLESHOOTING
PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS
Owner’s Guide
HAWF2041
WARRANTY INFORMATION
3 YEAR LIMITED WARRANTY
Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada)
Limited doing business as Jarden Consumer Solutions (collectively “JCS”) warrants that for a period of three years
from the date of purchase, this product will be free from defects in material and workmanship. JCS, at its option, will
repair or replace this product or any component of the product found to be defective during the warranty period.
Replacement will be made with a new or remanufactured product or component. If the product is no longer available,
replacement may be made with a similar product of equal or greater value. This is your exclusive warranty. Do NOT
attempt to repair or adjust any electrical or mechanical functions on this product. Doing so will void this warranty.
This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable.
Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. JCS dealers, service centers,
or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and conditions of
this warranty.
This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or
misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly,
repair or alteration by anyone other than JCS or an authorized JCS service center. Further, the warranty does not
cover: Acts of God, such as fire, flood, hurricanes and tornadoes.
What are the limits on JCS’s Liability?
JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or
statutory warranty or condition.
Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a
particular purpose is limited in duration to the duration of the above warranty.
JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise.
JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use
the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of
contract, fundamental or otherwise, or for any claim brought against purchaser by any other party.
Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages
or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights that vary from province to province,
state to state or jurisdiction to jurisdiction.
How to Obtain Warranty Service
In the U.S.A.
If you have any question regarding this warranty or would like to obtain warranty service, please call
1-800-546-5637 and a convenient service center address will be provided to you.
In Canada
If you have any question regarding this warranty or would like to obtain warranty service, please call
1-800-546-5637 and a convenient service center address will be provided to you.
In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions located
in Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing
business as Jarden Consumer Solutions, located at 20B Hereford Street, Brampton, Ontario L6Y OM1. If you have any
other problem or claim in connection with this product, please write our Consumer Service Department. PLEASE DO
NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE.
9100010010777 HAWF204109EM1 Printed In China
Twin Window Fan
with Comfort Control Thermostat
Issue Potential Cause Potential Solution
Air does not seem to be blowing
in properly.
Airflow set to Exhaust
rather than Intake.
Adjust Airflow Directional Switch to Intake.
Fan will not operate even though
I am turning on the Fan with the
Speed Control Knob.
Fan is not plugged in.
Thermostat is set
lower than the
ambient room
temperature.
Plug in the power cord into a 120 V AC Outlet. Be sure the Speed Control
Knob is in the off position prior to plugging in the Fan.
Make sure thermostat is set at a comfort level higher than the room
temperature. To do this, simply turn the thermostat knob to the right until
the fan blades begin to spin.
Fan is not secure in the window
and moves during operation.
Fan may not be set in
the window properly.
Ensure that the bottom edge of the window sash fits securely into the
groove along the top of the Fan. Close the sash completely on top of the
window so it is secure. Please refer to the Installation portion of the
manual for more details.
My Window Fan will not fit
horizontally in the window.
Fan may need to be
installed vertically.
Window fans can be installed either vertically or horizontally. Please note when
installing vertically, the internal adjustable extender panel must be located on
the top of the window fan and never on the bottom. Please refer to the
Installation portion of the manual for more details.
My Window Fan has become
very dirty.
Fan may need to be
cleaned.
First unplug the fan from the outlet. The outside of the fan can be wiped down
with a damp cloth. Use a vacuum cleaner with a dust brush attachment or a
can of compressed air to remove dust from any hard to reach areas. Please
note: Holmes window fans cannot be taken apart to be cleaned.
TROUBLESHOOTING GUIDE
© 2009 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All Rights Reserved.
Distributed by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431.
HAWF2041_09EM1.qxd:HAWF2041_07EM1.qxd 12/19/08 3:59 PM Page 1

COMFORT CONTROL THERMOSTAT
INSTRUCTIONS
Your window fan is equipped with a Comfort Control
Thermostat that automatically turns the fan on and off
depending on your preset comfort level.
• For the fan to turn on, the thermostat must be set at
a temperature higher than the
current room temperature. If the
fan power is on but the fan
blade(s) aren't moving, turn the
Comfort Control Thermostat dial
to the right until the fan blade(s)
spin.
• To set your desired comfort level, run the fan until
the temperature in your room is comfortable. Slowly
turn the Comfort Control Thermostat dial to the left
until the fan blades turn off. This is the temperature
your fan will maintain.
IMPORTANT: If you desire continuous running of
the fan, the Comfort Control Thermostat dial should
be turned all the way to the right to the largest dot.
• WARNING: BE SURE FAN IS SECURELY INSTALLED IN
YOUR WINDOW AT ALL TIMES. DO NOT LEAN OR
PUSH ON FAN WHILE IT IS IN THE WINDOW.
CLEANING/MAINTENANCE
INSTRUCTIONS
Follow these instructions to correctly and safely care for
your Holmes window fan.
Please remember:
• Always unplug the fan before cleaning or
disassembling.
• Do not allow water to drip on or enter into the fan
housing.
• Be sure to use a soft cloth moistened with mild soap
solution.
• Do not use gasoline, thinner or benzene as a cleaner.
Fan Blade and Front Grill Cleaning
1. Using a phillips head screwdriver, remove the screws
that hold the front and rear grills together. Do not
completely detach the grills as this may damage the
extender clips. Separate only enough to gain access
to the blades with one hand.
2. Clean blades and grills with a soft, moist cloth (see
above).
3. Securely fasten the grills together.
FAN STORAGE
For all window fans, and fans that come already
assembled.
• It is important to keep it in a safe, dry location.
• We recommend using the original (or appropriately
sized) box.
• Please remember to protect the fan from dust or
moisture.
WINDOW FAN ACCESSORIES
Panel (H) until the fan sits safely in your window.
4. If the fan still does not fit snugly attach the Slider
Safe®Extender Panel located in the polyfoam
packaging in the original box. Align the slot in the
Slider Safe®Extender Panel along the tab located on
the left side of your Window Fan (G). Slide the Slider
Safe®Extender Panel completely down the tab until it
is flush on both the top and bottom of the Window
Fan.
5. To keep the fan in place, carefully close the window
so that the bottom edge of the window rests on the
flat area on the top of the fan.
For Slider Windows
1. Set the Fan vertically in your window opening with
the left side of the fan situated on the bottom and
the Built-In Extender Panel on top.
2. Set the fan into your window opening (note that in
most cases the window screen does not have to be
removed or left open).
3. If the fan does not fit snugly to the top and bottom
of the window casing, attach the Slider Safe®
Extender Panel and adjust the built-in extender
screen until the fan fits securely in your window.
OPERATING INSTRUCTIONS
• Make sure rotary switches are in the OFF position.
• Plug into 120V AC electric outlet.
• Set the individual fan motors on either INTAKE,
EXHAUST or AIR EXCHANGE using the control level.
• To start the unit, turn the Left/Right Fan Speed
Controls to desired speed (HI,MED,LO). Note: If unit
will not start, please check that Comfort Control
Thermostat is set to HI/largest dot.
• When operating both fans on EXHAUST, set the
Comfort Control Thermostat all the way to high by
turning the dial CLOCKWISE (to the right) toward the
largest dot.
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
FEATURES - OPERATIONS
When using electrical appliances, basic safety precautions
should always be taken including the following:
1. Read all instructions before using this appliance.
2. Use fan only for purposes described in the instruction
manual.
3. To protect against electrical shock do not immerse
unit, plug or cord in water or spray with liquids. Plug
the appliance directly into a 120V AC electrical outlet.
4. WARNING: To reduce the risk of fire or electrical
shock, DO NOT use this fan with any solid-state speed
control device.
5. Close supervision is necessary when any appliance is
used by or near children.
6. Unplug from outlet when not in use, when moving
fan from one location to another, before putting on
or taking off parts and before cleaning.
7. Avoid contact with moving parts.
8. DO NOT operate in the presence of explosives and/or
flammable fumes.
9. To avoid fire hazard, NEVER place the cord under
rugs or any parts near an open flame, cooking or
other heating appliance.
10. DO NOT operate any appliance with a damaged cord
or plug after the appliance malfunctions, or has been
dropped/damaged in any manner.
11. The use of attachments not recommended or sold by
the appliance manufacturer may cause hazards.
12. DO NOT use outdoors.
13. DO NOT let the cord hang over the edge of a table,
counter or come in contact with hot surfaces or leave
exposed to high traffic areas.
14. To disconnect, grip plug and pull from wall outlet.
Never yank on cord.
15. Always use on a dry, level surface.
16. DO NOT operate fan until fully assembled with all
parts properly in place.
17. This product is intended for household use only and
not for commercial or industrial applications.
PLEASE READ AND SAVE
THESE IMPORTANT SAFETY
INSTRUCTIONS
INSTALLATION INSTRUCTIONS
NOTE: MAKE SURE YOU REMOVE ALL CONTENTS OF THE
PACKAGE. PLEASE CHECK PACKAGING MATERIALS FOR
PARTS THAT COULD BE REQUIRED TO OPERATE YOUR FAN.
The window fan comes fully assembled and is ready for
immediate installation.
This window fan has been designed to fit double-hung
windows with minimum openings of 25 inches (63 cm)
wide and 10 inches (25 cm) high.
NOTE: THIS FAN IS DESIGNED AND RECOMMENDED FOR
USE WITH A SCREEN IN THE WINDOW.
Window Fan Installation
1. Align the Window Fan horizontally in the window
with the controls facing you and the Built-In Extender
Panel to the right.
2. Set the fan into your window opening (note that in
most cases the window screen does not have to be
removed or left open).
3. If the fan does not fit snugly to the left and right of
the window casing, pull out the Built-In Extender
CLEANING/MAINTENANCE
INSTRUCTIONS
This appliance has a polarized plug (one blade is wider than the other).
To reduce the risk of electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS
SAFETY FEATURE IN ANY WAY.
Intake
Intake
Exhaust
Exhaust
Off
High
Medium
Low
A. Left Fan Speed Control
B. Left Fan Exhaust Switch
C. Comfort Control Thermostat Knob
D. Right Fan Exhaust Switch
E. Right Fan Speed Control
F. Locking Tabs
G. Slider Safe®Extender Tab
H. Built-In Extender Panel
FIGURE 1
A
BC
H
FD
E
G
COMFORT CONTROL
If you have any questions regarding your product or
would like to learn more about other Holmes®
products, please contact our Consumer Service
Department at 1-800-546-5637 or visit our website at
www.holmesproducts.com.
Window Fan
Extender Panel
To order please go to
www.holmesproducts.com
or call 1-800-546-5637
HAWF2041_09EM1.qxd:HAWF2041_07EM1.qxd 12/19/08 3:59 PM Page 2