HoMedics LT-50 Instruction Manual

Instruction Manual and
Warranty Information LT-50
© 2004 HoMedics, Inc. and its affiliated companies, all rights reserved. HoMedics®is a
registered trademark of HoMedics, Inc. and its affiliated companies. Color Cube™ and
ColorMotion™ are trademarks of HoMedics Inc. and its affiliated companies.
All rights reserved.
IB-LT50
Mail To:
HoMedics
Service Center, Dept. 168
3000 Pontiac Trail
Commerce Township, MI
48390
e-mail:
[email protected]
ONE YEAR LIMITED WARRANTY
(Valid in USA only)
HoMedics, Inc., guarantees this product free from defects in
material and workmanship for a period of one year from the date of
original purchase, except as noted below.
This HoMedics product warranty does not cover damage caused
by misuse or abuse; accident; the attachment of any unauthorized
accessory; alteration to the product; or any other conditions
whatsoever that are beyond the control of HoMedics. This warranty
is effective only if the product is purchased and operated in the
USA. A product that requires modification or adaptation to enable it
to operate in any country other than the country for which it was
designed, manufactured, approved and/or authorized, or repair of
products damaged by these modifications is not covered under
warranty. HoMedics shall not be responsible for any type of
incidental, consequential or special damages. All implied
warranties, including but not limited to those implied warranties of
fitness and merchantability, are limited in the total duration of one
year from the original purchase date.
To obtain warranty service on your HoMedics product, either
hand deliver or mail the unit and your dated sales receipt (as proof
of purchase), postpaid, along with check or money order in the
amount of $5.00 payable to HoMedics, Inc. to cover handling.
Upon receipt, HoMedics will repair or replace, as appropriate, your
product and return it to you, postpaid. If it is appropriate to replace
your product, HoMedics will replace the product with the same
product or a comparable product at HoMedics’ option. Warranty is
solely through HoMedics Service Center. Service of this product by
anyone other than HoMedics Service Center voids warranty.
This warranty provides you with specific legal rights. You may have
additional rights which may vary from state to state. Because of
individual state regulations, some of the above limitations and
exclusions may not apply to you.
For more information regarding our product line in the USA,
please visit: www.homedics.com
ColorMotion™Nightlight
Color Cube™50
LT50_IB 10/20/04 1:14 PM Page 1

3
Experience the Magic of ColorMotion
Thank you for purchasing Color Cube 50. This product is built with high-
quality craftsmanship to provide you years of dependable service. We hope
that you will find it to be the finest product of its kind.
Create excitement anywhere. Inside this box lies the magic of the color cube.
It’s fun. It’s cool. And it’s created for your enjoyment. Use it at a party, chill with it,
study with it, boogie with it, sleep with it, decorate with it, meditate with it... use it
with your friends or by yourself. It’s in your hands from here... just enjoy it!
IMPORTANT SAFETY INSTRUCTIONS:
When using an electrical appliance, basic precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
WARNING - To reduce the risk of burns, fire, electric shock
or injury to persons:
• This product is not a toy.
• Not intended for use by children.
• For adult use only.
• Do not use with extension cords.
• For indoor use only.
• Use this appliance for its intended use as described in this manual.
• Never operate this appliance if it has a damaged plug or housing. If it is
not working properly, if it has been dropped or damaged, return it to
HoMedics Service Center for examination and repair.
• To disconnect, remove plug from outlet.
• Never cover the appliance when it is in operation.
• Plug only in exposed wall outlets where Nite Cube is well ventilated and
cannot contact bed coverings or other material that might present a fire
hazard.
• Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
The Color Cube Features
• Choose from:
8 hip color settings OR Continuously changing color program
• Nite sensor automatically turns the Color Cube on when room
darkens and off when room lightens
2
Caution: All
servicing of
this product
must be
performed by
authorized
HoMedics
Service
Personnel only.
• For use in standard outlet
• Can be used in daylight and darkness to enjoy the benefits
of color therapy
Instructions for Use
1. Set up the unit by first turning prongs and stabilizer out.
(Fig 1)
2. Plug the Color Cube 50 into a 120V household outlet.
This unit is equipped with a Nite Sensor, which automatically
turns on the unit when the room darkens and off when the
room lightens. There is an on/off switch located on the back
of the unit, which allows you to decide if you want to use this
function. (Fig 2)
3. To use in a well-lit room, first turn Nite Sensor to the off
position.
a. To use the color program, press the Program button.
(Fig 3) The program will run through a continuously
changing color program until the unit is turned off.
b. To use the solid glowing colors, press the Color
button. (Fig 3) Continue pressing to scroll through the
8 different colors. Stop on the color you desire and
the Color Cube will glow in this color until you turn it
off or select something different.
4. To use the Nite Sensor function, first slide Nite Sensor to
the On position. The unit will immediately turn on if the
room is dark. It will run with the last selected program or
solid glowing color. When room lightens, the unit will
automatically turn off.
- While in Nite Sensor mode, the user can still
manually turn off and on by pressing the
corresponding Off, Color or Program buttons.
Maintenance
To Store: You may leave the unit on display or you can store
in its box in a cool dry place.
To Clean: First remove from outlet. Wipe off dust with a damp
cloth. Never use liquids or abrasive cleaners to clean.
Figure 1
Figure 2
Figure 3
Prongs
Stabilizer
LT50_IB 10/20/04 1:14 PM Page 3