Honeywell 18155 User manual

Owner’s Manual
For LifeTime HEPA™Permanent Filter
Model 18155 Air Purifier
The Science of Clean Air®
Portable True
HEPA Air Purifier
READ AND SAVE THESE INSTRUCTIONS
Install Pre-filter Before Initial Use.
18155 OM Eng.qxd 7/21/05 1:34 PM Page 1

When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock,
and injury to persons, including the following:
1. Read all instructions before operating the air purifier.
2. Place air purifier where it is not easily knocked over by persons in the household.
3. Always turn the air purifier to the OFF position and unplug from the wall outlet when
not in use.
4. To disconnect the air purifier, first turn control to the OFF position, grip the plug and
pull it from the wall outlet. Never pull by the cord.
5. Do not use any product with a damaged cord or plug or if product malfunctions, is
dropped or damaged in any manner. Keep the cord away from heated surfaces.
6. Do not use air purifier outdoors.
7. Never use air purifier unless it is fully assembled.
8. Do not run power cord under carpets, and do not cover with throw rugs. Arrange
cord such that it will not be tripped over.
9. Do not use air purifier where combustible gases or vapors are present.
10. Do not expose the air purifier to rain, or use near water, in a bathroom, laundry area
or other damp location.
11. The air purifier must be used in its upright position.
12. Do not allow foreign objects to enter ventilation or exhaust opening as this may
cause electric shock or damage to the air purifier. Do not block air outlets or
intakes.
13. Locate air purifier near the outlet and avoid using an extension cord.
14. This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. DO NOT attempt to defeat this safety feature.
15. A loose fit between the AC outlet (receptacle) and plug may cause overheating and
a distortion of the plug. Contact a qualified electrician to replace loose or worn
outlet.
16. Do not sit, stand or place heavy objects on the air purifier.
17. Disconnect power supply before servicing.
WARNING: To Reduce The Risk of Fire or Electric Shock, Do Not Use This Air
Purifier With Any Solid-State Speed Control Device.
IMPORTANT SAFETY
INSTRUCTIONS
READ AND SAVE THESE SAFETY
INSTRUCTIONS BEFORE USING
THIS AIR PURIFIER
2
18155 OM Eng.qxd 7/21/05 1:34 PM Page 2

Handle
Pre-filter
check/reset
monitor
HEPA Filter
check/reset
monitor
HEPA FILTER
HIGH
POWER
MED
PREFILTER
LOW
Top Cover
HEPA Filter
Body
Pre-filter Power Button
(OFF-HIGH-MED-LOW)
CONTROL PANEL
Base Ring
For Best Performance
True 99.97% HEPA Air Purifier with Germ Reduction
This air purifier model continually helps clean the air and helps reduce airborne bacteria,
germs and mold spores by drawing air through the HEPA filter which traps and collects
these particulates. In a test lab, the air purifiers were tested for reducing airborne
pathogens that passed through the filter, and results indicated a bacterial reduction up
to 100% with a mean reduction of 99.3%.
Germ Reduction
Construction
• Select a firm, level and flat location. For proper air flow, locate the unit at least 3 feet
(1 meter) from any wall or furniture.
• Due to the large volume of air drawn towards the air purifier, surrounding areas should
be cleaned and/or vacuumed frequently to prevent dust buildup. If the unit is placed
on light colored carpeting, a small mat or rug should be used to ease cleaning and
prevent any permanent staining of carpeting. This is particularly important in homes
with heavier contamination from smoking or fireplaces.
•Locate pre-filter in the box and install before initial operation. Refer to
“Removing/Changing the Filters” section for proper installation.
Set-up
3
We recommend that you operate your Honeywell air purifier 24 hours a day because
indoor air can be quickly contaminated by activity in a room, infiltration of outside air,
and from other sources of contamination. While all the air in a room will not be
processed by the air purifier, the more air circulated through the filter, the more filtered
air is returned to the room. Portable air purifiers will be much more effective in rooms
where all doors and windows are closed.
18155 OM Eng.qxd 7/21/05 1:34 PM Page 3

4
INSTALL PRE-FILTER BEFORE INITIAL OPERATION.
Refer to “Removing/Changing the Filters” section for proper
installation.
To encourage operation on higher speeds, the Honeywell
18155 air purifier has been designed to operate very quietly and
effectively without a cool exhaust draft. To operate, press the
POWER button to HIGH speed for a few seconds, and then
leave it on high for faster, more powerful air circulation, or move
it to a lower setting as desired.
The Intelli-Check™Filter Indicators serve as a convenient guideline for when to clean the
LifeTime HEPA™Permanent Filter and when to replace the carbon pre-filter. Depending
upon your individual usage (environment and hours used), you may need to clean/replace
the filters more or less frequently.
When the HEPA Filter Indicator Light turns on, it’s time to clean your HEPA filter. The
Intelli-Check™reminder for when to clean the HEPA filter is intended as a guideline only as
the performance of the filter media is dependent on the concentration of the contaminants
to which the system is exposed. If there are sources of large amounts of contaminant
generation (such as dust from woodworking or heavy smoking) the HEPA filter in your air
purifier may need to be cleaned more often. For instructions on how to clean your HEPA
filter, refer to section “Cleaning the LifeTime HEPA™Permanent Filter” in this manual.
When your Pre-filter Indicator Light turns on, it’s time to replace your pre-filter.It should
be replaced at least every 3 months. If there are heavy concentrations of odors, smoke, or
large particles in the home, you may need to change the carbon pre-filter more often. For
instructions on how to replace your pre-filter, refer to section “Removing/Changing the
Filters” in this manual.
Note: We do not recommend operating the air purifier without the carbon pre-filter.
To Reset Filter Indicator
•Once the filter has been checked and cleaned or replaced as
needed, the filter indicator will need to be reset.
• With the unit powered on, press and hold the appropriate filter
indicator button down for approximately 10 seconds until the
light turns off (Fig. 1)
Operation
Intelli-Check™Filter Indicators
Operation: Model 50150, 50200 and 50250 Series
Reset Filter Indicator/Turn Light Off
Fig. 1
18155 OM Eng.qxd 7/21/05 1:34 PM Page 4

5
INSTALL PRE-FILTER BEFORE INITIAL OPERATION.
The initial pre-filter is packaged separately to ensure its freshness. BEFORE initial
operation, locate the pre-filter in the box, remove it from its packaging and install per
instructions below.
• DISCONNECT from power supply before servicing.
• Replace filter(s) and re-assemble unit per instructions
below.
• Plug in and RESET appropriate filter monitor(s).
To Remove HEPA Filter for Cleaning:
• Unscrew handle counter-clockwise (Fig 2).
• Remove top cover.
• Remove the filter assembly (consisting of the HEPA filter
and pre-filter) from the internal chamber.
• Locate the seam of the pre-filter and carefully separate
the fastener to remove the pre-filter from the HEPA filter.
• Discard used pre-filter if necessary. Clean the HEPA filter
if necessary.
• Replace HEPA Filter (there is no top or bottom to filter).
• Replace top cover.
• Insert and tighten handle clockwise.
To Replace Pre-filter:
• Place unit on its side.
• Push in on both tabs on base ring to release base (Fig. 3).
• Gently remove base from motor assembly.
• Install initial pre-filter or replace used one. Wrap pre-filter around Base Ring and
attach with fastener provided.
• Align base into grooves and gently snap back into place.
Open Close
Handle Handle
HEPA
Filter
Pre-filter
installed on
Base Ring
Groove
Push
in on
both tabs
to release
Base Ring
HEPAFILTER
HIGH
POWER
MED
PREFILTER
LOW
Removing/Changing the Filters
Fig. 3
Fig. 2
18155 OM Eng.qxd 7/21/05 1:34 PM Page 5

6
The LifeTime HEPA™Filter is vacuum-able and should be cleaned regularly for optimum
performance.
To Clean the HEPA Filter:
•DO NOT USE WATER OR OTHER LIQUIDS TO CLEAN THE HEPA FILTER.
• Turn the air purifier OFF and unplug from the wall outlet.
• After removing the filter assembly from the air purifier (refer to section
“Removing/Changing the Filters” in this manual), separate and remove the carbon
pre-filter from the HEPA filter and place aside (or discard if pre-filter needs
replacement).
• To vacuum-clean the filter, hold the filter and run a vacuum cleaner with a nozzle or
brush attachment along the filter to pick-up the dirt and particles (Fig.4). Repeat along
the entire surface of the HEPA filter.
• Do not penetrate the HEPA paper pleats with the vacuum attachment since tearing or
puncturing can occur.
• Note that the filter may still be discolored even after
cleaning it. This is acceptable and will not affect
performance.
• After vacuuming the filter, wrap the pre-filter around
the HEPA filter and place the whole assembly back
into the internal chamber of the air purifier (see
“Removing/Changing the Filters”)
• You now need to reset the Intelli-Check™Filter
Indicator. With the air purifier powered on, press
and hold the appropriate filter indicator button for
approximately 10 seconds until the light turns off
(see Fig. 1).
If the HEPA filter clogs or if you have difficulty cleaning the filter, please visit us at
www.kaz.com or call us at 1-800-332-1110.
Fig 4
Cleaning the Lifetime HEPA™Permanent Filter*
*Permanent filter life based on ordinary use and care.
18155 OM Eng.qxd 7/21/05 1:34 PM Page 6

We recommend that you clean the air purifier at least once a month and before
extended storage. Use only a dry cloth to wipe external surfaces of the air purifier.
DO NOT USE WATER, WAX POLISH OR ANY CHEMICAL SOLUTION.
If you store your Honeywell HEPA air purifier for more than 30 days, we recommend:
• Removing both the primary HEPA filter and the activated carbon pre-filter from the
unit.
• Discarding the pre-filter.
• Wrapping the HEPA filter in an air-tight plastic bag or plastic wrap. Be sure that the
filter is totally sealed.
• To restore the air purifier to service, unwrap the HEPA filter, install a new activated
carbon pre-filter, and reinstall both filters in the air purifier. See “Removing/Changing
the Filters” section for proper installation.
To order replacement pre-filters, visit our website at: www.kaz.com
or call us at 1-800-332-1110.
Universal Carbon Pre-filter (38002): $14.99
Mail questions or comments to:
Kaz, Incorporated
Consumer Relations Dept.
250 Turnpike Road
Southborough, MA 01772
Call us toll-free at: 1-800-332-1110
E-mail: [email protected]
Or visit our website at: www.kaz.com
Please be sure to specify a model number.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER RELATIONS
FIRST OR SEE YOUR WARRANTY. DO NOT RETURN TO THE ORIGINAL PLACE OF
PURCHASE. DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF, DOING
SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE AIR PURIFIER OR
PERSONAL INJURY.
Cleaning and Storage
Accessories and Replacement Filters
Consumer Relations
7
Important – this air purifier has been designed to operate very quietly and
effectively without a cool exhaust draft, especially on lower speeds.
My Air Purifier is starting to make noise and the air output is less. What’s wrong?
The filters may be dirty. High amounts of contaminates can block the pores in the
filter and stop the air from moving through it. Clean the HEPA Filter.
How long should I run my Air Purifier?
For best results, you should operate your Air Purifier 24 hours a day. This unit will be
more effective when doors and windows are closed.
Can I wash the filters?
No. Washing the filters will destroy them.
Frequently Asked Questions
18155 OM Eng.qxd 7/21/05 1:34 PM Page 7

Storage
Five Year Limited Warranty
© 2005 Kaz, Incorporated. All Rights Reserved.
P/N: N.0120, Rev. 0
You should first read all instructions
before attempting to use this product.
A. This 5 year limited warranty applies to
repair or replacement of product found
to be defective in material or
workmanship. This warranty does not
apply to damage resulting from
commercial, abusive, unreasonable
use or supplemental damage. Defects
that are the result of normal wear and
tear will not be considered
manufacturing defects under this
warranty. KAZ IS NOT LIABLE FOR
INCIDENTAL OR CONSEQUENTIAL
DAMAGES OF ANY NATURE. ANY
IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE ON
THIS PRODUCT IS LIMITED IN
DURATION TO THE DURATION OF
THIS WARRANTY. Some jurisdictions
do not allow the exclusion or limitation
of incidental or consequential
damages or limitations on how long an
implied warranty lasts, so the above
limitations or exclusions may not apply
to you. This warranty gives you
specific legal rights, and you also may
have other rights which vary from
jurisdiction to jurisdiction. This
warranty applies only to the original
purchaser of this product from the
original date of purchase.
B. At its option, Kaz will repair or replace
this product if it is found to be
defective in material or workmanship.
Defective product should be returned
to the place of purchase in accordance
with store policy. Thereafter, while
within the warranty period defective
product may be returned to Kaz.
C. This warranty does not cover the
pre-filter or the HEPA filter except for
material or workmanship defects.
D. This warranty does not cover damage
resulting from any unauthorized
attempts to repair or from any use not
in accordance with the instruction
manual.
E. Return defective product to Kaz,
Incorporated with a brief description of
the problem. Include proof of purchase
and a $10 US/$15.50 CAN check or
money order for handling, return
packing and shipping charges. Please
include your name, address and a
daytime phone number. You must
prepay shipping charges. Send to:
In U.S.A.:
Kaz, Incorporated
Attn: Returns Department
4755 Southpoint Drive
Memphis, TN 38118
USA
In Canada:
Kaz, Incorporated
Attn: Returns Department
510 Bronte Street South
Milton, ON L9T 2X6
Canada
18155 OM Eng.qxd 7/21/05 1:34 PM Page 8