HOMCOM A90-259 Installation guide

ASSEMBLY & INSTRUCTION MANUAL
INaoa007_UK
READ AND SAVAE THIS INSTRUCTION FOR FUTURE USE
A90-259

EXPLOSIVE VIEW

SPARE PARTS LIST
No. Description Qty No. Description Qty
01 Main Frame 1 14
Inner Hexagon Bolt
M10*15mm
2
02 Upright 1 15 Dome Nut M10 2
03 Seat Support 1 16 Brake Knob 1
04 Front Stabilizer 1 17 Flat Washer M10 4
05 Rear Stablilizer 1 18 Flat Washer M8 3
06 Seat Slider 1 19 Spring Washer M8 1
07 Handlebar 1 20 Knob M8 1
08 Seat 1 21 Bushing 1
09L Left Crank 1 22 Pulse Sensor Wire 1
09R Right Crank 1 23 Upper Sensor Wire 1
10L Left Pedal 1 24 Monitor 1
10R Right Pedal 1 25 Lower Sensor Wire 1
11 Adjustable Knob 1 26 Adjustable Foot Pad 4
12
Inner Hexagon
Bolt M8*40mm
2 27 Handlebar Cover 1
13
Carriage Bolt
M10*45mm
2 28 Adjustable Knob 1

ASSEMBLY INSTRUCTION
Attach Front Stabilizer(04) to Main Frame(01), using two Inner Hexagon Bolts(12) and two
Flat Washer(18).
Attach Rear Stabilizer(05) to Main Frame(01),Using two Carriage Bolts(13),two Flat
Washers(17) and two Dome Nuts(15).
Step 1

Attach the Seat(08) to Seat Slider(06), then put it onto Seat Support(03), tighten with a Flat
Washer(18), Spring Washer(19) and Knob(20).
Insert this Seat Support assembly to Main Frame(01), secure by using one Adjustable
Knob(11).
Noted:The Adjustable Knob(11) is pre-assembled,when using it please follow below:
1:Turn knob counter-cloclwise three times.
2:Pull knob outward and adjust seat simultaneously.
3:Push the Knob back inward until it clicks and the tighten it by turning clockw
Step 2

Attach Handlebar(07) to Upright(02) using two Inner Hexagon Bolts(14) and two Flat
Washers(17),then put the Handlebar Cover(27) onto Handlebar(07) as showing.
Insert Upright assembly to Main Frame(01) secure by using Adjustable Knob(28).
Step 3

Attache the Monitor(24) to the bracket of Handlebar(07).Connect the Upper Sensor Wire(23) to
Pulse Sensor Wire(22) and Lower Sensor Wire(25) to the back of the Monitor(24).
Tighten the Left Pedal(10L) counter-clockwise onto the Left Crank(09L), and tighten the Right
Pedal(10R) clockwise onto the Right Crank(09R) .
Step 4