Honeywell BRDG-02M11 User manual

Installation
BRDG-02M11
RF Repeater
Honeywell
1
Check the contents
1. Communication module.
2. Power adapter.
3. Manual.
Connecting for repeater functionality
LED Indication Function Action
LED OFF No message forwarded
LED OFF
Repeater has learned at least 1 device
LED ON Repeater is in normal mode
Restore the factory settings:Press the reset button for 10 seconds, the power LED start blinking, release the reset button.
The repeater reboots. All learned devices will be removed.
1. Connect the communication module using the USB cable to the power adapter.
2. Connect the power adapter to the 230V power outlet. LED , LED and LED are lit.
3. Power LED starts blinking (repeater is now in learning mode for 5 minutes).
LED blinking
shortly Repeater forwarded a message
LED ON
LED blinking
Repeater hasn't learned a device yet
Repeater learned a new device,
blinks for 60s, after 60s the LED will be ON
To stop the blinking press the reset button for ~1s,
the LED will now be ON. (see picture below)
LED blinking Repeater is in learning mode for 5 minutes
When the repeater is in normal mode you need to
power cycle the repeater to reenter learning mode
4. Bind the product that needs to be repeated to each other. This binding procedure is just as normal.
The Ramses repeater listens for binding messages. Once the Ramses repeater recognizes that a
product sends a binding message, this product is automatically added to an internal list of
repeated products. All messages from these products will be repeated from now on.
Notes:
A product is also added when it sends any message to a product that is already in the list. This is called “Auto learning”.
Wait 30 seconds before removing the power supply after a product is added to the list.
Changes in the list are saved periodically every 30 seconds.

2
Honeywell
EN2H-0100NL15 R0417
Specifications
Power USB adapter 230V AC to 5V DC
Max USB current 500mA
Environment Operating temperature: 0-50°C
Storage temperature: -25 tot 60°C
Humidity: 5-90% (Non-Condensing)
Dimensions 80 x 25 x 105 mm (W x H x D)
Unit weight 90 gram
Ports RJ45 ethernet connector (female)
Micro USB B connector (power)
Communication RF: 868.3MHz; Rx Class 2
Ethernet (10 / 100Mbit)
Complies with EMC directive: 2014/30/EU
LVD directive: 2014/35/EU
RED directive: 2014/53/EU
ROHS directive: 2011/65/EC
WEEE directive: 2012/19/EU
Waste electrical products should not be disposed of with general
waste.
Please recycle where these facilities exist.
Check with your local authority for recycling advice.
Hereby, HCCP, declares that this BRDG-02M11 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
Disposal and Recycling
Gabriël Metsulaan 4a
5611 SP Eindhoven
The Netherlands
Phone: [phone]
HCCP