Honeywell INNCOM PC-503 User manual

The PC-503 LEDs indicate transmission (Tx)
and reception (Rx) with the computer.
Designed to work with the
INNTOOL/EngINN* room control
application, the PC-503 comes
with a USB A Male-to-USB Mini B
Male cable to provide power and
enable communication to a laptop
or personal computer in
the installation and
commissioning process.
INNCOM PC-503
COMMISSIONING
TOOL
Tx
Rx
PARAMETER PC503
PART NUMBER 201.503
RF DATA RATE 250kbps
ANTENNA TYPE SMT
INDOOR RANGE 70FT
TRANSMIT POWER 3mW (+5dBm)
RECEIVE SENSITIVITY -95dBm
FREQUENCY BAND 2.4GHz
ENCRYPTION AES128
PROTOCOL 802.15.4
FREQUENCY CHANNELS 1126
INPUT VOLTAGE 5VDC (USB)
OPERATING AMBIENT TEMPERATURE 0°C40 °C
LEDs FLASH TO SHOW TRANSMIT AND RECEIVE
RF FRAMES.
SPECIFICATIONS
*IMPORTANT NOTE PC-503 will not work with the INNCOM SNEEZER or any other INNCOM
legacy tool. PC-503 is an RF-only device and does not provide either S5 or IR5 interface.

01-00162 I 09/20
© 2020 Honeywell International Inc.
Honeywell Building Technologies
12 Clintonville Road
Northford, CT 06472
1-800-543-1999
www.inncom.com
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by INNCOM and Honeywell
International Inc. can void the user’s authority to operate this device.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada’s license-exempt RSSs. Operation is
subject to the following two conditions:
1) This device may not cause interference; and
2) This device must accept any interference, including interference that may cause
undesired operation of the device.
INNCOM PC-503
AGENCY STANDARD
CE EN 301 4891 V2.1.1/V2.2.0
EN 301 48917 V3.1.1/V3.2.0
EN55032:2012/AC:2013 CLASS B
EN 55024:2010
EN 6100032:2014
EN 6100033:2013
FCC FCC 47 CFR PART 15:2017, SECTIONS 15.107 AND 15.109 CLASS B
FCC 47 CFR PART 15.249:2017
IC
IC ICES003, ISSUE 6:2016, CLASS B
RSS210, ISSUE 9, 2016
RSSGEN, ISSUE 4, 2014
COMPLIANCE