Homelegance Marrin 1444-5 User manual

PAGE 1 OF 1
MADE IN MALAYSIA
Thank you for purchasing this product. Please take time to read and follow the instructions below.
Check that you have all parts and hardware before assembly. Parts apparently missing are often
found in the packing materials. If you do not have all the parts listed, have your dealer contact us
and they will be sent to you immediately.
ASSEMBLY INSTRUCTION
STEP 1 STEP 2
PART LIST
B
A1
4
Dresser
Leg
No Sketch Description Quantity
C1
Support Leg
* ABOVE HARDWARE ARE PACKED IN 1444-5 FOR ASSEMBLY
A
A
B
1
2
B
B
B
LEGS
INSIDE
C
It is recommended to install protective pads under all legs and support to avoid damage or
scratches when placing furniture on a wood floor or other hard surface, and to limit
indentation and prevent discoloration if placing on carpet.
Hardware may loosen over time. Periodically check to make sure all connections are tight. Re-
tighten if necessary.
ITEM NO : 1444-5 DRESSER
X 4
11
Allen Key
No Size Description QuantitySketch
M4 x 60mm
212
Connection Bolt
-JCBC Bolt
-Spring Washer
-Flat Washer
HARDWARE LIST
M6-1.0 x 20mm
Ø1/4" x 7/32" x 7/16" x 0.06"
Ø1/4" x 1/4" x 3/4" x 0.04"

Thank you for purchasing this product. Please take time to read and follow the instructions below.
Check that you have all parts and hardware before assembly. Parts apparently missing are often
found in the packing materials. If you do not have all the parts listed, have your dealer contact us
and they will be sent to you immediately.
ASSEMBLY INSTRUCTION
PART LIST
A1
Dresser
No Sketch Description Quantity
HARDWARE LIST FOR ANTI - TIPPING KIT
11
Screw
No Description QuantitySketch
21
Screw
3Strap 1
4L Bracket 2
* ABOVE HARDWARE ARE PACKED IN 1444-5 FOR ASSEMBLY
It is recommended to install protective pads under all legs and support to avoid damage or
scratches when placing furniture on a wood floor or other hard surface, and to limit
indentation and prevent discoloration if placing on carpet.
Hardware may loosen over time. Periodically check to make sure all connections are tight. Re-
tighten if necessary.
STEP 1 STEP 2
WALL
STEP 3
A
1
4
24
4
4
3
A
A
MADE IN MALAYSIA PAGE 1 OF 1
Tipping Restraint hardware kit is included
with this product. Refer to installation
instruction in the hardware pack.
NOTE
* ANTI-TIPPING HARDWARE PACK IS AT THE BACK PANEL
ITEM NO : 1444-5 DRESSER
Size
M4 x 16mm
M4 x 50mm